Development of commercial CMOS process-based technologies for the fabrication of smart accelerometers

A process for the monolithic integration of micromechanical structures into a 3- mu m standard CMOS process has been developed. Anisotropic wet etching of silicon using the p/sup +/-etchstop technique on high boron doped epitaxial layers as well as the electrochemical etchstop technique at pn-junctions was combined with the IC process. Piezoresistive accelerometers with a monolithically integrated operational amplifier were fabricated. Measurements on the devices produced with the p/sup +/-etchstop technique showed mechanical stress problems and shifts in the electronic device parameters. In contrast, no influence on mechanical and electronic properties of the devices fabricated with the pn-junction etchstop technique was found. Smart accelerometers with electronic device parameters comparable to the standard CMOS process were successfully realized.<<ETX>>

[1]  H. Reichl,et al.  Frequency-analog sensors using the I2L technique , 1983 .

[2]  U. Schnakenberg,et al.  TMAHW etchants for silicon micromachining , 1991, TRANSDUCERS '91: 1991 International Conference on Solid-State Sensors and Actuators. Digest of Technical Papers.

[3]  U. Schnakenberg,et al.  Multi electron beam lithography: Fabrication of a control unit , 1989 .

[4]  U. Schnakenberg,et al.  Miniaturized Accelerometers Based on Silicon Micromachining Techniques , 1989, ESSDERC '89: 19th European Solid State Device Research Conference.

[5]  Henry Baltes,et al.  Design and Simulation of Sensors , 1990 .

[6]  S. Middelhoek,et al.  Smart sensors: when and where? , 1985 .

[7]  J. Meindl,et al.  A monolithic capacitive pressure sensor with pulse-period output , 1980, 1980 IEEE International Solid-State Circuits Conference. Digest of Technical Papers.

[8]  H.-J. Kress,et al.  Fully Integrated Silicon Pressure Sensor with On-Chip CMOS Evaluation Circuit and On-Chip Trimming , 1990 .

[9]  S. Ansermet,et al.  Cooperative development of a piezoresistive pressure sensor with integrated signal conditioning for automotive and industrial applications , 1990 .

[10]  W. von Münch,et al.  A silicon pressure sensor using mos ring oscillators , 1985 .

[11]  W. Riethmueller.  Micromachined Silicon Devices Integrated with Standard IC Processes , 1990 .

[12]  R. Schörner,et al.  Silicon pressure sensor with frequency output , 1990 .

[13]  L. Csepregi.  Micromechanics: a silicon microfabrication technology , 1985 .

[14]  Isemi Igarashi.  New technology of sensors for automotive applications , 1986 .

[15]  K.E. Petersen,et al.  Micromechanical accelerometer integrated with MOS detection circuitry , 1982, IEEE Transactions on Electron Devices.

[16]  W. Benecke,et al.  NH4OH-based etchants for silicon micromachining: Influence of additives and stability of passivation layers , 1990 .