Modeling the Effects of Intake Flow Structures on Fuel/Air Mixing in a Direct-injected Spark-Ignition Engine

[1]  C. Rutland,et al.  Modeling the Effects of Intake Generated Turbulence and Resolved Flow Structures on Combustion in DI Diesel Engines , 1996 .

[2]  Philip Jones,et al.  Full Cycle Computational Fluid Dynamics Calculations in a Motored Four Valve Pent Roof Combustion Chamber and Comparison with Experiment , 1995 .

[3]  Bahram Khalighi,et al.  International Congress and Exposition Detroit, Michigan February 24-28, 1986Measured Steady Flow Velocity Distributions Around a Valve/Seat Annulus , 1986 .

[4]  Philippe Pinchon,et al.  Three Dimensional Modelling of Flow and Turbulence In a Four-valve Spark Ignition Engine - Comparison with LDV Measurements , 1989 .

[5]  Daniel C. Haworth,et al.  Multidimensional Port-and-Cylinder Flow Calculations for Two- and Four-Valve-Per-Cylinder Engines: Influence of Intake Configuration on Flow Structure , 1990 .

[6]  Rolf D. Reitz,et al.  A Study of Diesel Cold Starting using both Cycle Analysis and Multidimensional Calculations , 1991 .

[7]  N. B. Vargaftik.  Tables on the thermophysical properties of liquids and gases: In normal and dissociated states , 1975 .

[8]  Rolf D. Reitz,et al.  Modeling Engine Spray/Wall Impingement , 1988 .

[9]  M. C. Yuen,et al.  On Drag of Evaporating Liquid Droplets , 1976 .

[10]  Bahram Khalighi,et al.  Unsteady-flow velocity measurements around an intake valve of a reciprocating engine , 1987 .

[11]  Gerard M. Faeth,et al.  CURRENT STATUS OF DROPLET AND LIQUID COMBUSTION , 1977 .

[12]  A. F. Mills,et al.  Droplet evaporation: Effects of transients and variable properties☆ , 1975 .

[13]  R. Reitz,et al.  A temperature wall function formulation for variable-density turbulent flows with application to engine convective heat transfer modeling , 1997 .

[14]  J. A. Weston,et al.  Evaporation rates and drag resistance of burning drops , 1967 .

[15]  M. Renksizbulut,et al.  Numerical Study of Droplet Evaporation in a High-Temperature Stream , 1983 .

[16]  R. Reitz,et al.  Modeling the effects of drop drag and breakup on fuel sprays. Technical paper , 1993 .

[17]  W. Ranz.  Evaporation from drops : Part II , 1952 .

[18]  R. Reitz,et al.  Turbulence Modeling of Internal Combustion Engines Using RNG κ-ε Models , 1995 .

[19]  P. G. Hill,et al.  The effects of swirl and tumble on combustion in spark-ignition engines , 1994 .

[20]  L. Wachters,et al.  The heat transfer from a hot wall to impinging water drops in the spheroidal state , 1966 .

[21]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[22]  R. Reitz,et al.  MODELING HEAT TRANSFER TO IMPINGING FUEL SPRAYS IN DIRECT-INJECTION ENGINES , 1995 .

[23]  D. B. Spalding,et al.  The combustion of liquid fuels , 1953 .