Fatigue threshold-stress determination in AFP laminates containing gaps using IR thermography

Abstract The existence of gaps during manufacturing using automated fiber placement (AFP) is unavoidable. It is of interest to determine the threshold stress value below which no effect of the gaps on fatigue life exists. This work aims to use infrared thermography and apply Risitano method on AFP laminates containing gaps to provide a quick method for obtaining the threshold value. This method has a great potential in saving time and material required for performing traditional fatigue tests to develop stress/life curves. Based on the thermal observations of surface temperature of gapped specimen under fatigue loading with different maximum stress levels, a relation between the thermal response and the applied stress was observed. From this relation, the threshold stress value can be evaluated using a small number of specimens and in a short time. To investigate the applicability of this technique to different stacking sequences, fatigue tests were conducted on unidirectional, four-angle and cross-ply laminates containing defects (gaps). In addition, stress/life curves were developed for reference and defected specimens in order to get the threshold value using the traditional (Wohler) method. The results of threshold stress using IR thermography are in very good agreement with the results obtained using the traditional way.

[1]  Hui Li,et al.  First-principles study on the structural and electronic properties of clean and atomic oxygen adsorbed ZrC(001) surface , 2015 .

[2]  Theodore E. Matikas,et al.  Rapid evaluation of the fatigue limit in composites using infrared lock-in thermography and acoustic emission , 2013 .

[3]  Graziano Curti,et al.  Analisi tramite infrarosso termico della temperatura limite in prove di fatica , 1986 .

[4]  Damiano Pasini,et al.  Experimental study of the effect of automated fiber placement induced defects on performance of composite laminates , 2011 .

[5]  L. Vergani,et al.  Damage assessment of composite materials by means of thermographic analyses , 2013 .

[6]  Nicklaus C. Kimball.  Open hole compressive behavior of laminates with converging gap defects , 2011 .

[7]  Antonino Risitano,et al.  Thermographic methodology for rapid determination of the fatigue limit of materials and mechanical components , 2000 .

[8]  John Montesano,et al.  Use of infrared thermography to investigate the fatigue behavior of a carbon fiber reinforced polymer composite , 2013 .

[9]  Suong V. Hoa,et al.  Experimental and numerical investigation of the effect of gaps on fatigue behavior of unidirectional carbon/epoxy automated fiber placement laminates , 2017 .

[10]  Chiara Colombo,et al.  Fatigue behaviour of a GFRP laminate by thermographic measurements , 2011 .

[11]  Damiano Pasini,et al.  Defect layer method to capture effect of gaps and overlaps in variable stiffness laminates made by Automated Fiber Placement , 2013 .

[12]  Minh Phong Luong,et al.  Fatigue limit evaluation of metals using an infrared thermographic technique , 1998 .

[13]  Chiara Colombo,et al.  Static and fatigue characterisation of new basalt fibre reinforced composites , 2012 .

[14]  Xiangqian Li,et al.  Modelling the effect of gaps and overlaps in automated fibre placement (AFP)-manufactured laminates , 2015 .

[15]  Douglas S. Cairns,et al.  Response of automated tow placed laminates to stress concentrations , 1993 .

[16]  L. Vergani,et al.  Fatigue damage in GFRP , 2012 .

[17]  Zafer Gürdal,et al.  Progressive failure analysis of tow-placed, variable-stiffness composite panels , 2007 .