Aerothermal Performance of a Cooled Winglet at Engine Representative Mach and Reynolds Numbers

This paper presents an experimental and numerical investigation of the aerothermal performance of an uncooled winglet tip, under transonic conditions. Spatially resolved heat transfer data, including winglet tip surface and near-tip side-walls, are obtained using the transient infrared thermography technique within the Oxford high speed linear cascade test facility. Computational fluid dynamics (CFD) predictions are also conducted using the Rolls-Royce HYDRA suite. Most of the spatial heat transfer variations on the tip surface are well-captured by the CFD solver. The transonic flow pattern and its influence on heat transfer are analyzed, which shows that the turbine blade tip heat transfer is greatly influenced by the shock wave structure inside the tip gap. The effect of the casing relative motion is also numerically investigated. The CFD results indicate that the local heat transfer distribution on the tip is affected by the relative casing motion but the tip flow choking and shock wave structure within the tip gap still exist in the aft region of the blade.

[1]  Charles W. Haldeman,et al.  Time-Averaged Heat Flux for a Recessed Tip, Lip, and Platform of a Transonic Turbine Blade , 2000 .

[2]  D. E. Metzger,et al.  The Influence of Turbine Clearance Gap Leakage on Passage Velocity and Heat Transfer Near Blade Tips: Part II—Source Flow Effects on Blade Suction Sides , 1989 .

[3]  Michael G. Dunn,et al.  Turbine Tip and Shroud Heat Transfer , 1991 .

[4]  Cengiz Camci,et al.  Aerodynamic Tip Desensitization of an Axial Turbine Rotor Using Tip Platform Extensions , 2001 .

[5]  Li He,et al.  Overtip Shock Wave Structure and Its Impact on Turbine Blade Tip Heat Transfer , 2011 .

[6]  Je-Chin Han,et al.  Heat Transfer Coefficients and Film Cooling Effectiveness on the Squealer Tip of a Gas Turbine Blade , 2003 .

[7]  Howard P. Hodson,et al.  Heat transfer and aerodynamics of turbine blade tips in a linear cascade , 2006 .

[8]  Li He,et al.  Transonic Turbine Blade Tip Aerothermal Performance With Different Tip Gaps—Part I: Tip Heat Transfer , 2011 .

[9]  T. Arts,et al.  Aerodynamic Investigation of the Tip Leakage Flow for Blades With Different Tip Squealer Geometries at Transonic Conditions , 2009 .

[10]  Srinath V. Ekkad,et al.  Effect of Tip Gap and Squealer Geometry on Detailed Heat Transfer Measurements Over a High Pressure Turbine Rotor Blade Tip , 2004 .

[11]  Li He,et al.  Turbine Blade Tip Heat Transfer in Low Speed and High Speed Flows , 2011 .

[12]  T. C. Booth,et al.  Rotor-Tip Leakage: Part II—Design Optimization Through Viscous Analysis and Experiment , 1981 .

[13]  Li He,et al.  Comparison of Heat Transfer Measurement Techniques on a Transonic Turbine Blade Tip , 2011 .

[14]  Neil William Harvey,et al.  An Investigation Into a Novel Turbine Rotor Winglet: Part 2 — Numerical Simulation and Experimental Results , 2006 .

[15]  Je-Chin Han,et al.  Detailed heat transfer coefficient distributions on a large-scale gas turbine blade tip , 2001 .

[16]  Richard J Goldstein,et al.  Effect of Endwall Motion on Blade Tip Heat Transfer , 2003 .

[17]  Gary D. Lock,et al.  Calibration of a four-hole pyramid probe and area traverse measurements in a short-duration transonic turbine cascade tunnel , 1996 .

[18]  Ali Ameri,et al.  Effect of Squealer Tip on Rotor Heat Transfer and Efficiency , 1998 .

[19]  Je-Chin Han,et al.  Turbine Rotor with Various Tip Configurations Flow and Heat Transfer Prediction , 2006 .

[20]  Howard P. Hodson,et al.  Aerothermal Investigations of Tip Leakage Flow in Axial Flow Turbines—Part III: TIP Cooling , 2009 .

[21]  M. L. G. Oldfield,et al.  Impulse Response Processing of Transient Heat Transfer Gauge Signals , 2008 .

[22]  R. Bunker,et al.  Blade Tip Leakage Flow and Heat Transfer With Pressure-Side Winglet , 2006 .

[23]  Ali Ameri,et al.  Heat Transfer and Flow on the First-Stage Blade Tip of a Power Generation Gas Turbine: Part 1—Experimental Results , 2000 .

[24]  J. P. Bindon,et al.  The measurement and formation of tip clearance loss , 1989 .

[25]  Neil William Harvey,et al.  An Investigation Into a Novel Turbine Rotor Winglet: Part I — Design and Model Rig Test Results , 2006 .

[26]  S. Ekkad,et al.  Effect of Tip and Pressure Side Coolant Injection on Heat Transfer Distributions for a Plane and Recessed Tip , 2007 .

[27]  J. E. LaGraff,et al.  PIV Maps of Tip Leakage and Secondary Flow Fields on a Low-Speed Turbine Blade Cascade With Moving End Wall , 2008 .

[28]  J. G. Moore,et al.  Flow and Heat Transfer in Turbine Tip Gaps , 1989 .

[29]  Howard P. Hodson,et al.  Aerothermal Investigations of Tip Leakage Flow in Axial Flow Turbines—Part I: Effect of Tip Geometry and Tip Clearance Gap , 2009 .

