MINIMUM QUANTITY LUBRICATION (MQL) APPLICATIONS IN AUTOMOTIVE POWER-TRAIN MACHINING

ABSTRACT Minimum Quantity Lubrication (MQL) is a near-dry machining method that may be applied to reduce coolant usage in operations such as drilling, which cannot be performed completely dry. Although significant research has been reported on MQL, relatively little information on production applications and experience has appeared in the technical literature. The most common high-volume production application for MQL is cross and oil hole drilling on steel crankshafts. This paper reviews MQL test results for deep hole drilling of forged steel and cast nodular iron under conditions similar to crankshaft oil hole drilling. The results show that MQL can yield tool life equivalent to gun drills at higher penetration rates under these conditions. This result is consistent with production experience with steel crankshafts, and shows that MQL may also be useful for cross and oil hole drilling of cast crankshafts. Limited test and production data for MQL machining of aluminum prismatics is also described. Significant areas for future research and development, including chip management, air quality, capability and robustness, and cost are also discussed.

[1]  I. Inasaki,et al.  Tribological Characteristics and Cutting Performance of Lubricant Esters for Semi-dry Machining , 2003 .

[2]  John S. Agapiou,et al.  Metal Cutting Theory and Practice , 1996 .

[3]  J. Mccabe,et al.  Performance experience with near-dry machining of Aluminum© , 2001 .

[4]  Mahmudur Rahman,et al.  Experimental Evaluation on the Effect of Minimal Quantities of Lubricant in Milling , 2002 .

[5]  E. O. Bennett,et al.  Occupational airway diseases in the metalworking industry Part 1: Respiratory infections, pneumonia, chronic bronchitis and emphysema , 1985 .

[6]  E A Eisen,et al.  Acute pulmonary responses among automobile workers exposed to aerosols of machining fluids. , 1989, American journal of industrial medicine.

[7]  Anselmo Eduardo Diniz,et al.  Using a minimum quantity of lubricant (MQL) and a diamond coated tool in the drilling of aluminum–silicon alloys , 2002 .

[8]  C. Mackerer.  Health Effects of Oil Mists: A Brief Review 4 , 1989, Toxicology and industrial health.

[9]  L J Fine,et al.  Cancer risks among workers exposed to metalworking fluids: a systematic review. , 1998, American journal of industrial medicine.

[10]  Álisson Rocha Machado,et al.  The effect of extremely low lubricant volumes in machining , 1997 .

[11]  P. Burge,et al.  Occupational asthma due to an emulsified oil mist. , 1985, British journal of industrial medicine.

[12]  I. Inasaki,et al.  A Synthetic Ester as an Optimal Cutting Fluid for Minimal Quantity Lubrication Machining , 2002 .

[13]  Gerry Byrne,et al.  Environmentally Clean Machining Processes — A Strategic Approach , 1993 .

[14]  John W. Sutherland,et al.  Dry Machining and Minimum Quantity Lubrication , 2004 .

[15]  M. Cotterell,et al.  Minimal lubrication machining of aluminium alloys , 2002 .