Investigation on steam injection condition in refining vacuum furnace

Abstract As worldwide petroleum reserves evolve toward heavier crude oils, crude distillation units encounter historically high coking risk, and this problem is further exacerbated by cutting deeper into the bottom for higher HVGO yield. In this work, we aimed to optimize the steam injection condition for coking prevention purpose in refining vacuum furnace. A new technology that injecting steam inside the radiant section was proposed and comparison was made with steam injection at the entrance. Variable steam injection location and rate were examined according different operating cases, and the flow patterns in vaporizing tubes and coking tendency curves were present. All the calculations were performed using the commercial software Petro-SIM and the calculation model was validated against on-site data. The criterion was proposed for the optimal steam injection condition. The results showed that steam injection inside the radiant section was superior to the entrance.

[1]  Geoffrey F. Hewitt.  Churn and Wispy Annular Flow Regimes in Vertical Gas–Liquid Flows , 2012 .

[2]  T. W. F. Russell,et al.  Two phase process design , 1979 .

[3]  David F. Fletcher,et al.  Film and slug behaviour in intermittent slug–annular microchannel flows , 2010 .

[4]  Barry J. Azzopardi,et al.  Experimental study of the hydrodynamic behaviour of slug flow in a vertical riser , 2014 .

[5]  Iztok Žun,et al.  Inlet conditions effect on bubble to slug flow transition in mini-channels , 2013 .

[6]  Donald Quentin Kern,et al.  Process heat transfer , 1950 .

[7]  S. Jayanti,et al.  Flow development in vertical annular flow , 2001 .

[8]  Vittorio Ferrari,et al.  Core-annular flow in horizontal and slightly inclined pipes: Existence, pressure drops, and hold-up , 2011 .

[9]  Zhanfeng Cui,et al.  CFD modelling of slug flow in vertical tubes , 2006 .

[10]  A. S. Vianna,et al.  Modeling an annular flow tubular reactor , 2010 .

[11]  J. Thom,et al.  Prediction of pressure drop during forced circulation boiling of water , 1964 .

[12]  E. J. Anthony,et al.  A study of thermal-cracking behavior of asphaltenes , 2003 .

[13]  G. Geraci,et al.  Effect of inclination on circumferential film thickness variation in annular gas/liquid flow , 2007 .

[14]  E. M. Matos,et al.  Predicting coke formation due to thermal cracking inside tubes of petrochemical fired heaters using a fast CFD formulation , 2006 .

[15]  S. Guet,et al.  Void fraction in vertical gas–liquid slug flow: Influence of liquid slug content , 2006 .

[16]  G. Marin,et al.  Simulation of the coking phenomenon in the superheater of a steam cracker , 2014 .

[17]  M. Gray,et al.  Modeling of mass transfer and thermal cracking during the coking of Athabasca residues , 2008 .