Development and testing of kick detection system at mud line in deepwater drilling

Abstract Well control issues have posed significant challenges to deep water drilling construction. The success of early kick detection is an essential part of safe well control operations. Due to the characteristics of unresponsive prediction and low precision, conventional kick detection methods cannot meet the demands of deep water well control. This article proposed a more advanced kick monitoring method, which functions by adopting an ultrasonic device to monitor the annular flow velocity. Based on the Doppler principle, an early kick detection (EKD) prototype was successfully developed, which enables the annular flow velocity of the drilling fluid to be measured. Bearing-pressure experiments of 15 MPa were performed to verify the reliability of the ultrasonic sensor under mud line. The results of lab testing demonstrate that the EKD prototype can be used to measure stable annular flow velocities when the gas injection rate is less than 10%. The EKD prototype presented in this paper is valuable for timely kick detection in deep water drilling.

[1]  David Hargreaves,et al.  Early Kick Detection for Deepwater Drilling: New Probabilistic Methods Applied in the Field , 2001 .

[2]  Jon Bang,et al.  Acoustic Gas Kick Detection With Wellhead Sonar , 1994 .

[3]  Kamy Sepehrnoori,et al.  Deepwater gas kick simulation , 2009 .

[4]  Don Reitsma,et al.  First Deepwater Application of Dynamic Annular Pressure Control Succeeds , 2006 .

[5]  K. J. Zanker,et al.  Accurate Flow-Out Measurements for Kick Detection, Actual Response to Controlled Gas Influxes , 1988 .

[6]  Mohammad R. Riazi,et al.  Acoustic velocities in petroleum fluids: Measurement and prediction , 2014 .

[7]  Akhil Datta-Gupta,et al.  Optimizing smart well controls under geologic uncertainty , 2010 .

[8]  Roger Green,et al.  Software-gated pulse-Doppler ultrasound for a DSP-based blood flowmeter , 2000, 2000 IEEE International Conference on Acoustics, Speech, and Signal Processing. Proceedings (Cat. No.00CH37100).

[9]  Helio Santos,et al.  Micro-Flux Control: The Next Generation in Drilling Process , 2003 .

[10]  Joseph Shen,et al.  Two-phase flow metering of heavy oil using a Coriolis mass flow meter: A case study , 2006 .

[11]  J. Colt.  Computation of Dissolved Gas Concentrations in Water As Functions of Temperature, Salinity, and Pressure , 1984 .

[12]  W R Brody,et al.  Theoretical analysis of the CW doppler ultrasonic flowmeter. , 1974, IEEE transactions on bio-medical engineering.

[13]  R. Schroeder,et al.  Real-Time Monitoring and Control of Water Influx to a Horizontal Well Using Advanced Completion Equipped With Permanent Sensors , 2004 .

[14]  Jon Bang,et al.  Brief : acoustic gas-kick detection with wellhead sonar , 1995 .

[15]  S. I. Stokka,et al.  Gas Kick Warner - An Early Gas Influx Detection Method , 1993 .

[16]  J. M. Speers,et al.  Delta Flow: An Accurate, Reliable System for Detecting Kicks and Loss of Circulation During Drilling , 1987 .

[17]  Mingxi Wan,et al.  Theory and experiment of a new pseudorandom ultrasound Doppler blood flowmeter , 1988, IEEE 1988 Ultrasonics Symposium Proceedings..

[18]  P. C. Pedersen,et al.  Coherent FM Doppler system (US blood flow measurement) , 1989, Proceedings., IEEE Ultrasonics Symposium,.

[19]  Stuart Inglis Jardine,et al.  An Improved Kick Detection System for Floating Rigs , 1991 .

[20]  Helio Santos,et al.  Micro-Flux Control: The Next Generation in Drilling Process for Ultra-deepwater , 2003 .

[21]  R. E. Cornish.  The Vertical Multiphase Flow of Oil and Gas At High Rates , 1976 .

[22]  Chris Ward,et al.  Pressure-while-drilling data improve reservoir drilling performance , 1998 .