On-board Fault Diagnosis of HEV Induction Motor Drive at Start-up and During Idle Mode

The integrity of the electric motors in work and passenger vehicles can best be maintained by monitoring its condition frequently on-board the vehicle. In this paper, a signal processing based fault diagnosis scheme for on-board diagnosis of rotor asymmetry at start-up and idle mode is presented. Regular rotor asymmetry tests are done when the motor is running at certain speed under load with stationary current signal assumption. It is quite challenging to obtain these regular test conditions for long enough time during daily vehicle operations. In addition, automobile vibrations cause a nonuniform air-gap motor operation which directly affects the inductances of electric motor and results quite noisy current spectrum. Therefore, examining the condition of electric motor as part of hybrid electric vehicle (HEV) powertrain, conventional rotor fault detection methods become impracticable. The proposed method overcomes the aforementioned problems simply by testing the rotor asymmetry at zero speed. This test can be achieved and repeated during start-up and idle modes. The proposed method can be implemented at no cost basically using the readily available electric motor inverter sensors and microprocessing unit. Induction motor rotor asymmetry fault signatures are experimentally tested online employing the drive embedded master processor (TMS320F2812 DSP) to prove the effectiveness of the proposed method. It is experimentally shown that the proposed method detects the fault harmonics at start-up and standstill to determine the existence and the severity of faults in HEV powertrain.

[1]  H. A. Toliyat,et al.  Performance Analysis of a Three-Phase Induction Motor under Mixed Eccentricity Condition , 2002, IEEE Power Engineering Review.

[2]  H.A. Toliyat,et al.  Condition Monitoring and Fault Diagnosis of Electrical Motors—A Review , 2005, IEEE Transactions on Energy Conversion.

[3]  F. Filippetti,et al.  AI techniques in induction machines diagnosis including the speed ripple effect , 1996 .

[4]  L. Eren,et al.  Detecting motor bearing faults , 2004, IEEE Instrumentation & Measurement Magazine.

[5]  H. Henao,et al.  Detection of induction machines rotor faults at standstill using signals injection , 2004, IEEE Transactions on Industry Applications.

[6]  Mohamed El Hachemi Benbouzid A review of induction motors signature analysis as a medium for faults detection , 2000, IEEE Trans. Ind. Electron..

[7]  C. Kral,et al.  Detection of rotor faults in squirrel cage induction machines at standstill for batch tests by means of the Vienna monitoring method , 2000, Conference Record of the 2000 IEEE Industry Applications Conference. Thirty-Fifth IAS Annual Meeting and World Conference on Industrial Applications of Electrical Energy (Cat. No.00CH37129).

[8]  T. G. Habetler,et al.  Stator current harmonics and their causal vibrations: a preliminary investigation of sensorless vibration monitoring applications , 1999 .

[9]  T.G. Habetler,et al.  Motor bearing damage detection using stator current monitoring , 1994, Proceedings of 1994 IEEE Industry Applications Society Annual Meeting.

[10]  David G. Dorrell,et al.  Analysis of airgap flux, current and vibration signals as a function of the combination of static and dynamic airgap eccentricity in 3-phase induction motors , 1995, IAS '95. Conference Record of the 1995 IEEE Industry Applications Conference Thirtieth IAS Annual Meeting.

[11]  G. B. Kliman,et al.  Noninvasive detection of broken rotor bars in operating induction motors , 1988 .

[12]  Hamid A. Toliyat,et al.  Performance analysis of a three phase induction motor under mixed eccentricity condition , 1998, 1998 International Conference on Power Electronic Drives and Energy Systems for Industrial Growth, 1998. Proceedings..