Visualisation of water accumulation in the flow channels of PEMFC under various operating conditions

The accumulation of water in the cathode/anode serpentine flow channels of a transparent PEMFC has been investigated by direct visualisation where water droplets and slugs formed in these channels were quantified over a range of operating conditions. Four operating parameters concerning air stoichiometry, hydrogen stoichiometry, cell temperature, and electric load were examined to evaluate their effects on the formation and extraction of water from the flow channels. The results showed that hydrogen and air stoichiometry contribute almost equally to the water formation process in the cathode channels. However, their effects on the water extraction from the channels were quite different. Air stoichiometry proved capable of extracting all the water from the cathode channels, without causing membrane dehydration, contrary to hydrogen. Increasing the operating temperature of the cell was found to be very effective for the water extraction process; a temperature of 60 °C was sufficient to evaporate all the water in the channels as well as enhancing the fuel cell current. The electric load was strongly associated to the water formation in the channels but had no influence on water extraction. Finally, no water was present in the anode flow channels under all examined operating conditions.

[1]  D. Brüggemann,et al.  Simulation of the water and heat management in proton exchange membrane fuel cells , 2006 .

[2]  Xianguo Li,et al.  A flow channel design procedure for PEM fuel cells with effective water removal , 2007 .

[3]  Thomas A. Trabold,et al.  Effects of Flow Field and Diffusion Layer Properties on Water Accumulation in a PEM Fuel Cell , 2007 .

[4]  James Larminie,et al.  Fuel Cell Systems Explained , 2000 .

[5]  C. Arcoumanis,et al.  Visualisation of water droplets during the operation of PEM fuel cells , 2007 .

[6]  Zhigang Qi,et al.  Improvement of water management by a microporous sublayer for PEM fuel cells , 2002 .

[7]  J. Benziger,et al.  Nafion-layered sulfonated polysulfone fuel cell membranes , 2005 .

[8]  Trung Van Nguyen,et al.  Three-dimensional effects of liquid water flooding in the cathode of a PEM fuel cell , 2003 .

[9]  M. Sumita,et al.  Proton conduction in Nafion composite membranes filled with mesoporous silica , 2007 .

[10]  C. Gourdon,et al.  Detachment of a drop from an internal wall in a pulsed liquid-liquid column , 2000 .

[11]  Suresh G. Advani,et al.  Experimental investigation of liquid water formation and transport in a transparent single-serpentine PEM fuel cell , 2007 .

[12]  O. Barbera,et al.  Effect of operative conditions on a PEFC stack performance , 2008 .

[13]  Christopher Hebling,et al.  A PEM fuel cell for combined measurement of current and temperature distribution, and flow field flooding , 2004 .

[14]  G. G. Stokes.  "J." , 1890, The New Yale Book of Quotations.

[15]  Keith Promislow,et al.  The effects of water and microstructure on the performance of polymer electrolyte fuel cells , 2006 .

[16]  Suk Won Cha,et al.  Water management in proton exchange membrane fuel cells using integrated electroosmotic pumping , 2006 .

[17]  C. Hebling,et al.  Visualization of water buildup in the cathode of a transparent PEM fuel cell , 2003 .

[18]  Sirivatch Shimpalee,et al.  Predicting water and current distributions in a commercial-size PEMFC , 2004 .

[19]  城塚 正,et al.  Chemical Engineering Scienceについて , 1962 .

[20]  Biao Zhou,et al.  Liquid water transport in straight micro-parallel-channels with manifolds for PEM fuel cell cathode , 2006 .

[21]  Xianguo Li,et al.  Modelling of polymer electrolyte membrane fuel cells with variable degrees of water flooding , 2000 .

[22]  Biao Zhou,et al.  Innovative gas diffusion layers and their water removal characteristics in PEM fuel cell cathode , 2007 .

[23]  Biao Zhou,et al.  Water behavior in serpentine micro-channel for proton exchange membrane fuel cell cathode , 2005 .

[24]  K. Karan,et al.  Experimental investigation of the role of a microporous layer on the water transport and performance of a PEM fuel cell , 2007 .

[25]  W. Shepard,et al.  Removal of excess product water in a PEM fuel cell stack by vibrational and acoustical methods , 2006 .

[26]  Xianguo Li,et al.  An experimental and numerical investigation on the cross flow through gas diffusion layer in a PEM fuel cell with a serpentine flow channel , 2007 .

[27]  Yair Ein-Eli,et al.  PEM FC with improved water management , 2006 .

[28]  S. Litster,et al.  PEM fuel cell electrodes , 2004 .

[29]  Ay Su,et al.  Studies on flooding in PEM fuel cell cathode channels , 2006 .