2-D Micromachined Thermal Wind Sensors—A Review

This paper presents an overview and development of 2-D micromachined thermal wind sensors. It first compares different types of wind sensors, then gives a brief introduction to three basic measurement principles of the thermal wind sensors: hot-wire or hot-film, calorimetric, and time of flight. In order to have a good understanding of development of the 2-D micromachined thermal wind sensors, they are first categorized into thermoresistive, thermoelectric, and thermoelectronic wind sensors based on their operations. Then, each category is further divided into different subcategories, according to their measuring principles and sensor configurations. In Section IV, different materials, fabrication processes, packaging techniques, and control modes of the 2-D micromachined thermal wind sensors are analyzed. This paper also evaluates the core technologies on how to improve the sensitivity, measurement range, and power consumption of the thermal wind sensors.

[1]  David V. Thiel,et al.  MEMS wind direction detection: from design to operation , 2003, Proceedings of IEEE Sensors 2003 (IEEE Cat. No.03CH37498).

[2]  Sekwang Park,et al.  Measurement of flow direction and velocity using a micromachined flow sensor , 2004 .

[3]  Kofi A. A. Makinwa,et al.  Constant power operation of a two-dimensional flow sensor using thermal sigma-delta modulation techniques , 2001, IMTC 2001. Proceedings of the 18th IEEE Instrumentation and Measurement Technology Conference. Rediscovering Measurement in the Age of Informatics (Cat. No.01CH 37188).

[4]  W. S. Reid,et al.  Description and performance testing of a low friction, twin-propeller anemometer with wind vane , 1986 .

[5]  Ming Qin,et al.  Novel micromachined thermal anemometer based on lateral polysilicon diode flow sensor , 2001, Other Conferences.

[6]  H. Ruser.  Smart robust wind sensor using a simple optimization procedure , 2005, IEEE Sensors, 2005..

[7]  Walter Lang,et al.  A high-temperature thermopile fabrication process for thermal flow sensors , 2006 .

[8]  Ming Qin,et al.  A system-level model for a silicon thermal flow sensor , 2008 .

[9]  A. Nassiopoulou,et al.  A smart flow measurement system for flow evaluation with multiple signals in different operation modes , 2007 .

[10]  J. Y. Sim,et al.  Integrated Multifunctional Environmental Sensors , 2013, Journal of Microelectromechanical Systems.

[11]  R. Zhu,et al.  A Low-Cost Flexible Hot-Film Sensor System for Flow Sensing and its Application to Aircraft , 2009, 2009 IEEE 22nd International Conference on Micro Electro Mechanical Systems.

[12]  Kofi A. A. Makinwa,et al.  Industrial design of a solid-state wind sensor , 2001, SIcon/01. Sensors for Industry Conference. Proceedings of the First ISA/IEEE. Sensors for Industry Conference (Cat. No.01EX459).

[13]  Henry Baltes,et al.  Two-dimensional integrated gas flow sensors by CMOS IC technology , 1995 .

[14]  Takeshi Ohkuma,et al.  Full scale measurements of wind velocity in two urban areas using an ultrasonic anemometer , 1992 .

[15]  Pasqualina M. Sarro,et al.  Thermal sensors based on the seebeck effect , 1986 .

[16]  Kofi A. A. Makinwa,et al.  A Solid-State 2-D Wind Sensor , 2006, SAMOS.

[17]  Anton F. P. van Putten,et al.  Silicon thermal anemometry : developments and applications , 1996 .

[18]  Michael Hatzakis,et al.  Single-Step Optical Lift-Off Process , 1980, IBM J. Res. Dev..

[19]  Jun Ho Jeong,et al.  Fabrication of nano-sized metal patterns on flexible polyethylene-terephthalate substrate using bi-layer nanoimprint lithography , 2009 .

[20]  Ming Qin,et al.  A self-packaged thermal flow sensor by CMOS MEMS technology , 2004, Proceedings. 7th International Conference on Solid-State and Integrated Circuits Technology, 2004..

[21]  R. M. Halverson,et al.  The mechanism of single-step liftoff with chlorobenzene in a diazo-type resist , 1982 .

[22]  A.F.P. van Putten,et al.  An integrated silicon anemometer , 1974 .

[23]  Kofi A. A. Makinwa,et al.  A smart wind sensor using thermal sigma-delta modulation techniques , 2002 .

