Lightning strike evaluation on composite and biocomposite vertical-axis wind turbine blade using structural health monitoring approach

Lightning damages to wind turbine blades increase as the size of wind turbine becomes larger. The damages are quite serious since it contributes to high cost of repairs and loss of electric power production. Since natural plant fibres receive attention nowadays due to low density and high specific strength, the usage of natural fibre to replace synthetic fibre in fabricating the turbine blade will promote a green renewable material. As the application of biocomposite for wind turbine blade has been explored, the effect of lightning strike damage has been required for further test investigation. This article explores the comparative results of performing lightning strike damage testing on composite (fibreglass) and biocomposite (flax fibre) wind turbine blades with protective metal mesh materials. The damage assessments were performed using visual non-destructive inspection methods and piezoelectric sensor as part of structural health monitoring. From the result, it is found that fibreglass blade experienced larger damage area compared to flax fibre blade based on the visual test conducted.

[1]  J. Bréard,et al.  Mechanical Properties of Flax Fibers and of the Derived Unidirectional Composites , 2010 .

[2]  Ian Cotton,et al.  The update of IEC 61400-24 lightning protection of wind turbines , 2008 .

[3]  Changduk Kong,et al.  Investigation on Design for a 500 W Wind Turbine Composite Blade Considering Impact Damage , 2011 .

[4]  Jui-Sheng Chou,et al.  Failure analysis of wind turbine blade under critical wind loads , 2013 .

[5]  Paul J. Hogg,et al.  Resolving Performance Conflicts In New Wind Turbine Blade Designs , 2009 .

[6]  Anindya Ghoshal,et al.  Structural health monitoring techniques for wind turbine blades , 2000 .

[7]  S. Basavarajappa,et al.  Applications of biocomposite materials based on natural fibers from renewable resources: a review , 2016 .

[8]  B. Vijaya Ramnath,et al.  Evaluation of mechanical and thermal properties of banana-flax based natural fibre composite , 2014 .

[9]  Jung-Ryul Lee,et al.  Structural health monitoring for a wind turbine system: a review of damage detection methods , 2008 .

[10]  K Suresh Babu,et al.  THE MATERIAL SELECTION FOR TYPICAL WIND TURBINE BLADES USING A MADM APPROACH& ANALYSIS OF BLADES , 2006 .

[11]  Richard Kithil.  Case Study of Lightning Damage to Wind Turbine Blade , 2008 .

[12]  Libo Yan,et al.  Flax fibre and its composites – A review , 2014 .

[13]  Ian Cotton,et al.  Lightning protection of wind turbines — A comparison of real lightning strike data and finite element lightning attachment analysis , 2009, 2009 International Conference on Sustainable Power Generation and Supply.

[14]  Ahmet Duran Şahin,et al.  Progress and recent trends in wind energy , 2004 .

[15]  Xuefeng Chen,et al.  Quantitative Damage Detection and Sparse Sensor Array Optimization of Carbon Fiber Reinforced Resin Composite Laminates for Wind Turbine Blade Structural Health Monitoring , 2014, Sensors.

[16]  Hongxing Yang,et al.  Introduction: Renewable Energy , 2015 .

[17]  Nicholas Jenkins,et al.  Lightning protection for wind turbine blades and bearings , 2001 .

[18]  Lightning Strike Protection For Composite Structures , 2009 .