Design of passive mixers utilizing microfluidic self-circulation in the mixing chamber.

This paper proposes the design of a passive micromixer that utilizes the self-circulation of the fluid in the mixing chamber for applications in the Micro Total Analysis Systems (microTAS). The micromixer with a total volume of about 20 microL and consisting of an inlet port, a circular mixing chamber and an outlet port was designed. The device was actuated by a pneumatic pump to induce self-circulation of the fluid. The self-circulation phenomenon in the micromixer was predicted by the computational simulation of the microfluidic dynamics. Flow visualization with fluorescence tracer was used to verify the numerical simulations and indicated that the simulated and the experimental results were in good agreement. Besides, an index for quantifying the mixing performance was employed to compare different situations and to demonstrate the advantages of the self-circulation mixer. The mixing efficiencies in the mixer under different Reynolds numbers (Re) were evaluated numerically. The numerical results revealed that the mixing efficiency of the mixer with self-circulation was 1.7 to 2 times higher than that of the straight channel without a mixing chamber at Re= 150. When Re was as low as 50, the mixing efficiency of the mixer with self-circulation in the mixing chamber was improved approximately 30% higher than that in the straight channel. The results indicated that the self-circulation in the mixer could enhance the mixing even at low Re. The features of simple mixing method and fabrication process make this micromixer ideally suitable for microTAS applications.

[1]  Chun-Ping Jen,et al.  Design and simulation of the micromixer with chaotic advection in twisted microchannels. , 2003, Lab on a chip.

[2]  T. Johnson,et al.  Rapid microfluidic mixing. , 2002, Analytical chemistry.

[3]  Jin-Woo Choi,et al.  A Novel In-Plane Passive Micromixer Using Coanda Effect , 2001 .

[4]  Chun-Ping Jen,et al.  Improved design and experimental demonstration of a bi-directional microfluidic driving system , 2003 .

[5]  P. Tabeling,et al.  Chaotic mixing in electrokinetically and pressure driven micro flows , 2001, Technical Digest. MEMS 2001. 14th IEEE International Conference on Micro Electro Mechanical Systems (Cat. No.01CH37090).

[6]  A. Berg,et al.  Micro Total Analysis Systems , 1995 .

[7]  R. Miyake,et al.  Micro mixer with fast diffusion , 1993, [1993] Proceedings IEEE Micro Electro Mechanical Systems.

[8]  Yu-Cheng Lin,et al.  Design and simulation of bi-directional microfluid driving systems , 2002 .

[9]  V. S. Vaidhyanathan,et al.  Transport phenomena , 2005, Experientia.

[10]  S. Shoji.  Micro Total Analysis Systems , 1999 .

[11]  R.M. White,et al.  Ultrasonically induced microtransport , 1991, [1991] Proceedings. IEEE Micro Electro Mechanical Systems.

[12]  Dorian Liepmann,et al.  PLANAR LAMINAR MIXER , 2000 .

[13]  Mahesh Madhukar Athavale,et al.  Plastic In-Line Chaotic Micromixer for Biological Applications , 2001 .

[14]  Brian N. Johnson,et al.  An integrated nanoliter DNA analysis device. , 1998, Science.

[15]  Asterios Gavriilidis,et al.  Mixing characteristics of T-type microfluidic mixers , 2001 .

[16]  I. Mezić,et al.  Chaotic Mixer for Microchannels , 2002, Science.

[17]  Albert van den Berg,et al.  A Rapid Vortex Micromixer for Studying High-Speed Chemical Reactions , 2001 .

[18]  A. Manz,et al.  Miniaturized total chemical analysis systems: A novel concept for chemical sensing , 1990 .

[19]  Carl D. Meinhart,et al.  An Actively Controlled Micromixer , 1999, Micro-Electro-Mechanical Systems (MEMS).

[20]  Robin H. Liu,et al.  Passive mixing in a three-dimensional serpentine microchannel , 2000, Journal of Microelectromechanical Systems.

[21]  Jens Anders Branebjerg,et al.  Fast mixing by lamination , 1996, Proceedings of Ninth International Workshop on Micro Electromechanical Systems.

[22]  Jens Anders Branebjerg,et al.  Application of Miniature Analyzers: from Microfluidic Components to µTAS , 1995 .