Residual stresses in TiN, DLC and MoS2 coated surfaces with regard to their tribological fracture behaviour
暂无分享,去创建一个
Anssi Laukkanen | Kenneth Holmberg | Sture Hogmark | Staffan Jacobson | Kim Wallin | Helena Ronkainen | Urban Wiklund | Per Ståhle | Roberto M. Souza | P. Ståhle | K. Holmberg | S. Hogmark | S. Jacobson | A. Laukkanen | H. Ronkainen | K. Wallin | U. Wiklund | R. Souza | R. Souza
[1] Anssi Laukkanen,et al. Tribological analysis of TiN and DLC coated contacts by 3D FEM modelling and stress simulation , 2008 .
[2] K. Holmberg,et al. Friction in a coated surface deformed by a sliding sphere , 2007 .
[3] G. Janssen,et al. Stress and strain in polycrystalline thin films , 2007 .
[4] C. Mitterer,et al. Annealing of intrinsic stresses in sputtered TiN films: The role of thickness-dependent gradients of point defect density , 2007 .
[5] G. Janssen,et al. Stress gradients in CrN coatings , 2006 .
[6] K. Holmberg,et al. Tribological contact analysis of a rigid ball sliding on a hard coated surface. Part II: Material deformations influence of coating thickness and young's modulus , 2006 .
[7] K. Holmberg,et al. Tribological contact analysis of a rigid ball sliding on a hard coated surface: Part III: Fracture toughness calculation and influence of residual stresses , 2006 .
[8] K. Holmberg,et al. Tribological contact analysis of a rigid ball sliding on a hard coated surface. Part I: Modelling stresses and strains , 2006 .
[9] D. Lamas,et al. Residual stresses in titanium nitride thin films deposited by direct current and pulsed direct current unbalanced magnetron sputtering , 2006 .
[10] H. Du,et al. Toughness measurement of thin films: a critical review , 2005 .
[11] N. Ohtake,et al. Tribological properties of segment-structured diamond-like carbon films , 2004 .
[12] E. Meletis,et al. Tribological behavior of plasma-enhanced CVD a-C:H films. Part II: multinanolayers , 2004 .
[13] E. Werner,et al. Stresses in Thin Films , 2004 .
[14] A. Karimi,et al. On the behaviour of indentation fracture in TiAlSiN hard thin films , 2004 .
[15] K. Komvopoulos,et al. Effect of Residual Stress in Surface Layer on Contact Deformation of Elastic-Plastic Layered Media , 2003 .
[16] Francisco J. G. Silva,et al. Tribological behaviour of CVD diamond films on steel substrates , 2003 .
[17] Anssi Laukkanen,et al. A model for stresses, crack generation and fracture toughness calculation in scratched TiN-coated steel surfaces , 2003 .
[18] J. D. De Hosson,et al. Crack Resistance of PVD Coatings: Influence of Surface Treatment Prior to Deposition , 2002 .
[19] M. Berger. Thick Physical Vapour Deposited TiB2 Coatings , 2002 .
[20] J. Malzbender,et al. Measuring mechanical properties of coatings: a methodology applied to nano-particle-filled sol–gel coatings on glass , 2002 .
[21] Young-Chang Joo,et al. A new technique to measure through film thickness fracture toughness , 2001 .
[22] Y. Pauleau. Generation and evolution of residual stresses in physical vapour-deposited thin films , 2001 .
[23] Martin Heilmaier,et al. A new method of determining strength and fracture toughness of thin hard coatings , 2000 .
[24] E. J. Mittemeijer,et al. On the origin of stress in magnetron sputtered TiN layers , 2000 .
[25] M. Larsson,et al. Mechanical properties of multilayer pvd Ti/TiB2 coatings , 2000 .
[26] J. Malzbender. Cracking and residual stress in hybrid coatings on float glass , 2000 .
[27] H. Hawthorne,et al. The damage mechanisms of several plasma-sprayed ceramic coatings in controlled scratching , 1999 .
[28] Y. Gachon,et al. Study of sand particle erosion of magnetron sputtered multilayer coatings , 1999 .
[29] B. Bhushan. Chemical, mechanical and tribological characterization of ultra-thin and hard amorphous carbon coatings as thin as 3.5 nm: recent developments , 1999 .
[30] B. Bhushan,et al. Evaluation of Fracture Toughness of Ultra-Thin Amorphous Carbon Coatings Deposited by Different Deposition Techniques , 1999 .
[31] M. Larsson,et al. Mechanical and tribological properties of multilayered PVD TiN/CrN , 1999 .
[32] S. Hogmark,et al. Influence of residual stresses on fracture and delamination of thin hard coatings , 1999 .
[33] M. Nastasi,et al. Fracture toughness of diamondlike carbon coatings , 1999 .
[34] P. Juliet,et al. Mechanical properties of W and W(C) thin films : Young's modulus, fracture toughness and adhesion , 1998 .
[35] Sture Hogmark,et al. Mechanical and tribological properties of multilayered PVD TiN/CrN, TiN/MoN, TiN/NbN and TiN/TaN coatings on cemented carbide , 1998 .
[36] S. M. Hsu,et al. Evaluation of thermally-sprayed ceramic coatings using a novel ball-on-inclined plane scratch method , 1998 .
[37] Bharat Bhushan,et al. Measurement of fracture toughness of ultra-thin amorphous carbon films , 1998 .
[38] J. Gunnars,et al. Crack Growth Across a Strength Mismatched Bimaterial Interface , 1998 .
