The first light of Taiwan's photon source was produced on December 2013. TPS has been in operation for 6 years and mean time between fail (MTBF) has reached world class standards. The NSRRC upgrade of a storage ring and booster ring requires fast bipolar power supplies for the fast correction magnets. For the fast correction magnets are requirement of the correction power supplies must had a high bandwidth of 10kHz for the output current. A prototype DC/DC corrector power supply using a MOSFET full bridge circuit with a 200kHz PWM control signal and achieved up of 10kHz bandwidth with less than 3-dB attenuation for a small refer signal of the maximum operation current of 10 amperes. Finally, the prototype achieved an 11 kHz bandwidth with less than 3 dB attenuation for a refer signal 0.1V (equal to 0.lA). This paper also presents the designs of the power circuit, control circuit, MOSFET driver circuit, auxiliary & regulator power circuit, protection circuit, and component layout. The experimental results, the effectiveness of the control loop design can be verified from the gain margin and phase margin.
[1]
Jiann-Fuh Chen,et al.
A novel high step-up DC-DC converter with coupled inductor and switched clamp capacitor techniques for photovoltaic systems
,
2017
.
[2]
A. Holland,et al.
Development of EM-CCD-based X-ray detector for synchrotron applications
,
2014
.
[3]
Roberto Visintini,et al.
A New Concept of Controller for Accelerators’ Magnet Power Supplies
,
2016,
IEEE Transactions on Nuclear Science.
[4]
Tsuyoshi Murata,et al.
{m
,
1934,
ACML.
[5]
S. Marks,et al.
Design of a Cryogenic Calorimeter for Synchrotron Light Source Beam-Based Heating
,
2009,
IEEE Transactions on Applied Superconductivity.
[7]
C.-Y. Liu,et al.
Compensator design for corrector magnet power supply of TPS facility
,
2017
.
[8]
T. Ise,et al.
Application of Energy Storage System for Stabilization of Accelerator Magnet Power Supply
,
2010,
IEEE Transactions on Applied Superconductivity.