Parametric study of a multi-effect distillation plant with thermal vapor compression for its integration into a Rankine cycle power block

Abstract This paper presents a parametric study of a multi-effect distillation plant with thermal vapor compression (MED-TVC) for the analysis of its coupling with a Rankine cycle power block. In particular, the effect of the motive and suction steam pressures on the Gain Output Ratio (GOR), fresh water production, the specific heat transfer area and other key variables in an MED-TVC unit has been analyzed. For this purpose, a mathematical model of the MED-TVC system has been firstly developed and validated against actual data from Trapani MED-TVC industrial plant [1]. Different motive steam pressures corresponding to the turbine steam extractions available at a commercial power block have been taken, and the suction pressure has been varied by locating the thermocompressor in different effects. It was found an optimum value of the reduction of the heat transfer area of the evaporators after the suction point such that minimizes the specific heat transfer area. Moreover, results showed that there is an optimum position of the thermocompressor that maximizes the GOR for every motive steam pressure. The results of this work can be very useful to identify the best operation modes when a MED-TVC unit is integrated into a Rankine cycle power block.

[1]  S. Bingulac,et al.  Steady‐State Analysis of the Multiple Effect Evaporation Desalination Process , 1998 .

[2]  R. Kouhikamali,et al.  Process investigation of different locations of thermo-compressor suction in MED–TVC plants , 2011 .

[3]  Sheng Qiang Shen,et al.  Performance Analysis of Parallel Feed LT-MED Desalination System with Thermal Vapor Compressor , 2011 .

[4]  Lucio Rizzuti,et al.  A critical assessment of desalination operations in Sicily , 2005 .

[5]  M. Valdés,et al.  Solar multiple optimization for a solar-only thermal power plant, using oil as heat transfer fluid in the parabolic trough collectors , 2009 .

[6]  Hisham Ettouney,et al.  Analysis of single-effect evaporator desalination systems combined with vapor compression heat pumps , 1997 .

[7]  H. Ettouney,et al.  Multiple Effect Evaporation—Vapour Compression Desalination Processes , 2000 .

[8]  Yong Yang,et al.  Study of steam parameters on the performance of a TVC-MED desalination plant , 2011 .

[9]  Mohamed Darwish,et al.  Performance of thermal vapor compression , 2014 .

[10]  J. Lienhard,et al.  Erratum to Thermophysical properties of seawater: A review of existing correlations and data , 2010 .

[11]  Manuel Romero,et al.  Solar thermal CSP technology , 2014 .

[12]  Feng Gao,et al.  Performance analysis of mixed feed LT-MED desalination system with thermal vapor compressor , 2012 .

[13]  L. Friedel.  Improved Friction Pressure Drop Correlation for Horizontal and Vertical Two-Phase Pipe Flow , 1979 .

[14]  Julián Blanco,et al.  Assessment of different configurations for combined parabolic-trough (PT) solar power and desalinati , 2011 .

[15]  Carmelo Mineo,et al.  MED parallel system powered by concentrating solar power (CSP). Model and case study: Trapani, Sicily , 2015 .

[16]  Mohamed Darwish,et al.  Solar cogeneration power-desalting plant with assisted fuel , 2014 .

[17]  Julián Blanco,et al.  Evaluation of cooling technologies of concentrated solar power plants and their combination with desalination in the mediterranean area , 2013 .

[18]  Alexander Mitsos,et al.  Structural optimization of seawater desalination: II novel MED–MSF–TVC configurations , 2014 .

[19]  W. Wagner,et al.  The IAPWS Formulation 1995 for the Thermodynamic Properties of Ordinary Water Substance for General and Scientific Use , 2002 .

[20]  C Temstet,et al.  A large high-performance MED plant in Sicily , 1996 .