In this article, a CMOS multistandard wireless direct-conversion receiver is designed. The receiver is composed of three components: low noise amplifier, voltage-controlled oscillator, and mixer. In details, the designed receiver adopts direct-conversion architecture and accommodates three standards: WCDMA, Wibro (or mobile WIMAX), and CDMA 2000 1×: 1.84–2.4 GHz. The designed mixer is a passive sub-harmonic doubly balanced structure, the VCO is a back-gate coupling quadrature VCO, and the LNA is a differential structure. Each component is designed with relevance to direct-conversion architecture. The designed mixer has no flicker noise theoretically because the mixing transistors operate in the triode region. Also, DC offset problem is avoided, because local oscillator frequency is half of RF frequency and the port isolation is improved by the innate characteristic of a balanced structure. The VCO generates a quadrature signal and the oscillation frequency is half of RF frequency to drive designed sub-harmonic mixer. No coupling transistors are needed due to the use of back-gate coupling to reduce flicker noise. Back-gate coupling means that the body of a transistor is used as another gate. The LNA, which adopts a well-known cascade structure, is designed as a differential structure to suppress common mode noise and to drive a doubly balanced mixer. All designed components are fabricated by the TSMC 0.18-μm RF CMOS process. © 2010 Wiley Periodicals, Inc. Microwave Opt Technol Lett 52: 718–721, 2010; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.24989
[1]
Sheng-Lyang Jang,et al.
A Quadrature CMOS VCO Using Transformer Coupling and Current Reuse Topology
,
2007,
IEICE Trans. Commun..
[2]
Hyeongdong Kim,et al.
A 0.855 1.342 GHz octa‐phase LC VCO for multimode direct conversion receiver in 0.18‐μm CMOS
,
2008
.
[3]
Hyeongdong Kim,et al.
CMOS multi-standard wireless direct-conversion receiver for SDR
,
2008,
2008 Asia-Pacific Microwave Conference.
[4]
Sang-Gug Lee,et al.
A low-power CMOS direct conversion receiver with 3-dB NF and 30-kHz flicker-noise corner for 915-MHz band IEEE 802.15.4 ZigBee standard
,
2006
.
[5]
M.-C.F. Chang,et al.
A CMOS passive mixer with low flicker noise for low-power direct-conversion receiver
,
2005,
IEEE Journal of Solid-State Circuits.
[6]
T.H. Lee,et al.
A 12 mW wide dynamic range CMOS front end for a portable GPS receiver
,
1997,
1997 IEEE International Solids-State Circuits Conference. Digest of Technical Papers.