Using Image Analysis Techniques for Single Evaluation of the Chip Shrinkage Factor in Orthogonal Cutting Process

The forces involved in a cutting process are related, for example, with the power consumption, with the final quality of the workpiece and with the chip geometry obtained, since these forces determine the compression experimented by the chip and therefore its final geometry. The orthogonal cutting process assisted with a High Speed Filmation (HSF) permit obtains a digital filmation of the process with high magnification. This filmation permits to obtain a measurement of the longitudinal changes produced in the chip. This deforms are related with the Shrinkage Factor, ζ. And in this case the Stabler hypothesis is enabled, by that using the shear angle and the rake angle is possible obtain a value of the Shrinkage Factor in a different conditions.