Analytical Study of the Effects of the Clogging of a Mechanical Precipitator Unit in Air Preheaters in a High-Performance Thermoelectric Power Plant Based on Available Data

Following a detailed study of two of the mechanical precipitators in the air preheaters of a thermoelectric power plant, a large amount of ash that was deposited on one of the inlet conduits was observed, obstructing the incoming gas flow. A comparison of the available data for the two most recent hopper cleaning operations revealed that, on the one hand, the amount of ash collected by the clogged precipitator (A) was significantly less than that collected by the other (B) and, on the other hand, the temperature of the ash in the former was noticeably lower than in the latter. Prior to the cleaning of the conduits, a certain amount of damage was caused to the boiler dome, which meant that subsequent cleaning required the use of a hydrolazer, where it was noted that inlet pressures were very high. All of this indicated that the cause of the clogging was not physical. This paper provides a comprehensive analytical analysis that explains what happened, as well as resolving the situation.

[1]  C. T. Adams,et al.  Hydroprocess catalyst selection: tailoring and selecting catalyst systems for fixed-bed residue hydroprocessing made easier by a unified reactor model , 1989 .

[2]  S. M. Sadrameli,et al.  Simulation of fixed bed regenerative heat exchangers for flue gas heat recovery , 2004 .

[3]  Sadanari Mochizuki,et al.  Comparison between laminar and turbulent heat transfer in a stationary square duct with transverse or angled rib turbulators , 2001 .

[4]  J. David Logan,et al.  Dimensional Analysis and the Pi Theorem , 1982 .

[5]  Nabil Rafidi.  Thermodynamic aspects and heat transfer characteristics of HiTAC furnaces with regenerators , 2005 .

[6]  Frank Kreith,et al.  Thermal energy storage and regeneration , 1981 .

[7]  E. K. Zariffeh,et al.  THE COMBINED EFFECTS OF WALL AND FLUID AXIAL CONDUCTION ON LAMINAR HEAT TRANSFER IN CIRCULAR TUBES , 1982 .

[8]  Je-Chin Han,et al.  Detailed heat transfer distributions in two-pass square channels with rib turbulators , 1997 .

[9]  Jenn-Jiang Hwang,et al.  Turbulent transport phenomena in a channel with periodic rib turbulators , 1992 .

[10]  Wlodzimierz Blasiak,et al.  Physical properties of a LPG flame with high-temperature air on a regenerative burner , 2004 .

[11]  Charles Baukal,et al.  Heat Transfer in Industrial Combustion , 2000 .

[12]  Stuart W. Churchill,et al.  A general expression for the correlation of rates of transfer and other phenomena , 1972 .

[13]  R. J. Stuart,et al.  Common vortical structure of turbulent flows over smooth and rough boundaries , 1993 .

[14]  M. J. Moran,et al.  Thermal design and optimization , 1995 .

[15]  V. Ganapathy.  Cold end corrosion causes and cures , 1989 .

[16]  Frank P. Incropera,et al.  Fundamentals of Heat and Mass Transfer , 1981 .

[17]  R. Antonia,et al.  Turbulence structure in boundary layers over different types of surface roughness , 2001 .

[18]  G. Eigenberger,et al.  Approximate solutions for metallic regenerative heat exchangers , 2001 .

[19]  M. Damodaran,et al.  Application of ‘SPICE’ to predict temperature distribution in heat pipes , 1991 .

[20]  D. Naylor,et al.  Natural Convective Heat Transfer in a Divided Vertical Channel: Part I—Numerical Study , 1993 .

[21]  J. M. Blanco,et al.  Comparative analysis of CO2 and SO2 emissions between combined and conventional cycles with natural gas and fuel oil consumption over the Spanish thermal power plants , 2006 .

[22]  A. Vincent,et al.  The spatial structure and statistical properties of homogeneous turbulence , 1991, Journal of Fluid Mechanics.

[23]  Danesh K. Tafti,et al.  Large Eddy Simulation of Flow and Heat Transfer in the 180° Bend Region of a Stationary Ribbed Gas Turbine Internal Cooling Duct , 2005 .

[24]  M. Ebadian,et al.  Effects of heat generation and axial heat conduction in laminar flow inside a circular pipe with a step change in wall temperature , 1990 .

[25]  Hyun Dong Shin,et al.  Unsteady thermal flow analysis in a heat regenerator with spherical particles , 2003 .