论文信息 - Electrical Discharge Machining Flyback Converter using UC3842 Current Mode PWM Controller

Electrical Discharge Machining Flyback Converter using UC3842 Current Mode PWM Controller

This paper presents a current mode Pulse Width Modulation (PWM) controlled Flyback converter using UC3842 for Electrical Discharge Machining current generator control circuit. Circuit simplicity and high efficiency can be achieved by a Flyback converter with current mode PWM controller. The behaviors of the system's operation is analyzed and discussed by varying the load resistance. Matlab software is used to simulate the Flyback converter where a prototype has been built and tested to verify it's performance.

Azli Yahya | Trias Andromeda | Nazriah Mahmud

[1] L.G. Sison,et al. Energy-saving Flyback Converter for EDM Applications , 2005, TENCON 2005 - 2005 IEEE Region 10 Conference.

[2] Biing-Hwa Yan,et al. Machining characteristics of titanium alloy (Ti–6Al–4V) using a combination process of EDM with USM , 2000 .

[3] Milenko Sekulić,et al. Effect of electrical pulse parameters on the machining performance in EDM , 2011 .

[4] M. Çakır,et al. Influence of machining parameters on the surface integrity in small-hole electrical discharge machining , 2014 .

[5] Kumar Sandeep. Current Research Trends in Electrical Discharge Machining: A Review , 2013 .

[6] L.G. Sison,et al. Regenerative clamp as reset winding in flyback converters for EDM applications , 2004, 2004 IEEE International Conference on Industrial Technology, 2004. IEEE ICIT '04..

[7] Che Hassan Che Haron,et al. Investigation on the influence of machining parameters when machining tool steel using EDM , 2001 .

[8] Fan Yang,et al. Fly-Back Mode Constant Current LED Driver , 2014 .