Elimination of solidification shrinkage defects in the casting of aluminum alloy

[1]  J. Kronsteiner,et al.  Dynamic Simulations of Manufacturing Processes: Hybrid-Evolving Technique , 2021, Metals.

[2]  T. Haga,et al.  Fluidity Investigation of Pure Al and Al-Si Alloys , 2021, Materials.

[3]  Honggen Zhou,et al.  Research on the dynamic evolution of residual stress in thermal processing of diesel engine blocks based on FEM , 2021, Journal of Mechanical Science and Technology.

[4]  Baode Sun,et al.  Comparison of various gating systems for investment casting of hydraulic retarder impeller with complex geometry , 2020 .

[5]  A. Usman,et al.  Effect of variation of different additives on some selected properties of silica sand mould for aluminium castings , 2020 .

[6]  A. Sheikh,et al.  Mold design optimization and quality assessment of steel castings through integrated simulations and experiments , 2020 .

[7]  Kui Liu,et al.  Effect of cooling rate on microstructure, microsegregation and mechanical properties of cast Ni-based superalloy K417G , 2017 .

[8]  Suyitno,et al.  Prediction of Shrinkage Porosity in Femoral Stem of Titanium Investment Casting , 2016 .

[9]  Ike Sowden,et al.  Improving Casting Integrity Through the Use of Simulation Software and Advanced Inspection Methods , 2012 .

[10]  Anwar K. Sheikh,et al.  Mold Design Optimization for Sand Casting of Complex Geometries Using Advance Simulation Tools , 2012 .

[11]  Xin Lin,et al.  Numerical simulation and defect elimination in the casting of truck rear axle using a nodular cast iron , 2011 .

[12]  Ruhollah Tavakoli,et al.  On the prediction of shrinkage defects by thermal criterion functions , 2010, 1005.2706.

[13]  Suyitno,et al.  Contraction of aluminum alloys during and after solidification , 2004 .

[14]  E. Maire,et al.  Solidification Study of Aluminum Alloys Using Impulse Atomization: Part ii. Effect of Cooling Rate on Microstructure , 2002 .

[15]  K. O. Yu,et al.  Finite-element thermal modeling of casting microstructures and defects , 1992 .

[16]  José E. Spinelli,et al.  Design of mechanical properties of Al-alloys chill castings based on the metal/mold interfacial heat transfer coefficient , 2012 .

[17]  D. Kadhim.  EFFECT OF COOLING RATE ON MECHANICAL PROPERTIES OF EUTECTIC AND HYPOEUTECTIC Al-Si ALLOYS , 2011 .

[18]  Christoph Beckermann,et al.  Prediction of Shrinkage Pore Volume Fraction Using a Dimensionless Niyama Criterion , 2009 .

[19]  William C. Mack,et al.  Worldwide guide to equivalent nonferrous metals and alloys , 1996 .