Influence of Blade Leading Edge Geometry on Turbine Endwall Heat (Mass) Transfer

The secondary flows, including passage and other vortices in a turbine cascade, cause significant aerodynamic losses and thermal gradients. Leading edge modification of the blade has drawn considerable attention as it has been shown to reduce the secondary flows. However, the heat transfer performance of a leading edge modified blade has not been investigated thoroughly. Since a fillet at the leading edge blade is reported to reduce the aerodynamic loss significantly, the naphthalene sublimation technique with a fillet geometry is used to study local heat (mass) transfer performance in a simulated turbine cascade. The present paper compares Sherwood number distributions on an endwall with a simple blade and a similar blade having a modified leading edge by adding a fillet. With the modified blades, a horseshoe vortex is not observed and the passage vortex is delayed or not observed for different turbulence intensities. However, near the blade trailing edge the passage vortex has gained as much strength as with the simple blade for low turbulence intensity. Near the leading edge on the pressure and the suction surface, higher mass transfer regions are observed with the fillets. Apparently the corner vortices are intensified with the leading edge modified blade.

[1]  Y.-L. Lin,et al.  Controlling Secondary-Flow Structure by Leading-Edge Airfoil Fillet and Inlet Swirl to Reduce Aerodynamic Loss and Surface Heat Transfer , 2002 .

[2]  T. I-P. Shih,et al.  Controlling Secondary-Flow Structure by Leading-Edge Airfoil Fillet and Inlet Swirl to Reduce Aerodynamic Loss and Surface Heat Transfer , 2003 .

[3]  Sandor Becz,et al.  An Experimental Investigation of Contoured Leading Edges for Secondary Flow Loss Reduction , 2004 .

[4]  Terrence W. Simon,et al.  Flow measurements in a nozzle guide vane passage with a low aspect ratio and endwall contouring , 2000 .

[5]  Andrew T. Lethander,et al.  Optimizing the Vane-Endwall Junction to Reduce Adiabatic Wall Temperatures in a Turbine Vane Passage , 2003 .

[6]  D. Ambrose,et al.  The vapour pressure of naphthalene , 1975 .

[7]  Chao-Ho Sung,et al.  Numerical investigation on the effect of fairing on the vortex flowsaround airfoil/flat-plate junctures , 1988 .

[8]  Thomas F. Irvine,et al.  Measurement of the diffusion coefficient of naphthalene into air , 1992 .

[9]  R. Goldstein,et al.  Turbulent Transport on the Endwall in the Region Between Adjacent Turbine Blades , 1987 .

[10]  R. J. Goldstein,et al.  A review of mass transfer measurements using naphthalene sublimation , 1995 .

[11]  R. J. Goldstein,et al.  Effect of High Freestream Turbulence With Large Length Scale on Blade Heat/Mass Transfer , 1998 .

[12]  Karen A. Thole,et al.  Computational Design and Experimental Evaluation of Using a Leading Edge Fillet on a Gas Turbine Vane , 2001 .

[13]  Hugh W. Coleman,et al.  Experimentation and Uncertainty Analysis for Engineers , 1989 .

[14]  Richard J Goldstein,et al.  Flow visualization in a linear turbine cascade of high performance turbine blades , 1995 .

[15]  Konrad Vogeler,et al.  Reduction of secondary flow losses in turbine cascades by leading edge modifications at the endwall , 2001 .

[16]  Lee S. Langston,et al.  Leading Edge Modification Effects on Turbine Cascade Endwall Loss , 2003 .