Machinability investigation with Wiper Ceramic Insert and Optimization during the Hard Turning of AISI 4340 Steel

[1]  L. Mattoso,et al.  Solution blow spinning: parameters optimization and effects on the properties of nanofibers from poly(lactic acid)/dimethyl carbonate solutions , 2016, Journal of Materials Science.

[2]  Doriana M. D’Addona,et al.  Analysis of Surface Roughness in Hard Turning Using Wiper Insert Geometry , 2016 .

[3]  Sounak Kumar Choudhury,et al.  Investigations on machinability aspects of hardened AISI 4340 steel at different levels of hardness using coated carbide tools , 2013 .

[4]  T. R. Mansur,et al.  Development of a three-component dynamometer to measure turning force , 2012 .

[5]  V. N. Gaitonde,et al.  Machinability investigations on hardened AISI 4340 steel using coated carbide insert , 2012 .

[6]  M. Yallese,et al.  Statistical analysis of surface roughness and cutting forces using response surface methodology in hard turning of AISI 52100 bearing steel with CBN tool , 2010 .

[7]  Mehdi Tajdari,et al.  Surface roughness modelling in hard turning operation of AISI 4140 using CBN cutting tool , 2010 .

[8]  D. I. Lalwani,et al.  Experimental investigations of cutting parameters influence on cutting forces and surface roughness in finish hard turning of MDN250 steel , 2008 .

[9]  J. Paulo Davim,et al.  Modelling of surface finish and tool flank wear in turning of AISI D2 steel with ceramic wiper inserts , 2007 .

[10]  W. Grzesik,et al.  Surface finish generated in hard turning of quenched alloy steel parts using conventional and wiper ceramic inserts , 2006 .

[11]  Xiaowen Wang,et al.  Development of Empirical Models for Surface Roughness Prediction in Finish Turning , 2002 .

[12]  Yunn-Shiuan Liao,et al.  Wear characteristics in turning high hardness alloy steel by ceramic and CBN tools , 1999 .

[13]  Woei-Shyan Lee,et al.  Mechanical properties and microstructural features of AISI 4340 high-strength alloy steel under quenched and tempered conditions , 1999 .