Development of Laser-Assisted Bonding with Compression (LABC) Process for 3D IC Integration

Laser-Assisted Bonding with Compression (LABC) technology with NCF was proposed to accomplish the productivity and process reliability at the same time. A quartz block as a header was used to deliver a pressure to the devices because of its extremely low absorption of the laser during the bonding process. Newly developed NCF for LABC was designed to have stability on a hot stage and to show solder wetting and fast curing with no void and optimal fillet during the LABC bonding process. As the laser is used as a heat source, the uniform heat should be provided on each interconnection without any damages on chip or a substrate. 780μ-thick daisy chain top and bottom chips with the minimum pitch of 30^m and bump number of about 27,000 were successfully bonded using the LABC and NCF film.

[1]  K. Honda,et al.  NCF for pre-applied process in higher density electronic package including 3D-package , 2012, 2012 IEEE 62nd Electronic Components and Technology Conference.

[2]  Juhoon Yoon,et al.  Wafer Level Multi-chip Gang Bonding Using TCNCF , 2016, 2016 IEEE 66th Electronic Components and Technology Conference (ECTC).

[3]  Shigetoshi Sugawa,et al.  Design and Application of Innovative Multi-table and Bond Head Drive System on Thermal Compression Bonder with UPH Over 2000 , 2018, 2018 IEEE 68th Electronic Components and Technology Conference (ECTC).

[4]  Choonheung Lee,et al.  Development of Next Generation Flip Chip Interconnection Technology Using Homogenized Laser-Assisted Bonding , 2016, 2016 IEEE 66th Electronic Components and Technology Conference (ECTC).

[5]  T. Nonaka,et al.  High throughput thermal compression NCF bonding , 2014, 2014 IEEE 64th Electronic Components and Technology Conference (ECTC).