Energy and seismic drawbacks of masonry: a unified retrofitting solution

[1]  A. Ekinci,et al.  The utilization of waste rubber tire powder to improve the mechanical properties of cement-clay composites , 2021 .

[2]  Fabio Longo,et al.  Axial Stress–Strain Model for FRCM Confinement of Masonry Columns , 2021 .

[3]  V. Singhal,et al.  Strengthening of Lime Mortar Masonry Wallettes Using Fiber-Reinforced Cementitious Matrix , 2020 .

[4]  S. Lenci,et al.  TRM reinforced tuff and fired clay brick masonry: Experimental and analytical investigation on their in-plane and out-of-plane behavior , 2020 .

[5]  A. Cascardi,et al.  Confinement of Masonry Columns with the FRCM-System: Theoretical and Experimental Investigation , 2020, Infrastructures.

[6]  F. Lebon,et al.  Multiscale Numerical Analysis of TRM-Reinforced Masonry under Diagonal Compression Tests , 2020, Buildings.

[7]  Paola Lassandro,et al.  Lightweight geopolymer-based mortars for the structural and energy retrofit of buildings , 2020 .

[8]  L. Gil,et al.  In-plane cyclic loading of masonry walls strengthened by vegetal-fabric-reinforced cementitious matrix (FRCM) composites , 2020 .

[9]  Min Ook Kim,et al.  Pullout Behavior of Recycled Waste Fishing Net Fibers Embedded in Cement Mortar , 2020, Materials.

[10]  A. Cascardi,et al.  A New Fabric Reinforced Geopolymer Mortar (FRGM) with Mechanical and Energy Benefits , 2020, Fibers.

[11]  E. Aydin,et al.  Carbon-Fiber Enriched Cement-Based Composites for Better Sustainability , 2020, Materials.

[12]  F. B. Varona,et al.  Study on Retrofitted Masonry Elements under Shear Using Digital Image Correlation , 2020, Sensors.

[13]  L. Ombres,et al.  Analysis of the Behavior of FRCM Confined Clay Brick Masonry Columns , 2020, Fibers.

[14]  L. Ombres,et al.  Numerical Modeling Approaches of FRCMs/SRG Confined Masonry Columns , 2019, Front. Built Environ..

[15]  C. Mazzotti,et al.  FRCM strengthening systems efficiency on the shear behavior of pre-damaged masonry panels: an experimental study , 2019, Journal of Building Pathology and Rehabilitation.

[16]  C. Mazzotti,et al.  In-Plane Shear Behavior of Stone Masonry Panels Strengthened through Grout Injection and Fiber Reinforced Cementitious Matrices , 2019, International Journal of Architectural Heritage.

[17]  A. Prota,et al.  Experimental In-Plane Shear Capacity of Clay Brick Masonry Panels Strengthened with FRCM and FRM Composites , 2019, Journal of Composites for Construction.

[18]  C. Lam,et al.  Comparison of different types of TRM composites for strengthening masonry panels , 2019, Construction and Building Materials.

[19]  A. Prota,et al.  Analysis of FRCM and CRM parameters for the in-plane shear strengthening of different URM types , 2019, Composites Part B: Engineering.

[20]  A. Prota,et al.  In-plane shear capacity of tuff masonry walls with traditional and innovative Composite Reinforced Mortars (CRM) , 2019, Construction and Building Materials.

[21]  Riadh Al-Mahaidi,et al.  A state-of-the-art review: Near-surface mounted FRP composites for reinforced concrete structures , 2019, Construction and Building Materials.

[22]  C. Gentilini,et al.  Shear strengthening of masonry wallettes resorting to structural repointing and FRCM composites , 2019, Construction and Building Materials.

[23]  Jiong Hu,et al.  Effect of slag, silica fume, and metakaolin on properties and performance of alkali-activated fly ash cured at ambient temperature , 2019, Construction and Building Materials.

[24]  C. Mazzotti,et al.  Influence of Masonry Texture on the Shear Strength of FRCM Reinforced Panels , 2019, RILEM Bookseries.

[25]  J. Ingham,et al.  In-Plane Strengthening of Clay Brick and Block Masonry Walls Using Textile-Reinforced Mortar , 2018, Journal of Composites for Construction.

[26]  D. Bournas.  Concurrent seismic and energy retrofitting of RC and masonry building envelopes using inorganic textile-based composites combined with insulation materials: A new concept , 2018, Composites Part B: Engineering.

