Nonresonant micromachined gyroscopes with structural mode-decoupling

This paper reports a novel four-degrees-of-freedom (DOF) nonresonant micromachined gyroscope design concept that addresses two major MEMS gyroscope design challenges: eliminating the mode-matching requirement and minimizing instability and drift due to mechanical coupling between the drive and sense modes. The proposed approach is based on utilizing dynamical amplification both in the 2-DOF drive-direction oscillator and the 2-DOF sense-direction oscillator, which are structurally decoupled, to achieve large oscillation amplitudes without resonance. The overall 4-DOF dynamical system is composed of three proof masses, where second and third masses form the 2-DOF sense-direction oscillator, and the first mass and the combination of the second and third masses form the 2-DOF drive-direction oscillator. The frequency responses of the drive and sense direction oscillators have two resonant peaks and a flat region between the peaks. The device is nominally operated in the flat regions of the response curves belonging to the drive and sense direction oscillators, where the gain is less sensitive to frequency fluctuations. This is achieved by designing the drive and sense anti-resonance frequencies to match. Consequently, by utilizing dynamical amplification in the decoupled 2-DOF oscillators, increased bandwidth and reduced sensitivity to structural and thermal parameter fluctuations and damping changes are achieved, leading to improved robustness and long-term stability over the operating time of the device.

[1]  William C. Tang,et al.  Electrostatic Comb Drive for Resonant Sensor and Actuator Applications , 1990 .

[2]  Byung Man Kwak,et al.  Slide film damping in laterally driven microstructures , 1994 .

[3]  Wolfgang Kuehnel,et al.  Modelling of the mechanical behaviour of a differential capacitor acceleration sensor , 1995 .

[4]  Weichen Xue,et al.  Design and characteristics of two-gimbals micro-gyroscopes fabricated with quasi-LIGA process , 1997, Proceedings of International Solid State Sensors and Actuators Conference (Transducers '97).

[5]  Bernhard E. Boser.  Electronics for micromachined inertial sensors , 1997, Proceedings of International Solid State Sensors and Actuators Conference (Transducers '97).

[6]  A. Hoogerwerf,et al.  Analytical modeling of squeeze film damping in accelerometers , 1997, Proceedings of International Solid State Sensors and Actuators Conference (Transducers '97).

[7]  Sukhan Lee,et al.  Micromachined inertial sensors , 1999, Proceedings 1999 IEEE/RSJ International Conference on Intelligent Robots and Systems. Human and Environment Friendly Robots with High Intelligence and Emotional Quotients (Cat. No.99CH36289).

[8]  A. Shkel.  Modeling and simulation of micromachined gyroscopes in the presence of imperfections , 1999 .

[9]  James J. Allen,et al.  Parallel-plate electrostatic dual-mass resonator , 1999, Photonics West - Micro and Nano Fabricated Electromechanical and Optical Components.

[10]  Roberto Horowitz,et al.  Dynamics and control of micromachined gyroscopes , 1999, Proceedings of the 1999 American Control Conference (Cat. No. 99CH36251).

[11]  James J. Allen,et al.  Parallel-Plate Electrostatic Dual Mass Oscillator , 1999 .

[12]  Y. Mochida,et al.  A micromachined vibrating rate gyroscope with independent beams for the drive and detection modes , 2000, Technical Digest. IEEE International MEMS 99 Conference. Twelfth IEEE International Conference on Micro Electro Mechanical Systems (Cat. No.99CH36291).

[13]  Jong-Hyun Lee,et al.  A laterally driven symmetric micro-resonator for gyroscopic applications , 2000 .

[14]  Y. Mochida,et al.  A micromachined vibrating rate gyroscope with independent beams for the drive and detection modes , 2000 .

[15]  Andrei M. Shkel,et al.  FOUR DEGREES-OF-FREEDOM MICROMACHINED GYROSCOPES , 2001 .

[16]  J. Frech,et al.  Decoupled microgyros and the design principle DAVED , 2001, Technical Digest. MEMS 2001. 14th IEEE International Conference on Micro Electro Mechanical Systems (Cat. No.01CH37090).

[17]  T. Veijola,et al.  Compact damping models for laterally moving microstructures with gas-rarefaction effects , 2001 .

[18]  G. Schmidt,et al.  Inertial sensor technology trends , 2001 .

[19]  Robert P. Leland.  Adaptive tuning for vibrational gyroscopes , 2001, Proceedings of the 40th IEEE Conference on Decision and Control (Cat. No.01CH37228).

[20]  R. Horowitz,et al.  Adaptive control for z-axis MEMS gyroscopes , 2001, Proceedings of the 2001 American Control Conference. (Cat. No.01CH37148).

[21]  Said Emre Alper,et al.  A symmetric surface micromachined gyroscope with decoupled oscillation modes , 2002 .

[22]  Yong-Kweon Kim,et al.  A few deg/hr resolvable low noise lateral microgyroscope , 2002, Technical Digest. MEMS 2002 IEEE International Conference. Fifteenth IEEE International Conference on Micro Electro Mechanical Systems (Cat. No.02CH37266).

[23]  Robert Patton Leland.  Adaptive mode tuning for vibrational gyroscopes , 2003, IEEE Trans. Control. Syst. Technol..