[30]  A. A. Ameri,et al.  Heat Transfer and Flow on the First-Stage Blade Tip of a Power Generation Gas Turbine: Part 2—Simulation Results , 2000 .

[31]  S. J. Kline,et al.  Describing Uncertainties in Single-Sample Experiments , 1953 .

[32]  Je-Chin Han,et al.  Film-Cooling Effectiveness on a Gas Turbine Blade Tip Using Pressure Sensitive Paint , 2004 .

[33]  Michael G. Dunn,et al.  Measurement and Analyses of Heat Flux Data in a Turbine Stage: Part I—Description of Experimental Apparatus and Data Analysis , 1984 .

[34]  Budugur Lakshminarayana,et al.  Tip clearance effects in a turbine rotor : Part I : Pressure field and loss , 2001 .

[35]  Howard P. Hodson,et al.  Aerothermal Investigations of Tip Leakage Flow in Axial Flow Turbines-Part II: Effect of Relative Casing Motion , 2009 .

[36]  Howard P. Hodson,et al.  Aero-Thermal Investigations of Tip Leakage Flow In Axial Flow Turbines: Part I — Effect of Tip Geometry and Tip Clearance Gap , 2007 .

[37]  Steen A. Sjolander,et al.  Effects of Simulated Rotation on Tip Leakage in a Planar Cascade of Turbine Blades: Part II—Downstream Flow Field and Blade Loading , 1992 .

[38]  D. E. Metzger,et al.  HEAT TRANSFER AT THE TIP OF AN UNSHROUDED TURBINE BLADE , 1982 .

[39]  Roger W. Ainsworth,et al.  Blade-tip heat transfer in a transonic turbine , 2005 .

[40]  Budugar Lakshminarayana,et al.  Tip Clearance Effects in a Turbine Rotor: Part II—Velocity Field and Flow Physics , 2001 .

[41]  A. Yamamoto,et al.  Endwall Flow/Loss Mechanisms in a Linear Turbine Cascade With Blade Tip Clearance , 1989 .

[42]  Li He,et al.  Aero-Thermal Performance of a Winglet at Engine Representative Mach and Reynolds Numbers , 2010 .

[43]  Jeremy Clyde Bailey,et al.  Effect of Squealer Cavity Depth and Oxidation on Turbine Blade Tip Heat Transfer , 2001 .

[44]  Gary D. Lock,et al.  Free Vortex Theory for Efficiency Calculations From Annular Cascade Data , 1997 .

[45]  Je-Chin Han,et al.  Heat Transfer Coefficients on the Squealer Tip and Near-Tip Regions of a Gas Turbine Blade With Single or Double Squealer , 2003 .

[46]  Je-Chin Han,et al.  Heat transfer coefficients on the squealer tip and near squealer tip regions of a gas turbine blade , 2003 .

[47]  Hugh W. Coleman,et al.  Experimentation and Uncertainty Analysis for Engineers , 1989 .

[48]  R S Bunker,et al.  A Review of Turbine Blade Tip Heat Transfer , 2001, Annals of the New York Academy of Sciences.

[49]  Nicole L. Key,et al.  Comparison of Turbine Tip Leakage Flow for Flat Tip and Squealer Tip Geometries at High-Speed Conditions , 2006 .

[50]  Nikhil M. Rao,et al.  Influence of Casing Roughness on the Aerodynamic Structure of Tip Vortices in an Axial Flow Turbine , 2006 .

[51]  Srinath V. Ekkad,et al.  Numerical Simulation of Flow and Heat Transfer Past a Turbine Blade With a Squealer-Tip , 2002 .

[52]  Howard P. Hodson,et al.  Aeromechanical Optimisation of a Winglet-Squealer Tip for an Axial Turbine , 2010 .

[53]  Je-Chin Han,et al.  Heat Transfer and Flow on the Squealer Tip of a Gas Turbine Blade , 2000 .

[54]  Minking K. Chyu,et al.  Heat Transfer in the Tip Region of Grooved Turbine Blades , 1989 .

[55]  Robert J. Moffat,et al.  Describing the Uncertainties in Experimental Results , 1988 .

[56]  John D. Denton,et al.  The 1993 IGTI Scholar Lecture: Loss Mechanisms in Turbomachines , 1993 .

[57]  J. B. Young,et al.  Defining the Efficiency of a Cooled Turbine , 2006 .

[58]  Je-Chin Han,et al.  Heat Transfer and Pressure Distributions on a Gas Turbine Blade Tip , 2000 .

[59]  Richard J Goldstein,et al.  Effects of Tip Geometry and Tip Clearance on the Mass/Heat Transfer From a Large-Scale Gas Turbine Blade , 2003 .

[60]  Zbigniew Schabowski,et al.  The Reduction of Over Tip Leakage Loss in Unshrouded Axial Turbines Using Winglets and Squealers , 2007 .

[61]  Howard P. Hodson,et al.  Aero-Thermal Investigations of Tip Leakage Flow In Axial Flow Turbines: Part II — Effect of Relative Casing Motion , 2007 .

[62]  Howard P. Hodson,et al.  The Effect of Blade Tip Geometry on the Tip Leakage Flow in Axial Turbine Cascades , 1991 .

[63]  Je-Chin Han,et al.  Heat Transfer Coefficients and Film-Cooling Effectiveness on a Gas Turbine Blade Tip , 2003 .

[64]  Neil William Harvey,et al.  A Computational Study of a Novel Turbine Rotor Partial Shroud , 2001 .