[27]  C. Lam,et al.  Experimental investigation of in-plane shear behaviour of grey clay brick masonry panels strengthened with SRG , 2018 .

[28]  N. Ismail,et al.  In-Plane Shear Strength Improvement of Hollow Concrete Masonry Panels Using a Fabric-Reinforced Cementitious Matrix , 2018 .

[29]  M. Zargaran,et al.  Experimental diagonal tension (shear) test of Un-Reinforced Masonry (URM) walls strengthened with textile reinforced mortar (TRM) , 2018 .

[30]  E. Aydin.  Staple wire-reinforced high-volume fly-ash cement paste composites , 2017 .

[31]  D. Rai,et al.  Diagonal Shear and Out-of-Plane Flexural Strength of Fabric-Reinforced Cementitious Matrix–Strengthened Masonry Walletes , 2017 .

[32]  T. Triantafillou,et al.  An innovative structural and energy retrofitting system for URM walls using textile reinforced mortars combined with thermal insulation: Mechanical and fire behavior , 2017 .

[33]  F. Vestroni,et al.  Experimental investigation of tuff masonry panels reinforced with surface bonded basalt textile-reinforced mortar , 2017 .

[34]  F. Ceroni,et al.  Effectiveness of inorganic matrix–grid composites for strengthening masonry walls , 2016 .

[35]  Patrizia Aversa,et al.  Set-up of an experimental procedure for the measurement of thermal transmittances via infrared thermography on lab-made prototype walls , 2016 .

[36]  M. Corradi,et al.  Masonry wall panels retrofitted with thermal-insulating GFRP-reinforced jacketing , 2016 .

[37]  Yavuz Yardım,et al.  Shear strengthening of unreinforced masonry wall with different fiber reinforced mortar jacketing , 2016 .

[38]  Maria Rosa Valluzzi,et al.  Masonry repair & strengthening , 2016 .

[39]  Andrea Prota,et al.  Structural behaviour of masonry panels strengthened with an innovative hemp fibre composite grid , 2015 .

[40]  Thanasis Triantafillou,et al.  Analytical modeling of masonry-infilled RC frames retrofitted with textile-reinforced mortar , 2015 .

[41]  J. Barros,et al.  Assessment of overlay masonry strengthening system under in-plane monotonic and cyclic loading using the diagonal tensile test , 2015 .

[42]  Natalino Gattesco,et al.  Experimental and analytical study to evaluate the effectiveness of an in-plane reinforcement for masonry walls using GFRP meshes , 2015 .

[43]  Natalino Gattesco,et al.  Diagonal compression tests on masonry walls strengthened with a GFRP mesh reinforced mortar coating , 2015, Bulletin of Earthquake Engineering.

[44]  A. Licciulli,et al.  In-situ carbonation of alkali activated fly ash geopolymer , 2014 .

[45]  Antonio Borri,et al.  Shear strengthening of wall panels through jacketing with cement mortar reinforced by GFRP grids , 2014 .

[46]  A. Nanni,et al.  URM Walls Strengthened with Fabric-Reinforced Cementitious Matrix Composite Subjected to Diagonal Compression , 2014 .

[47]  J. Ingham,et al.  Polymer textiles as a retrofit material for masonry walls , 2014 .

[48]  Katerina Tsikaloudaki,et al.  The influence of concrete density and conductivity on walls’ thermal inertia parameters under a variety of masonry and insulation placements , 2013 .

[49]  Stefano Gialanella,et al.  Assessment of the thermal emissivity value of building materials using an infrared thermovision technique emissometer , 2013 .

[50]  A. Prota,et al.  In-plane behaviour of tuff masonry strengthened with inorganic matrix–grid composites , 2013 .

[51]  Viktor Mechtcherine,et al.  Durability of textile reinforced concrete made with AR glass fibre: effect of the matrix composition , 2010 .

[52]  Ciro Faella,et al.  Shear capacity of masonry walls externally strengthened by a cement-based composite material: An experimental campaign , 2010 .

[53]  Nathan Mendes,et al.  New external convective heat transfer coefficient correlations for isolated low-rise buildings , 2007 .

[54]  A. Prota,et al.  Experimental In-Plane Behavior of Tuff Masonry Strengthened with Cementitious Matrix–Grid Composites , 2006 .

[55]  Antonio Nanni,et al.  North American design guidelines for concrete reinforcement and strengthening using FRP: principles, applications and unresolved issues , 2003 .