Variable Angle Tow reinforcement design for locally reinforcing an open-hole composite plate

[1]  Zafer Gürdal,et al.  Design of variable stiffness panels for maximum strength using lamination parameters , 2011 .

[2]  Zafer Gürdal,et al.  Tailoring for strength of composite steered-fibre panels with cutouts , 2010 .

[3]  A. Crosky,et al.  Optimisation of fibre steering in composite laminates using a genetic algorithm , 2006 .

[4]  D. Kelly,et al.  Improving the Efficiency of Fiber Steered Composite Joints using Load Path Trajectories , 2006 .

[5]  Z. Gürdal,et al.  Design of variable stiffness composite panels for maximum fundamental frequency using lamination parameters , 2007 .

[6]  K. Gliesche,et al.  Application of the tailored fibre placement (TFP) process for a local reinforcement on an “open-hole” tension plate from carbon/epoxy laminates , 2003 .

[7]  A. Crosky,et al.  Strength improvement by fibre steering around a pin loaded hole , 2002 .

[8]  Don Kelly,et al.  On the design, manufacture and testing of trajectorial fibre steering for carbon fibre composite laminates☆ , 2000 .

[9]  K. Gliesche,et al.  3D reinforced stitched carbon/epoxy laminates made by tailored fibre placement , 2000 .

[10]  J. Loughlan,et al.  The influence of reinforcement ring width on the buckling response of carbon fibre composite panels with circular cut-outs , 1997 .

[11]  I. Herszberg,et al.  Tailored fibre placement to minimise stress concentrations , 1997 .

[12]  J. Loughlan,et al.  The buckling response of carbon fibre composite panels with reinforced cut-outs , 1995 .

[13]  P. Sullivan,et al.  Analysis of symmetric reinforcement of Quasi-Isotropic Graphite-Epoxy plates with a circular cutout under uniaxial tensile loading , 1983 .

[14]  G. O'Neill.  Asymmetric reinforcements of a quasi-isotropic graphite epoxy plate containing a circular hole. , 1982 .