[39] Bharat Bhushan,et al. Fracture Mechanisms of Thin Amorphous Carbon Films in Nanoindentation , 1997 .
[40] M. Nastasi,et al. Investigation of mechanical and tribological properties of amorphous diamond-like carbon coatings , 1997 .
[41] Steve Bull,et al. Failure mode maps in the thin film scratch adhesion test , 1997 .
[42] M. Larsson,et al. Cracking resistance of thin hard coatings estimated by four-point bending , 1997 .
[43] Philip J. Martin,et al. Practical measurement of the residual stress in coatings , 1996 .
[44] Carl V. Thompson,et al. Stress and grain growth in thin films , 1996 .
[45] A. Alahelisten,et al. Thermal stresses in diamond coatings and their influence on coating wear and failure , 1996 .
[46] P. Ståhle,et al. Effect of elastic mismatch on the growth of a crack initially terminated at an interface in elastic plastic bimaterials , 1995 .
[47] Kazuo Hokkirigawa,et al. Fracture Mechanisms of Ceramic Coatings in Indentation , 1994 .
[48] Norman A. Fleck,et al. Brittle fracture under a sliding line contact , 1994 .
[49] C. Davis,et al. A simple model for the formation of compressive stress in thin films by ion bombardment , 1993 .
[50] J. Sue. X-ray elastic constants and residual stress of textured titanium nitride coating , 1992 .
[51] O. Knotek,et al. On the origin of compressive stress in PVD coatings — an explicative model , 1991 .
[52] Anthony G. Evans,et al. Kinking of a Crack out of an Interface: Role of In‐Plane Stress , 1991 .
[53] Staffan Jacobson,et al. Failure mode analysis of TiN-coated high speed steel: In situ scratch adhesion testing in the scanning electron microscope , 1990 .
[54] M. Gantois,et al. Major damage mechanisms during scratch and wear testing of hard coatings on hard substrates , 1989 .
[55] B. Villechaise,et al. Thermomechanical Behavior of Multilayered Media: Theory , 1989 .
[56] D. W. Hoffman,et al. Stress-related effects in thin films , 1989 .
[57] Kyriakos Komvopoulos,et al. Finite element analysis of a layered elastic solid in normal contact with a rigid surface , 1988 .
[58] F. D. Ju,et al. Parameters Affecting Thermo-Meohanical Cracking in Coated Media Due to High-Speed Friction Load , 1988 .
[59] K. H. Kloos,et al. Structure, internal stresses, adhesion and wear resistance of sputtered alumina coatings , 1987 .
[60] H. Windischmann. An intrinsic stress scaling law for polycrystalline thin films prepared by ion beam sputtering , 1987 .
[61] F. D. Ju,et al. Thermomechanical Cracking in Layered Media From Moving Friction Load , 1984 .
[62] A. Pineau,et al. A local criterion for cleavage fracture of a nuclear pressure vessel steel , 1983 .
[63] B. Kramer. Requirements for wear-resistant coatings☆ , 1983 .
[64] G. Stoney. The Tension of Metallic Films Deposited by Electrolysis , 1909 .
[65] A. Erdemir,et al. Tribology of diamond-like carbon films : fundamentals and applications , 2008 .
[66] Y. Pauleau. Residual Stresses in DLC Films and Adhesion to Various Substrates , 2008 .
[67] K. Holmberg,et al. Three dimensional stress analysis of TiN, DLC and MoS2 coated contacts by 3D FEM modelling , 2007 .
[68] Kyriakos Komvopoulos,et al. Mechanical and Thermomechanical Elastic-Plastic Contact Analysis of Layered Media With Patterned Surfaces , 2004 .
[69] Y. Pei,et al. Surface Modification and Mechanisms , 2004 .
[70] S. Cunningham,et al. Thermo- and Electromechanics of Thin-Film Microstructures , 2004 .
[71] Kyriakos Komvopoulos,et al. Three-Dimensional Finite Element Analysis of Elastic-Plastic Layered Media Under Thermomechanical Surface Loading , 2003 .
[72] I. L. Singer,et al. Monitoring Transfer Films and Friction Instabilities with In Situ Raman Tribometry , 2003 .
[73] M. Larsson,et al. DEFLECTION MEASUREMENTS AS METHOD TO DETERMINE RESIDUAL STRESS IN THIN HARD COATINGS ON TOOL MATERIALS , 1996 .
[74] Albert Feldman,et al. Applications of diamond films and related materials , 1995 .
[75] A. Eberhardt,et al. Surface Cracks in Layered Hertzian Contact with Friction , 1995 .
[76] K. Holmberg. Coatings Tribology: Properties, Techniques and Applications in Surface Engineering , 1994 .
[77] H. Windischmann. Intrinsic Stress in Sputter Deposited Thin Films , 1992, Optical Interference Coatings.
[78] M. Alam,et al. Residual Stress in CVD Diamond Films , 1991 .
[79] K. Komvopoulos. Sliding Friction Mechanisms of Boundary-Lubricated Layered Surfaces: Part I—Basic Mechanical Aspects and Experimental Results , 1991 .
[80] S. Bull. Failure modes in scratch adhesion testing , 1991 .
[81] Maria Comninou,et al. AN OVERVIEW OF INTERFACE CRACKS , 1990 .
[82] F. Kennedy,et al. Thermo-mechanical analysis of dry sliding systems , 1987 .
[83] G. Betz,et al. Sputtering by particle bombardment , 1983 .