Improved power conversion efficiency of bulk heterojunction poly(3-hexylthiophene):PCBM photovoltaic devices using small molecule additive

Abstract We report that the power conversion efficiency (PCE) of the bulk heterojunction organic photovoltaic device based on poly(3-hexylthiophene):[6,6]-phenyl–C61–butyric acid methyl ester (P3HT:PCBM) blend was improved by incorporating a small molecule SM having absorption band in the longer wavelength region. SM is a small molecule containing thienothiadiazole central unit with terminal cyanovinylene 4-nitrophenyl at both sides, which were connected to the central unit via a thiophene ring. The combination of SM with P3HT and PCBM allows not only a broad band absorption up to longer wavelength, but also tuning the inter-energy level leading to a higher short circuit current (Jsc) and open circuit voltage (Voc). The device based on the as cast P3HT:PCBM:SM exhibits a PCE of 3.69%, which is higher than the device based on P3HT:PCBM and SM:PCBM blends. The overall PCE of the device based on thermally annealed blend is further improved up to 4.1%. The improvement of the PCE has been attributed to a better charge transport in the device, due to the increased crystallinity of the blend through thermal annealing.

[1]  Mario Leclerc,et al.  A Low‐Bandgap Poly(2,7‐Carbazole) Derivative for Use in High‐Performance Solar Cells , 2007 .

[2]  Christoph J. Brabec,et al.  Design Rules for Donors in Bulk‐Heterojunction Solar Cells—Towards 10 % Energy‐Conversion Efficiency , 2006 .

[3]  Gang Li,et al.  Fast-Grown Interpenetrating Network in Poly(3-hexylthiophene): Methanofullerenes Solar Cells Processed with Additive , 2009 .

[4]  Yong Cao,et al.  Polymer solar cells: Recent development and possible routes for improvement in the performance , 2010 .

[5]  A. Heeger,et al.  The Role of Processing in the Fabrication and Optimization of Plastic Solar Cells , 2009 .

[6]  Thuc-Quyen Nguyen,et al.  Nanoscale Phase Separation and High Photovoltaic Efficiency in Solution‐Processed, Small‐Molecule Bulk Heterojunction Solar Cells , 2009 .

[7]  J. Brédas,et al.  Molecular understanding of organic solar cells: the challenges. , 2009, Accounts of chemical research.

[8]  N. E. Coates,et al.  Efficient Tandem Polymer Solar Cells Fabricated by All-Solution Processing , 2007, Science.

[9]  Yang Yang,et al.  Polymer solar cells with enhanced open-circuit voltage and efficiency , 2009 .

[10]  Thuc‐Quyen Nguyen,et al.  Small molecule sensitizers for near-infrared absorption in polymer bulk heterojunction solar cells , 2008 .

[11]  Zaifang Li,et al.  Solution processable D–A small molecules for bulk-heterojunction solar cells , 2010 .

[12]  Valentin D. Mihailetchi,et al.  Ultimate efficiency of polymer/fullerene bulk heterojunction solar cells , 2006 .

[13]  Takahiro Nogami,et al.  Improvement of the light-harvesting efficiency in polymer/fullerene bulk heterojunction solar cells by interfacial dye modification. , 2009, ACS applied materials & interfaces.

[14]  Pierre-Antoine Bouit,et al.  Organic photovoltaics: a chemical approach. , 2010, Chemical communications.

[15]  Yang Yang,et al.  Synthesis, characterization, and photovoltaic properties of a low band gap polymer based on silole-containing polythiophenes and 2,1,3-benzothiadiazole. , 2008, Journal of the American Chemical Society.

[16]  Yongfang Li,et al.  6.5% Efficiency of Polymer Solar Cells Based on poly(3‐hexylthiophene) and Indene‐C60 Bisadduct by Device Optimization , 2010, Advanced materials.

