Interrelationship between electrocoalescence and interfacial tension in a high acidity crude: Effect of pH and nature of alkalinity

Abstract The efficacy of electrocoalescence is critically dependent upon the interfacial tension of the crude–water interface. This study demonstrates the effect of interfacial tension on the electrocoalescence efficiency in crudes with high acidity. The interfacial tension is estimated using spinning drop tensiometer (SDT) and electrocoalescence experiments are performed at an electric field = 1.15 kVrms/cm at a frequency of 50 Hz. It is observed that separation of water from the crude is hindered at high pH for two very different reasons depending upon the source of alkalinity. Calcium hydroxide induced alkalinity leads to more rigid interface, resulting in delayed electrocoalescence. On the other hand, sodium hydroxide based alkalinity leads to ultra-low tension of crude–water interface, thereby causing oil-in-water emulsion. Increase in the pH also leads to poor quality of brine resolution, in case of sodium hydroxide based alkalinity (pH = 10) we get unresolved turbid emulsion.

[1]  C. Dicharry,et al.  Influence of pH and Water Content on the Type and Stability of Acidic Crude Oil Emulsions , 2007 .

[2]  H. Yarranton,et al.  The Stabilization of Water-in-Hydrocarbon Emulsions by Asphaltenes and Resins , 2001 .

[3]  P. K. Kilpatrick.  Water-in-Crude Oil Emulsion Stabilization: Review and Unanswered Questions , 2012 .

[4]  Simone Less,et al.  Electrostatic destabilization of water-in-crude oil emulsions: Application to a real case and evaluation of the Aibel VIEC technology , 2008 .

[5]  J. Argillier,et al.  Interfacial behavior of asphaltenes. , 2016, Advances in colloid and interface science.

[6]  K. Moran,et al.  On the Stabilization Mechanism of Water-in-Oil Emulsions in Petroleum Systems , 2005 .

[7]  T. Havre.  Near-IR spectroscopy as a method for studying the formation of calcium naphthenate , 2004 .

[8]  J. Strassner,et al.  Effect of pH on Interfacial Films and Stability of Crude Oil-Water Emulsions , 1968 .

[9]  M. Fahim,et al.  Stability of Water-in-Crude Oil Emulsions: Effect of Oil Aromaticity, Resins to Asphaltene Ratio, and pH of Water , 2008 .

[10]  Hussein,et al.  Water-in-Hydrocarbon Emulsions Stabilized by Asphaltenes at Low Concentrations. , 2000, Journal of colloid and interface science.

[11]  Regis Vilagines,et al.  The electrocoalescers' technology: Advances, strengths and limitations for crude oil separation , 2012 .

[12]  A. Hassanpour,et al.  Electrostatic phase separation: a review , 2015 .

[13]  J. Speight.  The Chemistry and Technology of Petroleum , 1980 .

[14]  S. Acevedo,et al.  Interfacial rheological studies of extra-heavy crude oils and asphaltenes: Role of the dispersion effect of resins in the adsorption of asphaltenes at the interface of water-in-crude oil emulsions☆ , 1993 .

[15]  J. Chung,et al.  Demulsification of water-in-oil emulsion by wetting coalescence materials in stirred- and packed-columns , 1999 .

[16]  Shahab Ayatollahi,et al.  Effect of Salinity, Resin, and Asphaltene on the Surface Properties of Acidic Crude Oil/Smart Water/Rock System , 2014 .

[17]  Meiqin Lin,et al.  The influence of NaOH on the stability of paraffinic crude oil emulsion , 2005 .

[18]  R. L. Cummins,et al.  Modification of a Centrifugal Separator for In-Well Oil-Water Separation , 2005 .

[19]  D. Harbottle,et al.  Interfacial Layer Properties of a Polyaromatic Compound and its Role in Stabilizing Water-in-Oil Emulsions. , 2015, Langmuir.

[20]  J. Argillier,et al.  Effect of Added Surfactants in an Enhanced Alkaline/Heavy Oil System , 2011 .

[21]  J. Sjöblom,et al.  Oil/Water‐Partitioning and Interfacial Behavior of Naphthenic Acids , 2003 .

[22]  Rochish Thaokar,et al.  Electrocoalescence in non-uniform electric fields: An experimental study , 2015 .

[23]  S. Simon,et al.  Limitations and Applicability of the Interfacial Shear Rheology in the Study of Monolayer Films at the Air-Water Interface , 2014 .

[24]  Pin–Plate Electrode System for Emulsification of a Higher Conductivity Leaky Dielectric Liquid into a Low Conductivity Medium , 2014 .

[25]  J. Argillier,et al.  Influence of pH on Stability and Dynamic Properties of Asphaltenes and Other Amphiphilic Molecules at the Oil−Water Interface† , 2005 .