Motion control of electric vehicles and prospects of supercapacitors

Novel motion control techniques for electric vehicles (EVs) on the basis of the quick torque generation in these vehicles have been developed at the Hori Laboratory. Because EVs are powered by electric motors, they have three major advantages: (i) motor torque generation is quick and accurate, (ii) a motor can be attached to each wheel, and (iii) motor torque can be estimated precisely. These advantages enable us to (i) easily realize high-performance antilock braking systems and traction control systems with minor feedback control of each wheel, (ii) control chassis motion, for example, direct yaw control, and (iii) estimate road surface condition. We have developed test vehicles and confirmed the effectiveness of the proposed methods. Recently, we have manufactured small EVs that are powered only by supercapacitors. Supercapacitors have long operating life, large current density, and are environmental friendly. Furthermore, their energy level can be estimated from their terminal voltage. Because EVs powered by supercapacitors can run for more than 20 min by charging only for 30 s, recharging EVs will not be a major problem. In the future, EVs will be recharged via contactless power transfer. Copyright © 2009 Institute of Electrical Engineers of Japan. Published by John Wiley & Sons, Inc.

[1]  Masao Nagai,et al.  Yaw-moment control of electric vehicle for improving handling and stability , 2001 .

[2]  Jürgen Ackermann,et al.  Yaw disturbance attenuation by robust decoupling of car steering , 1996 .

[3]  Li Zhao,et al.  Realtime SMART Speed Pattern Generator for EVs taking account of Driver’s Command Change , 2007 .

[4]  H. Fujimoto,et al.  Traction Control based on Slip Ratio Estimation Without Detecting Vehicle Speed for Electric Vehicle , 2007, 2007 Power Conversion Conference - Nagoya.

[5]  Fredrik Gustafsson,et al.  Slip-based tire-road friction estimation , 1997, Autom..

[6]  Uwe Kiencke,et al.  Estimation of Tyre Slip during combined Cornering and Braking Observer Supported Fuzzy Estimation , 1996 .

[7]  Y. Hori,et al.  Experimental demonstration of body slip angle control based on a novel linear observer for electric vehicle , 2005, 31st Annual Conference of IEEE Industrial Electronics Society, 2005. IECON 2005..

[8]  Yoichi Hori,et al.  Traction control of electric vehicle: basic experimental results using the test EV "UOT electric march" , 1998 .

[9]  Yoshimi Furukawa,et al.  Direct Yaw Moment Control with Estimating Side-Slip Angle by Using On-Board-Tire-Model , 1998 .

[10]  Yutaka Hori,et al.  Implementation of advanced adhesion control for electric vehicle , 1996, Proceedings of 4th IEEE International Workshop on Advanced Motion Control - AMC '96 - MIE.

[11]  Yoichi Hori,et al.  ADVANCED VEHICLE MOTION CONTROL OF ELECTRIC VEHICLE BASED ON THE FAST MOTOR TORQUE RESPONSE , 2000 .

[12]  M. Soljačić,et al.  Wireless Power Transfer via Strongly Coupled Magnetic Resonances , 2007, Science.

[13]  Y. Hori,et al.  Anti-skid control for EV using dynamic model error based on back-EMF observer , 2004, 30th Annual Conference of IEEE Industrial Electronics Society, 2004. IECON 2004.

[14]  Kazuhiko Shimada,et al.  IMPROVEMENT OF VEHICLE MANEUVERABILITY BY DIRECT YAW MOMENT CONTROL. , 1992 .

[15]  Yoichi Hori.  Future vehicle driven by electricity and control-research on four wheel motored "UOT Electric March II" , 2002, 7th International Workshop on Advanced Motion Control. Proceedings (Cat. No.02TH8623).

[16]  Yoichi Hori,et al.  Normal Force Stabilizing Control Using Small EV Powered only by Electric Double Layer Capacitor , 2008 .

[17]  Yoichi Hori,et al.  Traction control of electric vehicle based on the estimation of road surface condition-basic experimental results using the test EV "UOT Electric March" , 1997, Proceedings of Power Conversion Conference - PCC '97.

[18]  Yoichi Hori,et al.  Application of Advanced Motion Control Techniques and the Prospect of Super Capacitors in Electric Vehicles , 2006 .

[19]  Huei Peng,et al.  Road Friction Coefficient Estimation For Vehicle Path Prediction , 1996 .

[20]  Yoichi Hori,et al.  Improvement of EV Maneuverability and Safety by Dynamic Force Distribution with Disturbance Observer , 2007 .

[21]  Masao Nagai,et al.  Integrated control of four-wheel-steer and yaw moment to improve dynamic stability margin , 1996, Proceedings of 35th IEEE Conference on Decision and Control.

[22]  Shin-ichiro Sakai,et al.  Motion control in an electric vehicle with four independently driven in-wheel motors , 1999 .

[23]  Y. Hori,et al.  Robustified model matching control for motion control of electric vehicle , 1998, AMC'98 - Coimbra. 1998 5th International Workshop on Advanced Motion Control. Proceedings (Cat. No.98TH8354).

[24]  Y. Hori,et al.  Design of a simulator of one-wheel EV system for testing of slip-prevention controller , 2004, 30th Annual Conference of IEEE Industrial Electronics Society, 2004. IECON 2004.

[25]  Yoichi Hori,et al.  Nonlinear Body Slip Angle Observer for Electric Vehicle Stability Control , 2008 .