[24]  Rex Klopfenstein,et al.  Air velocity and flow measurement using a Pitot tube , 1998 .

[25]  A.F.P. van Putten,et al.  An integrated silicon double bridge anemometer , 1983 .

[26]  John V. Ringwood,et al.  Evaluation of a prototype thermal anemometer for use in low airspeed drying measure calculations , 2002 .

[27]  Ming Qin,et al.  A FCOB packaged thermal wind sensor with compensation , 2010 .

[28]  J.H. Huijsing,et al.  A 2nd order thermal sigma-delta modulator for flow sensing , 2005, Italian National Conference on Sensors.

[29]  J. Engel,et al.  Two-Dimensional Micromachined Flow Sensor Array for Fluid Mechanics Studies , 2003 .

[30]  Kofi A. A. Makinwa,et al.  A 50mW CMOS wind sensor with ±4% speed and ±2° direction error , 2011, 2011 IEEE International Solid-State Circuits Conference.

[31]  F. Kohl,et al.  Highly Sensitive Sensor for Flow Velocity and Flow Direction Measurement , 2006, 2006 5th IEEE Conference on Sensors.

[32]  Jack Chen,et al.  Development and characterization of surface micromachined, out-of-plane hot-wire anemometer , 2003 .

[33]  P. Bruschi,et al.  A Low-Power 2-D Wind Sensor Based on Integrated Flow Meters , 2009, IEEE Sensors Journal.

[34]  Sun Lining,et al.  The fabrication of array wind speed and direction sensor based on Pt film , 2011, Proceedings of 2011 6th International Forum on Strategic Technology.

[35]  Henry Baltes,et al.  A high sensitivity CMOS gas flow sensor on a thin dielectric membrane , 1993 .

[36]  Takahiro Matsuo,et al.  Improved bi-layer lift-off process for MEMS applications , 2008 .

[37]  W. Lang,et al.  Thermoelectric flow sensors on flexible substrates and their integration process , 2010, 2010 IEEE Sensors.

[38]  Nam-Trung Nguyen,et al.  A novel wind sensor concept based on thermal image measurement using a temperature sensor array , 2004 .

[39]  G. Stemme,et al.  Three dimensional silicon triple-hot-wire anemometer based on polyimide joints , 1998, Proceedings MEMS 98. IEEE. Eleventh Annual International Workshop on Micro Electro Mechanical Systems. An Investigation of Micro Structures, Sensors, Actuators, Machines and Systems (Cat. No.98CH36176.

[40]  Jianmin Miao,et al.  High Sensitivity, Miniature, Full 2-D Anemometer Based on MEMS Hot-Film Sensors , 2013, IEEE Sensors Journal.

[41]  Miko Elwenspoek,et al.  Thermal flow micro sensors , 1999, CAS '99 Proceedings. 1999 International Semiconductor Conference (Cat. No.99TH8389).

[42]  Shufeng Sun,et al.  Conditioning strategies of indoor thermal environment in warm climates , 2004 .

[43]  Nam-Trung Nguyen,et al.  Micromachined flow sensors—a review , 1997, Flow Measurement and Instrumentation.

[44]  Lennart Löfdahl,et al.  Silicon based flow sensors used for mean velocity and turbulence measurements , 1992 .

[45]  O. Brand,et al.  Micromachined thermally based CMOS microsensors , 1998, Proc. IEEE.

[46]  Kofi A. A. Makinwa,et al.  A wind-sensor with integrated interface electronics , 2001, ISCAS 2001. The 2001 IEEE International Symposium on Circuits and Systems (Cat. No.01CH37196).

[47]  Ming Qin,et al.  Thermal asymmetry compensation of a wind sensor fabricated on ceramic substrate , 2010, 2010 IEEE Sensors.

[48]  Péter Fürjes,et al.  Thermal characterisation of a direction dependent flow sensor , 2004 .

[49]  Nam-Trung Nguyen.  A novel thermal sensor concept for flow direction and flow velocity , 2005, IEEE Sensors Journal.

[50]  Euisik Yoon,et al.  An integrated mass flow sensor with on-chip CMOS interface circuitry , 1992 .

[51]  O. Paul,et al.  Single-chip CMOS anemometer , 1997, International Electron Devices Meeting. IEDM Technical Digest.

[52]  Kofi A. A. Makinwa,et al.  Flow sensing with thermal sigma-delta modulators , 2004 .

