This paper presents a technique of electric energy generation using a mechanically excited unimorph piezoelectric membrane transducer. The electrical characteristics of the piezoelectric power generator are investigated under dynamic conditions. The electromechanical model of the generator is presented and used to predict its electrical performances. The experiments was performed with a piezoelectric actuator (shaker) moving a macroscopic 25 mm diameter piezoelectric membrane. A power of 0.65 mW was generated at the resonance frequency (1.71 kHz) across a 5.6 kOmega optimal resistor and for a 80 N force. A special electronic circuit has been conceived in order to increase the power harvested by the piezoelectric transducer. This electrical converter applies the SSHI (synchronized switch harvesting on inductor) technique, and leads to remarkable results: under the same actuation conditions the generated power reaches 1.7 mW, which is sufficient to supply a large range of low consumption sensors.
[1]
Michael P. Païdoussis,et al.
FOREWORD FOR VOLUME 15
,
2001
.
[2]
Khai D. T. Ngo,et al.
Technology Development for Self-Powered Sensors
,
2002
.
[3]
G. Harbauer,et al.
Implantable physiological power supply with PVDF film
,
1984
.
[4]
V. Schmidt.
Piezoelectric energy conversion in windmills
,
1992,
IEEE 1992 Ultrasonics Symposium Proceedings.
[5]
D. Guyomar,et al.
Toward energy harvesting using active materials and conversion improvement by nonlinear processing
,
2005,
IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.