Abstract We present an experimental approach to extract the dark saturation current density j0e-met at the emitter-metal interface of the front contact. For this purpose, 2×2 cm2 sized silicon solar cells have been realized featuring different metallization fractions FM. By simply applying the one-diode-model, the dark current density j01 is determined from the open circuit voltage Voc. From the slope of the j01 over FM plot, j0e-met is extracted. However, this is only valid if the dominant recombination mechanism at Voc features a diode character that is close to unity. Hence, the local ideality factor m is determined from the suns-Voc-curve indicating the required value close to one. Three main effects are observed. First, the metallization methods which are compared show different influences on j0e-met on the same emitter configuration. Second, an emitter drive-in due to an additional short thermal oxidation lowers j0e-met. Also, the field-effect passivation of the highly n-doped selective emitter decreases j0e-met effectively. By combining the field effect passivation with a short drive-in step the very low value of j0e-met = 549 fA/cm2 is reported.
[1]
R. Preu,et al.
20.1% Efficient Silicon Solar Cell With Aluminum Back Surface Field
,
2011,
IEEE Electron Device Letters.
[2]
Ronald A. Sinton,et al.
A quasi-steady-state open-circuit voltage method for solar cell characterization
,
2000
.
[3]
Stefan W. Glunz,et al.
Electrochemical methods to analyse the light-induced plating process
,
2010
.
[4]
A. Cuevas,et al.
Surface recombination velocity of highly doped n‐type silicon
,
1996
.
[5]
Richard M. Swanson,et al.
Studies of diffused phosphorus emitters: saturation current, surface recombination velocity, and quantum efficiency
,
1990
.