[53]  Ming Qin,et al.  A novel 2-D wind sensor with thermal feedback , 2008, 2008 9th International Conference on Solid-State and Integrated-Circuit Technology.

[54]  G. P. Shen,et al.  An intelligent wind sensor system with auto-zero function , 2009, TRANSDUCERS 2009 - 2009 International Solid-State Sensors, Actuators and Microsystems Conference.

[55]  X.M. Jing,et al.  An aerodynamically efficient sphere anemometer with integrated hot-film sensors for 2-D environmental airflow monitoring , 2011, 2011 16th International Solid-State Sensors, Actuators and Microsystems Conference.

[56]  D.V. Thiel,et al.  Self Heated Thermo-Resistive Element Hot Wire Anemometer , 2010, IEEE Sensors Journal.

[57]  Mark E. Westgate,et al.  Lagrangian numerical simulations of canopy air flow effects on maize pollen dispersal , 2007 .

[58]  D. Aylor,et al.  The Role of Intermittent Wind in the Dispersal of Fungal Pathogens , 1990 .

[59]  Pasqualina M. Sarro,et al.  Integrated thermopile sensors , 1990 .

[60]  Ming Qin,et al.  An intelligent flow sensor system with zero drift self calibration function , 2009, 2009 IEEE 3rd International Conference on Nano/Molecular Medicine and Engineering.

[61]  Ellis Meng,et al.  Micromachined Thermal Flow Sensors - A Review , 2012, Micromachines.

[62]  B. W. Oudheusden,et al.  Silicon thermal flow sensor with a two-dimensional direction sensitivity , 1990 .

[63]  B. W. Oudheusden,et al.  Silicon flow sensors , 1988 .

[64]  Ming Qin,et al.  A Cross-Type Thermal Wind Sensor With Self-Testing Function , 2010, IEEE Sensors Journal.

[65]  Ming Qin,et al.  A hot film wind sensor with four Constant Temperature Difference elements fabricated on ceramic substrate , 2011, 2011 IEEE SENSORS Proceedings.

[66]  F. E. Terman,et al.  Integrated Electronics: Analog and Digital Circuits and Systems , 1972 .

[67]  Kofi A. A. Makinwa,et al.  A wind-sensor interface using thermal sigma delta modulation techniques , 2001 .

[68]  Ming Qin,et al.  Wafer level packaging based on AU-AU bonding for a CMOS compatible thermal wind sensor , 2011, 2011 16th International Solid-State Sensors, Actuators and Microsystems Conference.

[69]  W. Sansen,et al.  Electrochemical time of flight flow sensor , 2002 .

[70]  Ming Qin,et al.  Flip-Chip Packaging for a Two-Dimensional Thermal Flow Sensor Using a Copper Pillar Bump Technology , 2007, IEEE Sensors Journal.

[71]  Youngcheol Chae,et al.  A 25mW CMOS sensor for wind and temperature measurement , 2011, 2011 IEEE SENSORS Proceedings.

[72]  Torbjorn Thiringer,et al.  Modeling of Wind Turbines for Power System Studies , 2002, IEEE Power Engineering Review.

[73]  Chia-Yen Lee,et al.  MEMS-based gas flow sensors , 2009 .

[74]  Gerald Urban,et al.  A 2D thermal flow sensor with sub-mW power consumption , 2010 .

[75]  Sekwang Park,et al.  A circular-type thermal flow direction sensor free from temperature compensation , 2003 .

[76]  Ming Qin,et al.  Fabrication of a Micromachined Two-Dimensional Wind Sensor by Au–Au Wafer Bonding Technology , 2012, Journal of Microelectromechanical Systems.

[77]  Kofi A. A. Makinwa,et al.  Compensation of packaging asymmetry in a 2-D wind sensor , 2002, Proceedings of IEEE Sensors.

[78]  Saffa Riffat,et al.  Thermoelectrics: a review of present and potential applications , 2003 .

[79]  Louis Vessot King,et al.  On the Convection of Heat from Small Cylinders in a Stream of Fluid: Determination of the Convection Constants of Small Platinum Wires with Applications to Hot-Wire Anemometry , 1914 .

[80]  A. W. van Herwaarden,et al.  High-sensivity 2-D flow sensor with an etched thermal isolation structure , 1990 .

[81]  J. Romeral,et al.  A hot film anemometer for the Martian atmosphere , 2008 .