Influence of coal bottom ash as fine aggregates replacement on various properties of concretes: A review

Abstract In the current phase, the engineering and construction industry has successfully engaged in a challenge for consuming “sustainable, green and recycled products” in manufacturing of concrete. The utilization of Coal Bottom Ash (CBA) in concrete industry is one of the best feasible options to minimize the environmental concerns raised due to its presence. The use of CBA in manufacturing of concrete has been increased in last decade. Coal bottom ash has a potential to be used as concrete material in place of fine aggregates. The present investigation has focused on reviewing some of the fresh, mechanical and durability properties of Normally Vibrated Concrete (NVC) and Self-Compacting Concrete (SCC) made with incorporation of CBA as replacement of fine aggregates. Most of the studies have described that the use of CBA lowers the overall performance of NVC/SCC, whereas few of them have reported its successful use in attaining similar/better performance to that of the concretes made without incorporation of CBA.

[1]  Rafat Siddique,et al.  Utilization of industrial by-products in concrete , 2014 .

[2]  H. Schoenberger,et al.  Construction and demolition waste best management practice in Europe , 2018, Resources, Conservation and Recycling.

[3]  M. Karim,et al.  Review: Application of coal bottom ash as aggregate replacement in highway embankment, acoustic absorbing wall and asphalt mixtures , 2017 .

[4]  A. Cadersa,et al.  Use of Coal Bottom Ash as Mechanical Stabiliser in Subgrade Soil , 2014 .

[5]  Kosmas K. Sideris,et al.  Durability of normal strength self-compacting concretes and their impact on service life of reinforced concrete structures , 2013 .

[6]  R. Siddique,et al.  Influence of water/powder ratio on strength properties of self-compacting concrete containing coal fly ash and bottom ash , 2012 .

[7]  S. Tangtermsirikul,et al.  Effect of cement types, mineral admixtures, and bottom ash on the curing sensitivity of concrete , 2013, International Journal of Minerals, Metallurgy, and Materials.

[8]  R. Siddique,et al.  Compressive strength, drying shrinkage and chemical resistance of concrete incorporating coal bottom ash as partial or total replacement of sand , 2014 .

[9]  Sanjaya Kumar Patro,et al.  Sustainable use of industrial-waste as partial replacement of fine aggregate for preparation of concrete – A review , 2016 .

[10]  C. Beckett,et al.  Rammed Earth incorporating Recycled Concrete Aggregate: a sustainable, resistant and breathable construction solution , 2018, Resources, Conservation and Recycling.

[11]  Byung Jae Lee,et al.  An experimental study on the hazard assessment and mechanical properties of porous concrete utilizing coal bottom ash coarse aggregate in Korea. , 2009, Journal of hazardous materials.

[12]  R. Siddique,et al.  Design and development of self-compacting concrete made with coal bottom ash , 2015 .

[13]  T. Ramjeawon,et al.  Assessing the durability of coal bottom ash as aggregate replacement in low strength concrete , 2014 .

[14]  R. Siddique,et al.  Effect of coal bottom ash as partial replacement of sand on workability and strength properties of concrete , 2016 .

[15]  Hyeong-Ki Kim.  Utilization of sieved and ground coal bottom ash powders as a coarse binder in high-strength mortar to improve workability , 2015 .

[16]  Shahiron Shahidan,et al.  Physical and Chemical Properties of Coal Bottom Ash (CBA) from Tanjung Bin Power Plant , 2016 .

[17]  João Carlos Marques,et al.  Durability and Strength Properties of Concrete Containing Coal Bottom Ash , 2010 .

[18]  M. Wyrzykowski,et al.  Internal curing of high performance mortars with bottom ash , 2016 .

[19]  Dinesh Kumar,et al.  Study The Effect of Coal Bottom Ash on Partial Replacement of Fine Aggregate in Concrete With Sugarcane Molasses as an Admixture , 2016 .

[20]  S. Tighe,et al.  Influence of recycled concrete aggregate on volumetric properties of hot mix asphalt , 2018 .

[21]  Binu Sukumar,et al.  Permeation Properties of Self – Compacting Concrete using High Volume Fly Ash , 2017 .

[22]  Somnuk Tangtermsirikul,et al.  Properties of Self-Compacting Concrete in Corporating Bottom Ash as a Partial Replacement of Fine Aggregate , 2008 .

[23]  J. Andresen,et al.  Physical cleaning of high carbon fly ash , 2002 .

[24]  Nurul Izzati Raihan Ramzi Hannan,et al.  A Comprehensive Review on the Properties of Coal Bottom Ash in Concrete as Sound Absorption Material , 2017 .

[25]  I. Topcu,et al.  Effect of Bottom Ash as Fine Aggregate on Shrinkage Cracking of Mortars , 2010 .

[26]  Adamah Messan,et al.  Physical and transfer properties of mortar containing coal bottom ash aggregates from Tefereyre (Niger) , 2016 .

