Investigation of gas–solids flow characteristics in a circulating fluidized bed with annular combustion chamber by pressure measurements and CPFD simulation

Abstract For large scale circulating fluidized bed (CFB) boilers, a new type of annular combustion chamber was proposed to improve the secondary air penetration and provide adequate space to arrange the heat transfer surface. To investigate the gas–solids flow characteristics and optimize the structure of the annular combustion chamber, a “cold” test rig was built with a cross sectional area of 1.18 m 2 and a height of 8.0 m. High frequency pressure transducers were used to obtain the pressure fluctuations characteristics. CFD simulation based on computational particle fluid dynamic (CPFD) was used to obtain pressure fluctuations and particles concentration. The time domain analysis, power spectrum analysis and Hilbert–Huang transform were applied to the experimental and simulation data. Different flow regimes including single bubble regime, exploding bubble regime and turbulent fluidization regime were identified. The flow characteristics were investigated in terms of standard deviation and higher-order moments, auto-correlation, power spectrum, and EMD energy entropy. The results show that the gas–solids flow in the bottom region of the annular combustion chamber was relatively uniform. The gas–solids flow in annular combustion chamber was proved similar to that in a conventional CFB riser.

[1]  Guizhi Qiu,et al.  Measurement of gas-solids flow in loop seal and external heat exchanger in a circulating fluidized bed , 2014 .

[2]  A. Carroll,et al.  Particle size monitoring in a fluidized bed using pressure fluctuations , 2008 .

[3]  D. Geldart.  Types of gas fluidization , 1973 .

[4]  D. Snider.  An incompressible three-dimensional multiphase particle-in-cell model for dense particle flows , 2001 .

[5]  Frédéric Depypere,et al.  CFD analysis of air distribution in fluidised bed equipment , 2004 .

[6]  Tom Dyakowski,et al.  Study of bubbling and slugging fluidized beds by simulation and ECT , 2006 .

[7]  Filip Johnsson,et al.  Bottom bed regimes in a circulating fluidized bed boiler , 1996 .

[8]  John R. Grace,et al.  Distribution of multi-phase gas–solid flow across identical parallel cyclones: Modeling and experimental study , 2010 .

[9]  Atsushi Tsutsumi,et al.  Nonlinear dynamics of gas-solid circulating fluidized-bed system , 2000 .

[10]  P. J. O'rourke,et al.  The multiphase particle-in-cell (MP-PIC) method for dense particulate flows , 1996 .

[11]  Filip Johnsson,et al.  Fluidization regimes in non-slugging fluidized beds: the influence of pressure drop across the air distributor , 1996 .

[12]  Shuo Ma,et al.  Hilbert-Huang transform analysis of dynamic and earthquake motion recordings , 2003 .

[13]  Filip Johnsson,et al.  Time-series analysis of pressure fluctuations in gas–solid fluidized beds – A review , 2011 .

[14]  N. Huang,et al.  The empirical mode decomposition and the Hilbert spectrum for nonlinear and non-stationary time series analysis , 1998, Proceedings of the Royal Society of London. Series A: Mathematical, Physical and Engineering Sciences.

[15]  Xiaofeng Lu,et al.  Gas–solid flow in an integrated external heat exchanger for CFB boiler , 2010 .

[16]  Jiamin Ye,et al.  Investigation of flow hydrodynamics and regime transition in a gas-solids fluidized bed with different riser diameters , 2014 .

[17]  Bed-inventory Overturn Mechanism for Pant-leg Circulating Fluidized Bed Boilers , 2011, 1101.3661.

[18]  L. Mörl,et al.  Characterization of spouted bed regimes using pressure fluctuation signals , 2008 .

[19]  Filip Johnsson,et al.  Characterization of fluidization regimes by time-series analysis of pressure fluctuations , 2000 .

[20]  Leon R. Glicksman,et al.  Experimental verification of scaling relationships for fluidized bed , 1984 .

[21]  Guizhi Qiu,et al.  Modelling and experimental investigation of the full-loop gas-solid flow in a circulating fluidized bed with six cyclone separators , 2014 .

[22]  P. Foscolo,et al.  Generalized friction factor and drag coefficient correlations for fluid-particle interactions , 1985 .

[23]  Filip Johnsson,et al.  Non-intrusive determination of bubble and slug length scales in fluidized beds by decomposition of the power spectral density of pressure time series , 2002 .

[24]  Rui Xiao,et al.  Flow regime identification in a three-phase bubble column based on statistical, Hurst, Hilbert–Huang transform and Shannon entropy analysis , 2013 .

[25]  Javier Villa Briongos,et al.  Phase space structure and multi-resolution analysis of gas–solid fluidized bed hydrodynamics: Part I — The EMD approach , 2006 .

[26]  Yassir Makkawi,et al.  Fluidization regimes in a conventional fluidized bed characterized by means of electrical capacitance tomography , 2002 .

[27]  D. Che,et al.  Structure and Performance of a 600MWe Supercritical CFB Boiler with Water Cooled Panels , 2009 .

[28]  Lawrence J. Shadle,et al.  Identification and characteristics of different flow regimes in a circulating fluidized bed , 2005 .

[29]  Qinhui Wang,et al.  Non-uniform distribution of gas-solid flow through six parallel cyclones in a CFB system： An experimental study , 2012 .