Quantitative, time-resolved detection of CH 4 concentrations in flows for injection analysis in CNG engines using IR absorption

Abstract. The reduction of CO2 and other greenhouse gas emissions is an important driving force for the development of modern engines. Especially in the transport sector, the use of alternative fuels like methane, the main component of compressed natural gas (CNG), is an applied measure to achieve this goal. This work describes the development of an optical measurement system for accurate quantification of CH4 densities in gas flows based on broadband absorption of infrared light, i.e. non-dispersive IR absorption spectroscopy (NDIR). We demonstrate the capability of the system to achieve high time resolution as well as high measurement accuracy and precision. The optical set-up of the system is designed for usage at the inlet manifold of CNG-fuelled spark ignition engines. It allows for detailed analysis of the mixture formation during single engine cycles. CH4 densities can be determined by monitoring the infrared light attenuation around 3.3 µm caused by the ν3 anti-symmetric C–H-stretch vibration. We calculate the nonlinear relation between transmittance and CH4 density from absorption cross sections calculated from the HITRAN database. The theoretical transmittance signals are corrected for spectral influences of the bandpass filter, the detector sensitivity, the fibre transmittance and the emission spectrum of the light source in order to calculate CH4 densities directly from the measured transmittance. A calibration function corrects remaining differences between experimental and simulated values and improves the accuracy. We show that the sensor system is capable for determination of air–fuel ratios (λ-values) and demonstrate the dynamic quantification of a CH4 injection into a flow channel under various flow conditions. Furthermore, we present the first measurements with a prototype probe capable of measurements inside the inlet manifold of a four-stroke spark ignition engine. We validate the detection strategy in experiments with premixed gases using a modified inlet geometry and demonstrate its application under standard engine operation with port fuel injection while varying the injection parameters.

[1]  M. Gambino,et al.  Evaluation of emission toxicity of urban bus engines: compressed natural gas and comparison with liquid fuels. , 2006, The Science of the total environment.

[2]  Nick Collings.  A New Technique for Measuring HC Concentration in Real Time, in a Running Engine , 1988 .

[3]  Robert W. Dibble,et al.  In situ measurement of hydrocarbon fuel concentration near a spark plug in an engine cylinder using the 3.392 μm infrared laser absorption method: Discussion of applicability with a homogeneous methane-air mixture , 2003 .

[4]  P. T. Krein,et al.  Review of Battery Charger Topologies, Charging Power Levels, and Infrastructure for Plug-In Electric and Hybrid Vehicles , 2013, IEEE Transactions on Power Electronics.

[5]  Volker Sick,et al.  Tracer-LIF diagnostics: quantitative measurement of fuel concentration, temperature and fuel/air ratio in practical combustion systems , 2005 .

[6]  Michael H. Koenig,et al.  Measurements of Local In-Cylinder Fuel Concentration Fluctuations in a Firing SI Engine , 1997 .

[7]  Renato J. Orsato,et al.  The emergence of an electric mobility trajectory , 2013 .

[8]  A. Grosch,et al.  Infrared spectroscopic concentration measurements of carbon dioxide and gaseous water in harsh environments with a fiber optical sensor by using the HITEMP database , 2014 .

[9]  Matthew J. Hall.  Mid-IR fiber optic sensors for internal combustion engines , 1999, Optics East.

[10]  Volker Sick,et al.  Toluene laser-induced fluorescence for in-cylinder temperature imaging in internal combustion engines , 2008 .

[11]  Anibal T. de Almeida,et al.  A sustainability assessment of electric vehicles as a personal mobility system , 2012 .

[12]  T. Korakianitis,et al.  Natural-gas fueled spark-ignition (SI) and compression-ignition (CI) engine performance and emissions , 2011 .

[13]  Ronald K. Hanson,et al.  Temperature- and pressure-dependent absorption cross sections of gaseous hydrocarbons at 3.39 µm , 2006 .

[14]  Eiji Tomita,et al.  In situ measurement of hydrocarbon fuel concentration near a spark plug in an engine cylinder using the 3.392 µm infrared laser absorption method: application to an actual engine , 2003 .

[15]  E. R. Polovtseva,et al.  The HITRAN2012 molecular spectroscopic database , 2013 .

[16]  Andrew Harrison,et al.  A new comparison between the life cycle greenhouse gas emissions of battery electric vehicles and internal combustion vehicles , 2012 .

[17]  V. Beushausen,et al.  Temperature- and pressure-dependent midinfrared absorption cross sections of gaseous hydrocarbons. , 2010, Applied optics.

[18]  Wai K. Cheng,et al.  On the time delay in continuous in-cylinder sampling from IC engines , 1989 .

[19]  V. Beushausen,et al.  Calibration of mid-infrared transmission measurements for hydrocarbon detection and propane concentration measurements in harsh environments by using a fiber optical sensor , 2011 .

[20]  Richard W. Anderson,et al.  Fiber optic sensor for crank angle resolved measurements of burned gas residual fraction in the cylinder of an SI engine , 2001 .

[21]  Mikhail A. Bolshov,et al.  Tunable diode laser spectroscopy as a technique for combustion diagnostics , 2015 .

[22]  John B. Heywood,et al.  In-Cylinder Measurements of Residual Gas Concentration in a Spark Ignition Engine , 1990 .

[23]  Gang Li,et al.  The HITRAN 2008 molecular spectroscopic database , 2005 .

[24]  Michael H. Koenig,et al.  Cycle-resolved measurements of pre-combustion fuel concentration near the spark plug in a gasoline SI engine , 1998 .

[25]  V. Beushausen,et al.  Crank Angle Resolved Determination of Fuel Concentration and Air/Fuel Ratio in a SI-Internal Combustion Engine Using a Modified Optical Spark Plug , 2007 .