Human vertebral cancellous bone surface distribution.

The three-dimensional distribution of bone surface and the bone volume fraction (BV/TV) of 110 human vertebral cancellous bone specimens from seven individuals were measured using a three-dimensional radiographic method (microcomputed tomography). The ratios of the three principal projections of bone surface per total volume were found to be relatively constant for specimens examined in this study. The constancy of the projected surface ratios means that the fraction of the total bone surface oriented in any direction does not change markedly with BV/TV. Bone volume fraction was a good predictor of bone surface per total volume (BS/TV) for a one-parameter nonlinear model (r2 = 0.92). The results of this pilot study suggest that the changes in surface distribution which occur during age-related bone loss are largely predetermined rather than adaptive. The results are also consistent with the idea that cancellous bone tends to maintain a constant ratio of trabecular number for the principal directions. If these inferences from the data are correct, the morphogenetic processes which create the initial adult trabecular pattern become of primary interest. A model was developed which explained the strong relationship between BS/TV and BV/TV. The model was used to demonstrate the importance of morphogenetic processes.

[1]  H J Gundersen,et al.  Estimation of structural anisotropy based on volume orientation. A new concept , 1990, Journal of microscopy.

[2]  S A Goldstein,et al.  The relationship between the structural and orthogonal compressive properties of trabecular bone. , 1994, Journal of biomechanics.

[3]  W. J. Whitehouse.  The quantitative morphology of anisotropic trabecular bone , 1974, Journal of microscopy.

[4]  R M Rose,et al.  A structural model for the mechanical behavior of trabecular bone. , 1973, Journal of biomechanics.

[5]  H. Gray.  Gray's Anatomy , 1858 .

[6]  David P. Fyhrie,et al.  The development of microstructure in cancellous bone , 1993 .

[7]  D P Fyhrie,et al.  Failure mechanisms in human vertebral cancellous bone. , 1994, Bone.

[8]  S. Goldstein,et al.  Evaluation of a microcomputed tomography system to study trabecular bone structure , 1990, Journal of orthopaedic research : official publication of the Orthopaedic Research Society.

[9]  Martin Rb.  Porosity and specific surface of bone. , 1984 .

[10]  L. Mosekilde,et al.  Consequences of the remodelling process for vertebral trabecular bone structure: a scanning electron microscopy study (uncoupling of unloaded structures). , 1990, Bone and mineral.

[11]  N L Fazzalari,et al.  Mathematical modelling of trabecular bone structure: the evaluation of analytical and quantified surface to volume relationships in the femoral head and iliac crest. , 1989, Journal of biomechanics.

[12]  N L Fazzalari,et al.  Direct calculation of the surface-to-volume ratio for human cancellous bone. , 1993, Journal of biomechanics.

[13]  M. Kleerekoper,et al.  Relationships between surface, volume, and thickness of iliac trabecular bone in aging and in osteoporosis. Implications for the microanatomic and cellular mechanisms of bone loss. , 1983, The Journal of clinical investigation.

[14]  H. Frost.  An introduction to biomechanics , 1967 .

[15]  D. Carter,et al.  A unifying principle relating stress to trabecular bone morphology , 1986, Journal of orthopaedic research : official publication of the Orthopaedic Research Society.

[16]  S. Goldstein,et al.  The direct examination of three‐dimensional bone architecture in vitro by computed tomography , 1989, Journal of bone and mineral research : the official journal of the American Society for Bone and Mineral Research.