Performance prediction for a parallel flow condenser based on artificial neural network

Abstract This paper reports the use of artificial neural network (ANN) to predict the thermal performance of a parallel flow (PF) condenser with R134a as working fluid. The ANN predictions were compared with the distributed parameter model (DPM) calculation data, which had been validated by experiments at steady-state conditions while varying the air inlet temperature and velocity, refrigerant inlet temperature, pressure and mass flow rate. Based on the data deduced from DPM, ANN was built to predict heat exchange capacity, outlet refrigerant temperature and pressure drop for both air side and refrigerant side. The ANN was optimized for 6-9-5 configuration with Lavenberg–Marquardt (L–M) algorithm, which showed good performance with the root mean square error (RMSE) in the range of 0.00149–0.00605, correlation coefficient (R2) in the range of 0.99989–0.99999 and mean relative error (MRE) in the range of 0.24143–1.31947%.

[1]  Kai-Shing Yang,et al.  Characteristics of flow distribution in compact parallel flow heat exchangers, part I: Typical inlet header , 2011 .

[2]  J. Yoo,et al.  Performance analysis and simulation of automobile air conditioning system , 2000 .

[3]  A. Shooshtari,et al.  Performance characterization of R134a and R245fa in a high aspect ratio microchannel condenser , 2013 .

[4]  R. Payne,et al.  Artificial neural network modelling of the thermal performance of a compact heat exchanger , 2009 .

[5]  Tsing-Fa Lin,et al.  Condensation heat transfer and pressure drop of refrigerant R-134a in a plate heat exchanger , 1999 .

[6]  Jong-Phil Won,et al.  Performance characteristics of mobile heat pump for a large passenger electric vehicle , 2013 .

[7]  Pascal Lavieille,et al.  Heat transfer analysis according to condensation flow structures in a minichannel , 2006 .

[8]  Rodney L. McClain,et al.  Neural network analysis of fin-tube refrigerating heat exchanger with limited experimental data , 2001 .

[9]  Steven J. Eckels,et al.  Dimensional analysis on the evaporation and condensation of refrigerant R-134a in minichannel plate heat exchangers , 2006 .

[10]  R. Webb,et al.  Condensation of R-12 in small hydraulic diameter extruded aluminum tubes with and without micro-fins , 1996 .

[11]  Qiuwang Wang,et al.  Heat transfer analysis for shell-and-tube heat exchangers with experimental data by artificial neural networks approach , 2007 .

[12]  Songping Mo,et al.  Experimental verification of a condenser with liquid–vapor separation in an air conditioning system , 2013 .

[13]  Z. Weng,et al.  CO2 condensation heat transfer coefficient and pressure drop in a mini-channel space condenser , 2013 .

[14]  H. Hegab,et al.  Experimental investigation of thermal model of parallel flow microchannel heat exchangers subjected to external heat flux , 2012 .

[15]  Indrajit Mukherjee,et al.  Comparing the performance of neural networks developed by using Levenberg-Marquardt and Quasi-Newton with the gradient descent algorithm for modelling a multiple response grinding process , 2012, Expert Syst. Appl..

[16]  Predrag Stojan Hrnjak,et al.  Microchannel heat exchangers for charge minimization in air-cooled ammonia condensers and chillers , 2008 .

[17]  Chi-Chuan Wang,et al.  A generalized heat transfer correlation for Iouver fin geometry , 1997 .

[18]  Srinivas Garimella,et al.  Characterization of two-phase flow patterns in small diameter round and rectangular tubes , 1999 .

[19]  Tim Ameel,et al.  A minichannel aluminium tube heat exchanger - Part III: Condenser performance with propane , 2008 .

[20]  Murat Hosoz,et al.  Artificial neural network analysis of a refrigeration system with an evaporative condenser , 2006 .