Analysis and design of a 1.3-mW current-reuse RF front-end for the MICS band

This paper presents a wide-band low-power super-heterodyne RF front-end for the Medical Implant Communications Services (MICS) band. The front-end consists of a low-noise amplifier (LNA), a mixer, buffers, and passive baluns. The proposed circuits feature the techniques of current-reuse, MOSFET back-gate coupling, feedback, and current bleeding to achieve low power under acceptable noise figure (NF) levels for the MICS application. The RF front-end is implemented in 0.18um standard CMOS process with an area of 1.4mm×1.2mm at a supply voltage of 1.8V. Measurement results reveal the capability of a minimum sensitivity of -97dBm, maximum conversion gain of 30dB, and total noise figure (NF) of 11.6 and 13.2 dB while consuming 1.3mW and 2.9mW, respectively.

[1]  S Shashidharan,et al.  A CMOS Low-Power Transceiver With Reconfigurable Antenna Interface for Medical Implant Applications , 2011, IEEE Transactions on Microwave Theory and Techniques.

[2]  Anantha Chandrakasan,et al.  A 350μW CMOS MSK transmitter and 400μW OOK super-regenerative receiver for Medical Implant Communications , 2009, 2008 IEEE Symposium on VLSI Circuits.

[3]  Tsung-Hsien Lin,et al.  A 400-MHz super-regenerative receiver with digital calibration for capsule endoscope systems in 0.18-μm CMOS , 2008, 2008 IEEE International Symposium on VLSI Design, Automation and Test (VLSI-DAT).

[4]  Thomas H. Lee,et al.  The Design of CMOS Radio-Frequency Integrated Circuits: RF CIRCUITS THROUGH THE AGES , 2003 .

[5]  P.D. Bradley,et al.  An ultra low power, high performance Medical Implant Communication System (MICS) transceiver for implantable devices , 2006, 2006 IEEE Biomedical Circuits and Systems Conference.

[6]  M.P. Flynn,et al.  A Fully Integrated Auto-Calibrated SuperRegenerative Receiver , 2006, 2006 IEEE International Solid State Circuits Conference - Digest of Technical Papers.

[7]  M. Chanca,et al.  A multimode 0.3-200-kb/s transceiver for the 433/868/915-MHz bands in 0.25-/spl mu/m CMOS , 2004, IEEE Journal of Solid-State Circuits.

[8]  Yiannos Manoli,et al.  Design of Low-Power Direct-Conversion RF Front-End With a Double Balanced Current-Driven Subharmonic Mixer in 0.13 $\mu {\rm m}$ CMOS , 2013, IEEE Transactions on Circuits and Systems I: Regular Papers.

[9]  R.W. Brodersen,et al.  Design of a Sub-mW 960-MHz UWB CMOS LNA , 2006, IEEE Journal of Solid-State Circuits.

[10]  Hoi-Jun Yoo,et al.  A 10.8 mW Body Channel Communication/MICS Dual-Band Transceiver for a Unified Body Sensor Network Controller , 2009, IEEE Journal of Solid-State Circuits.

[11]  Hoi-Jun Yoo,et al.  A 10.8mW body-channel-communication/MICS dual-band transceiver for a unified body-sensor-network controller , 2009, 2009 IEEE International Solid-State Circuits Conference - Digest of Technical Papers.

[12]  Alyssa B. Apsel,et al.  A Crystal-Less Self-Synchronized Bit-Level Duty-Cycled IR-UWB Transceiver System , 2013, IEEE Transactions on Circuits and Systems I: Regular Papers.

[13]  M.P. Flynn,et al.  A Fully Integrated Auto-Calibrated Super-Regenerative Receiver in 0.13-$\mu{\hbox {m}}$ CMOS , 2007, IEEE Journal of Solid-State Circuits.

[14]  Miguel Chanca,et al.  A multimode 0.3-200-kb/s transceiver for the 433/868/915-MHz bands in 0.25-μm CMOS , 2004 .