[17]  Valentin D. Mihailetchi,et al.  Charge Transport and Photocurrent Generation in Poly(3‐hexylthiophene): Methanofullerene Bulk‐Heterojunction Solar Cells , 2006 .

[18]  Luping Yu,et al.  Development of new semiconducting polymers for high performance solar cells. , 2009, Journal of the American Chemical Society.

[19]  Yang Yang,et al.  Manipulating regioregular poly(3-hexylthiophene) : [6,6]-phenyl-C61-butyric acid methyl ester blends—route towards high efficiency polymer solar cells , 2007 .

[20]  Thuc‐Quyen Nguyen,et al.  A low band gap, solution processable oligothiophene with a dialkylated diketopyrrolopyrrole chromophore for use in bulk heterojunction solar cells , 2009 .

[21]  Vladimir Dyakonov,et al.  Polymer–fullerene bulk heterojunction solar cells , 2010, 1003.0359.

[22]  E. Gomez,et al.  Altering the Thermodynamics of Phase Separation in Inverted Bulk‐Heterojunction Organic Solar Cells , 2009 .

[23]  Jean M. J. Fréchet,et al.  Increased light harvesting in dye-sensitized solar cells with energy relay dyes , 2009 .

[24]  Chen Li,et al.  Polyphenylene-based materials for organic photovoltaics. , 2010, Chemical reviews.

[25]  Thuc‐Quyen Nguyen,et al.  A Low Band Gap, Solution Processable Oligothiophene with a Diketopyrrolopyrrole Core for Use in Organic Solar Cells , 2008 .

[26]  N. S. Sariciftci,et al.  Conjugated polymer-based organic solar cells. , 2007, Chemical reviews.

[27]  H. Ohkita,et al.  Improvement of charge injection efficiency in organic-inorganic hybrid solar cells by chemical modification of metal oxides with organic molecules , 2007 .

[28]  Roar R. Søndergaard,et al.  Advanced materials and processes for polymer solar cell devices , 2010 .

[29]  G. Sharma,et al.  Low band gap conjugated small molecules containing benzobisthiadiazole and thienothiadiazole central units: synthesis and application for bulk heterojunction solar cells , 2011 .

[30]  Shijun Jia,et al.  Polymer–Fullerene Bulk‐Heterojunction Solar Cells , 2009, Advanced materials.

[31]  Thuc‐Quyen Nguyen,et al.  Influence of alkyl substituents and thermal annealing on the film morphology and performance of solution processed, diketopyrrolopyrrole-based bulk heterojunction solar cells , 2009 .

[32]  J. Fréchet,et al.  Polymer-fullerene composite solar cells. , 2008, Angewandte Chemie.

[33]  P. Heremans,et al.  Strategies for increasing the efficiency of heterojunction organic solar cells: material selection and device architecture. , 2009, Accounts of chemical research.

[34]  John E. Anthony,et al.  Photovoltaics from soluble small molecules , 2007 .

[35]  M. Stylianakis,et al.  Efficient bulk heterojunction devices based on phenylenevinylene small molecule and perylene–pyrene bisimide , 2010 .

[36]  Mm Martijn Wienk,et al.  Narrow‐Bandgap Diketo‐Pyrrolo‐Pyrrole Polymer Solar Cells: The Effect of Processing on the Performance , 2008 .

[37]  Yongfang Li,et al.  Conjugated Polymer Photovoltaic Materials with Broad Absorption Band and High Charge Carrier Mobility , 2008 .

[38]  Christoph J. Brabec,et al.  Two Novel Cyclopentadithiophene-Based Alternating Copolymers as Potential Donor Components for High-Efficiency Bulk-Heterojunction-Type Solar Cells , 2008 .

[39]  Yongfang Li,et al.  High‐Yield Synthesis and Electrochemical and Photovoltaic Properties of Indene‐C70 Bisadduct , 2010 .

[40]  Daoben Zhu,et al.  Novel electroactive and photoactive molecular materials based on conjugated donor-acceptor structures for optoelectronic device applications. , 2005, The journal of physical chemistry. B.

