Effect of aspect ratio on the recirculation region of 35° Ahmed body

This paper reports a numerical investigation of the effect of aspect ratio (AR) on the flow structure around the 35° Ahmed body. The AR is defined as the ratio of length to the height of the model....

[1]  Sai Cheong Fok,et al.  Comparative Analysis of Turbulence Models for Automotive Aerodynamic Simulation and Design , 2019, International Journal of Automotive Technology.

[2]  Mesbah Uddin,et al.  Turbulence Modeling Effects on the CFD Predictions of Flow over a Detailed Full-Scale Sedan Vehicle , 2019, Fluids.

[3]  M. Salvetti,et al.  Separation delay through contoured transverse grooves on a 2D boat-tailed bluff body: Effects on drag reduction and wake flow features , 2019, European Journal of Mechanics - B/Fluids.

[4]  G. Romano,et al.  Investigation on the effect of horizontal and vertical deflectors on the near-wake of a square-back car model , 2019, Journal of Wind Engineering and Industrial Aerodynamics.

[5]  G. Devaradjane,et al.  Investigation on Aerodynamic Behaviour of a SUV Car Model with Vortex Generators at Different Yaw Conditions , 2019, Journal of Applied Fluid Mechanics.

[6]  M. Passmore,et al.  Low-frequency wake dynamics for a square-back vehicle with side trailing edge tapers , 2019, Journal of Wind Engineering and Industrial Aerodynamics.

[7]  A. Mariotti.  Axisymmetric bodies with fixed and free separation: Base-pressure and near-wake fluctuations , 2018 .

[8]  M. Salvetti,et al.  Separation control and drag reduction for boat-tailed axisymmetric bodies through contoured transverse grooves , 2017, Journal of Fluid Mechanics.

[9]  Jie Tian,et al.  Aerodynamic drag reduction and flow control of Ahmed body with flaps , 2017 .

[10]  G. Du.  Theoretical and Numerical Calculation on the Added Mass of Ahmed Body , 2017 .

[11]  Naresh Kumar,et al.  Recommendations on statistics and benchmarks to assess photochemical model performance , 2017, Journal of the Air & Waste Management Association.

[12]  John Sheridan,et al.  The nature of the vortical structures in the near wake of the Ahmed body , 2017 .

[13]  L. Parras,et al.  Experimental study on Ahmed's body drag coefficient for different yaw angles , 2016 .

[14]  T. Barber,et al.  The aerodynamic effects on a cornering Ahmed body , 2016 .

[15]  Alistair Revell,et al.  Assessment of RANS and DES methods for realistic automotive models , 2016 .

[16]  Bernd R. Noack,et al.  Bluff body drag manipulation using pulsed jets and Coanda effect , 2015, Journal of Fluid Mechanics.

[17]  Emmanuel Guilmineau,et al.  ASSESSMENT OF RANS AND DES METHODS FOR THE AHMED BODY , 2016 .

[18]  Matt Corallo,et al.  Effect of aspect ratio on the near-wake flow structure of an Ahmed body , 2015 .

[19]  S. To,et al.  Unsteady flow structures around a high-drag Ahmed body , 2015, Journal of Fluid Mechanics.

[20]  M. Thompson,et al.  The effect of aspect ratio on the wake of the Ahmed body , 2015 .

[21]  Connection between base drag, separating boundary layer characteristics and wake mean recirculation length of an axisymmetric blunt-based body , 2015 .

[22]  Hyungmin Park,et al.  Aerodynamics of Heavy Vehicles , 2014 .

[23]  A. Mariotti,et al.  Experimental investigation on the influence of boundary layer thickness on the base pressure and near-wake flow features of an axisymmetric blunt-based body , 2013 .

[24]  Agnes L. Bodor,et al.  PIV measurement of the flow past a generic car body with wheels at LES applicable Reynolds number , 2013 .

[25]  Jochen Fröhlich,et al.  On simulating the turbulent flow around the Ahmed body: A French–German collaborative evaluation of LES and DES , 2013 .

[26]  Michel Visonneau,et al.  Cross wind effects on a simplified car model by a DES approach , 2013 .

[27]  Emmanuel Guilmineau,et al.  Numerical simulation with a DES approach for automotive flows , 2011 .

[28]  Philippe Planquart,et al.  Experimental aerodynamic study of a car-type bluff body , 2011 .

[29]  Anton Fuchs,et al.  Experiments and numerical simulations on the aerodynamics of the Ahmed body , 2011 .

[30]  Florian R. Menter,et al.  Review of the shear-stress transport turbulence model experience from an industrial perspective , 2009 .

[31]  Emmanuel Guilmineau,et al.  Effect of Side Wind on a Simplified Car Model: Experimental and Numerical Analysis , 2009 .

[32]  F. Thiele,et al.  Numerical Study of the Controlled Flow Around a Tandem Ahmed Body Configuration , 2009 .

[33]  Emmanuel Guilmineau,et al.  Computational study of flow around a simplified car body , 2008 .

[34]  Iraj Mortazavi,et al.  Passive Control Around the Two-Dimensional Square Back Ahmed Body Using Porous Devices , 2008 .

[35]  Fabien Anselmet,et al.  Thorough analysis of vortical structures in the flow around a yawed bluff body , 2008 .

[36]  F. Menter,et al.  Development and Application of SST-SAS Turbulence Model in the DESIDER Project , 2008 .

[37]  Kevin Knowles,et al.  A CFD and Experimental Study of an Ahmed Reference Model , 2004 .

[38]  Manuel García-Villalba,et al.  Large eddy simulation of flow around the Ahmed body , 2004 .

[39]  Jack Snoeyink,et al.  Path Seeds and Flexible Isosurfaces - Using Topology for Exploratory Visualization , 2003, VisSym.

[40]  Stefan Becker,et al.  Flow and Turbulence Structures in the Wake of a Simplified Car Model (Ahmed Modell) , 2002 .

[41]  Sung-Eun Kim,et al.  Advances in External-Aero Simulation of Ground Vehicles Using the Steady RANS Equations , 2000 .

[42]  Y. Dubief,et al.  On coherent-vortex identification in turbulence , 2000 .

[43]  John Allen.  Global energy issues affecting aeronautics: a reasoned conjecture , 1999 .

[44]  Robert Ranzenbach,et al.  Rectangular Bodies with Radiused Edges in Ground Effect , 1999 .

[45]  Robert Ranzenbach,et al.  Experimental Study of CD Variation With Aspect Ratio , 1999 .

[46]  Sanjay R. Mathur,et al.  A Reynolds-averaged Navier-Stokes solver using unstructured mesh-based finite-volume scheme , 1998 .

[47]  Jinhee Jeong,et al.  On the identification of a vortex , 1995, Journal of Fluid Mechanics.

[48]  F. Menter.  Two-equation eddy-viscosity turbulence models for engineering applications , 1994 .

[49]  T. Han,et al.  Computational analysis of three-dimensional turbulent flow around a bluff body in ground proximity , 1988 .

[50]  Gunther Ramm,et al.  Some salient features of the time - averaged ground vehicle wake , 1984 .

[51]  S. R. Ahmed.  Influence of Base Slant on the Wake Structure and Drag of Road Vehicles , 1983 .

[52]  Issawi.  1973 oil crisis and after , 1978 .