[27]  M. Paul,et al.  STRENGTH PERFORMANCE OF CONCRETE USING BOTTOM ASH AS FINE AGGREGATE , 2014 .

[28]  Ramadhansyah Putra Jaya,et al.  Fresh properties and flexural strength of self-compacting concrete integrating coal bottom ash , 2016 .

[29]  İsa Yüksel,et al.  Durability of concrete incorporating non-ground blast furnace slag and bottom ash as fine aggregate , 2007 .

[30]  A. Camões,et al.  Durability Indicators Comparison for SCC and CC in Tropical Coastal Environments , 2015, Materials.

[31]  N. Jamaluddin,et al.  Split Tensile Strength on Self-compacting Concrete Containing Coal Bottom Ash , 2015 .

[32]  Malik Cheriaf,et al.  Influence of coal bottom ash as fine aggregate on fresh properties of concrete , 2009 .

[33]  Avner Vengosh,et al.  Survey of the potential environmental and health impacts in the immediate aftermath of the coal ash spill in Kingston, Tennessee. , 2009, Environmental science & technology.

[34]  N. Makul,et al.  Utilization of coal- and biomass-fired ash in the production of self-consolidating concrete: a literature review , 2015 .

[35]  Rafat Siddique,et al.  COMPRESSIVE STRENGTH, WATER ABSORPTION, SORPTIVITY, ABRASION RESISTANCE, AND PERMEABILITY OF SELF-COMPACTING CONCRETE CONTAINING COAL BOTTOM ASH , 2013 .

[36]  Ramadhansyah Putra Jaya,et al.  Nomograph of self-compacting concrete mix design incorporating coal bottom ash as partial replacement of fine aggregates , 2016 .

[38]  Rafat Siddique,et al.  Strength properties and micro-structural properties of concrete containing coal bottom ash as partial replacement of fine aggregate , 2014 .

[39]  C. Mathiraja.  Mechanical Properties of Concrete using Bottom Ash Manufacturing Sand and Metallic Fibres , 2014 .

[40]  M. H. Wan Ibrahim,et al.  The Effect of Bottom Ash on Fresh Characteristic, Compressive Strength and Water Absorption of Self-Compacting Concrete , 2014 .

[41]  Shang-Lien Lo,et al.  Life-cycle environmental and cost impacts of reusing fly ash , 2017 .

[42]  H. Lee,et al.  Internal-curing efficiency of cold-bonded coal bottom ash aggregate for high-strength mortar , 2016 .

[43]  Turhan Bilir,et al.  Effects of non-ground slag and bottom ash as fine aggregate on concrete permeability properties , 2012 .

[44]  Iman M. Nikbin,et al.  A comprehensive analytical study on the mechanical properties of concrete containing waste bottom ash as natural aggregate replacement , 2016 .

[45]  Ali R. Pouladkhan,et al.  Mechanical, rheological, durability and microstructural properties of high performance self-compacting concrete containing SiO2 micro and nanoparticles , 2012 .

[46]  Imad L. Al-Qadi,et al.  Environmental and economic analyses of recycled asphalt concrete mixtures based on material production and potential performance , 2015 .

[47]  Aswathy P.U.  Behaviour of Self Compacting Concrete by Partial Replacement of Fine Aggregate with Coal Bottom Ash , 2015 .

[48]  Rafat Siddique,et al.  Mechanical and durability properties of self-compacting concrete containing fly ash and bottom ash , 2012 .

[49]  H. Lee,et al.  Use of power plant bottom ash as fine and coarse aggregates in high-strength concrete , 2011 .

[50]  R. Siddique,et al.  Effect of coal bottom ash as partial replacement of sand on properties of concrete , 2013 .

[51]  R. Siddique,et al.  Microstructure and properties of concrete using bottom ash and waste foundry sand as partial replacement of fine aggregates , 2014 .

[52]  Hyeong-Ki Kim,et al.  Coal bottom ash in field of civil engineering: A review of advanced applications and environmental considerations , 2015 .

[53]  N. Ghafoori,et al.  LABORATORY-MADE ROLLER COMPACTED CONCRETES CONTAINING DRY BOTTOM ASH: PART II--LONG-TERM DURABILITY , 1998 .

[54]  L. Silva,et al.  Nanominerals and nanoparticles in feed coal and bottom ash: implications for human health effects , 2011, Environmental monitoring and assessment.

[55]  M. Sani,et al.  The Properties of Special Concrete Using Washed Bottom Ash (WBA) as Partial Sand Replacement , 2010 .

[56]  A. Annachhatre,et al.  Reuse options for coal fired power plant bottom ash and fly ash , 2014, Reviews in Environmental Science and Bio/Technology.

[57]  Laurent Barcelo,et al.  Autogenous shrinkage of concrete: a balance between autogenous swelling and self-desiccation , 2005 .

[58]  N. Ghafoori,et al.  Investigation of lignite-based bottom ash for structural concrete , 1996 .

[59]  M. Salim,et al.  Investigation of coal bottom ash and fly ash in concrete as replacement for sand and cement , 2016 .