[41]  J. Ding,et al.  Development of a new s-tetrazine-based copolymer for efficient solar cells. , 2010, Journal of the American Chemical Society.

[42]  M. Summers,et al.  Using Resonance Energy Transfer to Improve Exciton Harvesting in Organic–Inorganic Hybrid Photovoltaic Cells , 2005 .

[43]  Jin Young Kim,et al.  Processing additives for improved efficiency from bulk heterojunction solar cells. , 2008, Journal of the American Chemical Society.

[44]  Gang Li,et al.  Effects of Solvent Mixtures on the Nanoscale Phase Separation in Polymer Solar Cells , 2008 .

[45]  Chain‐Shu Hsu,et al.  Synthesis of conjugated polymers for organic solar cell applications. , 2009, Chemical reviews.

[46]  Xiong Gong,et al.  Thermally Stable, Efficient Polymer Solar Cells with Nanoscale Control of the Interpenetrating Network Morphology , 2005 .

[47]  Yongfang Li,et al.  Solution-Processable Star-Shaped Photovoltaic Organic Molecule with Triphenylamine Core and Benzothiadiazole−Thiophene Arms , 2009 .

[48]  P. Suresh,et al.  Effect of the incorporation of a low-band-gap small molecule in a conjugated vinylene copolymer: PCBM blend for organic photovoltaic devices. , 2009, ACS applied materials & interfaces.

[49]  Frederik C. Krebs,et al.  Business, market and intellectual property analysis of polymer solar cells , 2010 .

[50]  Nelson E. Coates,et al.  Bulk heterojunction solar cells with internal quantum efficiency approaching 100 , 2009 .

[51]  Jan Genoe,et al.  Solar cells utilizing small molecular weight organic semiconductors , 2007 .

[52]  Niyazi Serdar Sariciftci,et al.  Organic solar cells: An overview , 2004 .

[53]  G. Sharma,et al.  A Simple and Effective Modification of PCBM for Use as an Electron Acceptor in Efficient Bulk Heterojunction Solar Cells , 2011 .

[54]  A J Heeger,et al.  Efficiency enhancement in low-bandgap polymer solar cells by processing with alkane dithiols. , 2007, Nature materials.

[55]  Christoph J. Brabec,et al.  Interface materials for organic solar cells , 2010 .

[56]  R. Liu,et al.  Tailoring Nanowire Network Morphology and Charge Carrier Mobility of Poly(3-hexylthiophene)/C60 Films , 2009 .

[57]  A. Arias,et al.  Materials and applications for large area electronics: solution-based approaches. , 2010, Chemical reviews.

[58]  X. Gu,et al.  Efficient Bulk-Heterojunction Solar Cells Based on a Symmetrical D-π-A-π-D Organic Dye Molecule , 2009 .

[59]  Yang Yang,et al.  High-efficiency solution processable polymer photovoltaic cells by self-organization of polymer blends , 2005 .

[60]  H. Ade,et al.  Improved efficiency of bulk heterojunction poly(3-hexylthiophene):[6,6]-phenyl-C61-butyric acid methyl ester photovoltaic devices using discotic liquid crystal additives , 2010 .

[61]  F. Krebs,et al.  Low Band Gap Polymers for Roll-to-Roll Coated Polymer Solar Cells , 2010 .

[62]  C. Brabec,et al.  Plastic Solar Cells , 2001 .

[63]  Gang Li,et al.  For the Bright Future—Bulk Heterojunction Polymer Solar Cells with Power Conversion Efficiency of 7.4% , 2010, Advanced materials.

[64]  Ashok Kumar,et al.  Efficient bulk heterojunction solar cells based on low band gap bisazo dyes containing anthracene and/or pyrrole units , 2010 .

[65]  Daniel Moses,et al.  Method for increasing the photoconductive response in conjugated polymer/fullerene composites , 2006 .