Modeling partial discharge in a three-phase cable joint experiment with minimal adjustable parameters

A general physical model of partial discharge (PD) has been developed and used to simulate discharges within a void at the tip of a metallic spike defect within a three-phase 11 kV paper insulated lead covered (PILC) cable joint. Discharges are modeled by altering surface charge density at the void boundary using a logistic function distribution. The model was validated against experimental data, and a good agreement was observed with minimal free parameters. The model was then used to investigate the impact of single phase energization on PD activity in three-phase PILC cable joints. It was concluded that PD testing of three-phase PILC cable joints should be performed at raised temperatures with the cable fully energized as this results in a higher frequency of PD activity, and reduces the level of background PD from cable terminations. This research represents a further step towards developing PD models that can describe measurements taken from operational high voltage plant.

[1]  S. Boggs,et al.  Partial discharge: overview and signal generation , 1990, IEEE Electrical Insulation Magazine.

[2]  R. J. Brunt.  Physics and chemistry of partial discharge and corona. Recent advances and future challenges , 1994 .

[3]  L. Niemeyer,et al.  Measurement and simulation of PD in epoxy voids , 1995 .

[4]  L. Niemeyer.  A generalized approach to partial discharge modeling , 1995 .

[5]  C. Heitz,et al.  A generalized model for partial discharge processes based on a stochastic process approach , 1999 .

[6]  A. Cavallini,et al.  Effect of supply voltage frequency on testing of insulation system , 2006, IEEE Transactions on Dielectrics and Electrical Insulation.

[7]  Optical Diagnosis of Pulsed Streamer Discharge under Atmospheric Pressure , 2007 .

[8]  H. Edin,et al.  Partial discharges in a cavity at variable applied frequency part 2: measurements and modeling , 2008, IEEE Transactions on Dielectrics and Electrical Insulation.

[9]  Zhiqiang Xu,et al.  Charge trapping and detrapping in polymeric materials , 2009 .

[10]  J. A. Hunter,et al.  Partial discharge in medium voltage three-phase cables , 2010, 2010 IEEE International Symposium on Electrical Insulation.

[11]  Simulation of partial discharge sequences using fluid equations , 2011 .

[12]  J. A. Hunter,et al.  Discrimination of multiple PD sources using wavelet decomposition and principal component analysis , 2011, IEEE Transactions on Dielectrics and Electrical Insulation.

[13]  P L Lewin,et al.  Partial discharge behavior within a spherical cavity in a solid dielectric material as a function of frequency and amplitude of the applied voltage , 2011, IEEE Transactions on Dielectrics and Electrical Insulation.

[14]  Hazlee Azil Illias,et al.  The influence of spherical cavity surface charge distribution on the sequence of partial discharge events , 2011 .

[15]  P. L. Lewin,et al.  Partial discharge diagnostics of defective medium voltage three-phase PILC cables , 2012, 2012 IEEE International Symposium on Electrical Insulation.

[16]  Kai Wu,et al.  Dynamic behavior of surface charge distribution during partial discharge sequences , 2013, IEEE Transactions on Dielectrics and Electrical Insulation.

[17]  Jack A. Hunter.  An investigation into partial discharge activity within three-phase belted cables , 2013 .

[18]  G. Callender,et al.  Physical models for field based partial discharge measurements , 2014, 2014 International Conference on Advances in Communication and Computing Technologies (ICACACT 2014).