Investigation of a Novel Reciprocating Compression Reformer for Use in Solid Oxide Fuel Cell Systems

A novel reciprocating compression device has been investigated as a non-catalytic natural gas reformer for solid oxide fuel cell systems. The reciprocating compression reformer is a potential improvement over current reforming technology for select applications due to its high degree of heat integration, its homogenous gas phase reaction environment, and its ability to co-produce shaft work. Performance modeling of the system was conducted to understand component integration and operational characteristics. The reformer was modeled by utilizing GRI mech. in tandem with CHEMKIN. The fuel cell was modeled as an equilibrium reactor assuming constant fuel utilization. The effect on the reformer and the reformer – fuel cell system efficiencies and exit gas concentrations was examined over a range of relative air-to-fuel ratios, 0.2 to 1.0, and at compression ratios of 50 and 100. Results from this study indicate that the reformer – fuel cell system could approach 50% efficiency, if run at low relative air-to-fuel ratios (0.3 to 0.5). With higher air-to-fuel ratios, system efficiencies were shown to continuously decline due to a decrease in the quality of synthesis gas provided to the fuel cell (i.e. more power being produced by the reformer). Optimal operation of the system has been shown to occur at a relative air-to-fuel ratio of approximately 0.775 and to be nearly independent of the compression ratio in the reciprocating compression reformer. Higher efficiencies may be obtained at lower relative air-to-fuel ratios; however, operation below this point may lead to excessive carbon formation as determined from an equilibrium carbon formation analysis.Copyright © 2003 by ASME