A Simple Model for Predicting the Trapped Mass in a DI Diesel Engine

[1]  Rolf Egnell,et al.  Combustion Diagnostics by Means of Multizone Heat Release Analysis and NO Calculation , 1998 .

[2]  Jose J. Lopez,et al.  Development of a zero-dimensional Diesel combustion model: Part 2: Analysis of the transient initial and final diffusion combustion phases , 2003 .

[3]  Arvind Atreya,et al.  An Experimental Heat Release Rate Analysis of a Diesel Engine Operating Under Steady State Conditions , 1997 .

[4]  John B. Heywood,et al.  A Model for Predicting Residual Gas Fraction in Spark-Ignition Engines , 1993 .

[5]  X. Margot,et al.  Computational Study of Heat Transfer to the Walls of a DI Diesel Engine , 2005 .

[6]  H. Kosaka,et al.  A NUMERICAL SIMULATION OF IGNITION DELAY IN DIESEL ENGINES , 1998 .

[7]  Jose J. Lopez,et al.  Development of a zero-dimensional Diesel combustion model. Part 1: Analysis of the quasi-steady diffusion combustion phase , 2003 .

[8]  Damon Honnery,et al.  Heat release model for the combustion of diesel oil emulsions in DI diesel engines , 2005 .

[9]  John B. Heywood,et al.  Heat Release Analysis of Engine Pressure Data , 1984 .

[10]  Octavio Armas,et al.  Influence of measurement errors and estimated parameters on combustion diagnosis , 2006 .

[11]  A Three-Zone Heat Release Model for DI Diesel Engines , 1994 .

[12]  H. Hiroyasu,et al.  Development and Use of a Spray Combustion Modeling to Predict Diesel Engine Efficiency and Pollutant Emissions : Part 1 Combustion Modeling , 1983 .

[13]  Dimitrios C. Kyritsis,et al.  Validation and sensitivity analysis of a two zone Diesel engine model for combustion and emissions prediction , 2004 .

[14]  Konstantinos Boulouchos,et al.  A Phenomenological Combustion Model for Heat Release Rate Prediction in High-Speed DI Diesel Engines with Common Rail Injection , 2000 .

[15]  Diego Micheli,et al.  Phenomenological Modelling of IDI Diesel Engines , 1997 .

[16]  Paul N. Blumberg,et al.  Phenomenological models for reciprocating internal combustion engines , 1979 .

[17]  G. Woschni.  A Universally Applicable Equation for the Instantaneous Heat Transfer Coefficient in the Internal Combustion Engine , 1967 .

[18]  Andrew L. Emtage,et al.  The Calculation of Heat Release Energy from Engine Cylinder Pressure Data , 1998 .

[19]  Rolf D. Reitz,et al.  Predictions of Residual Gas Fraction in IC Engines , 1996 .

[20]  Nick Collings,et al.  Pressure data analysis of Formula One racing engines , 1997 .

[21]  Jose J. Lopez,et al.  Cycle to Cycle Diesel Combustion Characterisation During Engine Transient Operation , 2001 .

[22]  Takeyuki Kamimoto,et al.  A Two-Zone Model Analysis of Heat Release Rate in Diesel Engines , 1997 .

[23]  David J. Timoney,et al.  Problems with Heat Release Analysis in D.I. Diesels , 1987 .

[24]  N Watson,et al.  A Combustion Correlation for Diesel Engine Simulation , 1980 .

[25]  John B. Heywood,et al.  Evaluation of a One-Zone Burn-Rate Analysis Procedure Using Production SI Engine Pressure Data , 1993 .

[26]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[27]  Francisco José Arnau,et al.  Analysis of numerical methods to solve one-dimensional fluid-dynamic governing equations under impulsive flow in tapered ducts , 2004 .

[28]  David R. Lancaster,et al.  MEASUREMENT AND ANALYSIS OF ENGINE PRESSURE DATA , 1975 .

[29]  José Galindo,et al.  Combustion simulation of turbocharger HSDI Diesel engines during transient operation using neural networks , 2005 .

[30]  W. L. Brown.  Methods for Evaluating Requirements and Errors in Cylinder Pressure Measurement , 1967 .

[31]  O. Armas,et al.  Diagnosis of DI Diesel combustion from in-cylinder pressure signal by estimation of mean thermodynamic properties of the gas , 1999 .

[32]  Lars Eriksson,et al.  A Specific Heat Ratio Model for Single-Zone Heat Release Models , 2004 .