A model for cutting forces generated during machining with self-propelled rotary tools

In this paper, a force model for self-propelled rotary tool is presented. Conventional oblique cutting force predictions were reviewed and extended to predict the cutting forces generated during machining with the self-propelled rotary tools. The model presented is based on Oxley's analysis and was verified by cutting tests using a typical self-propelled tool. Good agreement was obtained between the predicted and the experimentally measured forces under a wide range of cutting conditions. The effect of different cutting conditions on the friction coefficient along the chip/tool interface and tool rake face normal force were also presented and discussed.

[1]  Hossam A. Kishawy,et al.  Prediction of chip flow direction during machining with self-propelled rotary tools , 2006 .

[2]  Hossam A. Kishawy,et al.  Tool performance and attainable surface quality during the machining of aerospace alloys using self-propelled rotary tools , 2004 .

[3]  W. F. Hastings,et al.  A machining theory for predicting chip geometry, cutting forces etc. from work material properties and cutting conditions , 1980, Proceedings of the Royal Society of London. A. Mathematical and Physical Sciences.

[4]  P.L.B. Oxley,et al.  Calculating the shear angle in orthogonal metal cutting from fundamental stress-strain-strain rate properties of the work material , 1964 .

[5]  P.L.B. Oxley,et al.  Allowing for Nose Radius Effects in Predicting the Chip Flow Direction and Cutting Forces in Bar Turning , 1987 .

[6]  E.J.A. Armarego,et al.  Predictive Cutting Model for Forces and Power in Self-Propelled Rotary Tool Turning Operations , 1997 .

[7]  Hossam A. Kishawy,et al.  Tool wear and chip formation during hard turning with self-propelled rotary tools , 2003 .

[8]  Shuting Lei,et al.  High-speed machining of titanium alloys using the driven rotary tool , 2002 .

[9]  P Mathew,et al.  Predicting Cutting Forces for Oblique Machining Conditions , 1982 .

[10]  Tetsutaro Hoshi,et al.  High-Performance Machining of SiC Whisker-Reinforced Aluminium Composite by Self-Propelled Rotary Tools , 1992 .

[11]  Jun Wang,et al.  Development of a Chip Flow Model for Turning Operations , 2001 .

[12]  M. C. Shaw,et al.  Mechanics of Machining: An Analytical Approach to Assessing Machinability , 1989 .

[13]  M. C. Shaw.  Metal Cutting Principles , 1960 .

[14]  E.J.A. Armarego,et al.  Computer-Aided Predictive Models for Fundamental Rotary Tool Cutting Processes , 1993 .

[15]  E. Armarego,et al.  The Machining of Metals , 1969 .