Identification and maximum impact force modeling investigation for critical slugging in underwater compressed gas energy storage systems

[1]  A. Clarens,et al.  Compressed air energy storage capacity of offshore saline aquifers using isothermal cycling , 2022, Applied Energy.

[2]  D. Ting,et al.  Underwater Compressed Gas Energy Storage (UWCGES): Current Status, Challenges, and Future Perspectives , 2022, Applied Sciences.

[3]  D. Domiri Ganji,et al.  Experimental study of two-phase flow patterns through an inclined rectangular channel with horizontal and vertically upward directions , 2022, Alexandria Engineering Journal.

[4]  A. Haselbacher,et al.  Analytical modeling of advanced adiabatic compressed air energy storage: Literature review and new models , 2022, Renewable and Sustainable Energy Reviews.

[5]  E. Woschke,et al.  Internal two-phase flow induced vibrations: A review , 2022, Cogent Engineering.

[6]  N. Srinil,et al.  Influence of Internal Slug Flow on Vortex-Induced Vibration of Flexible Riser With Variable Curvature , 2022, Volume 7: CFD and FSI.

[7]  C. Kang,et al.  Role of compressed air energy storage in urban integrated energy systems with increasing wind penetration , 2022, Renewable and Sustainable Energy Reviews.

[8]  Yan Ma,et al.  A new theoretical model of local air-leakage seepage field for the compressed air energy storage lined cavern , 2022, Journal of Energy Storage.

[9]  D. Ting,et al.  Experimental and modeling investigation of critical slugging behavior in marine compressed gas energy storage systems , 2022, Journal of Energy Storage.

[10]  Mohammad Hossein Nabat,et al.  A comprehensive study and multi-criteria optimization of a novel sub-critical liquid air energy storage (SC-LAES) , 2022, Energy Conversion and Management.

[11]  M. Bucolo,et al.  Projection micro-stereolithography versus master–slave approach to manufacture a micro-optofluidic device for slug flow detection , 2022, The International Journal of Advanced Manufacturing Technology.

[12]  Changjun Li,et al.  Establishment and Solution of Four Variable Water Hammer Mathematical Model for Conveying Pipe , 2022, Energies.

[13]  Hongkun Li,et al.  Remaining Useful Life prediction of rolling bearings based on risk assessment and degradation state coefficient. , 2022, ISA transactions.

[14]  A. Rahbari,et al.  Hydrothermal performance of twisted elliptical tube equipped with twisted tape insert , 2022, International Journal of Thermal Sciences.

[15]  Stability analysis for compressed air energy storage cavern with initial excavation damage zone in an abandoned mining tunnel , 2022, Journal of Energy Storage.

[16]  Xuewen Cao,et al.  Effect of SDBS surfactant on gas–liquid flow pattern and pressure drop in upward-inclined pipelines , 2022 .

[17]  Li Wang,et al.  Liquid air energy storage , 2022, Storing Energy.

[18]  Xiaohu Yang,et al.  Assessment evaluation of a trigeneration system incorporated with an underwater compressed air energy storage , 2021 .

[19]  J. Legrand,et al.  A Discussion on the Relation Between the Intermittent Flow Sub-Regimes and the Frictional Pressure Drop , 2021, International Journal of Heat and Mass Transfer.

[20]  J. Whidborne,et al.  Slug Flow Control Using Topside Measurements: A Review , 2021, Chemical Engineering Journal Advances.

[21]  H. Teng,et al.  Near-field relaxation subsequent to the onset of oblique detonations with a two-step kinetic model , 2021, Physics of Fluids.

[22]  C. Nieto-Londoño,et al.  Numerical analysis of flow patterns maps in horizontal pipes with variation of inclination angles in a collector/evaporator of a DX-SAHP , 2021, Materials Today: Proceedings.

[23]  Xiaodong Sun,et al.  Investigation of air-water two-phase flow characteristics in a 25.4 mm diameter circular pipe , 2021, Progress in Nuclear Energy.

[24]  O. Matar,et al.  An experimental study of the thermohydraulic characteristics of flow boiling in horizontal pipes: Linking spatiotemporally resolved and integral measurements , 2021, Applied Thermal Engineering.

[25]  R. Weyer.  Assessment of Dynamic High Momentum Slug Loads on Piping Following STHE Tube Rupture , 2021, Volume 2: Computer Technology and Bolted Joints; Design and Analysis.

[26]  B. Ugwoke,et al.  Experimental investigation of the characteristics of the transition from spherical cap bubble to slug flow in a vertical pipe , 2021, Experimental Thermal and Fluid Science.

[27]  R. Gajbhiye,et al.  Effects of Density, Viscosity and Surface Tension on Flow Regimes and Pressure Drop of Two-Phase Flow in Horizontal Pipes , 2021 .

[28]  Pengbo Yin,et al.  Phase volume fraction measurement of slug flow with surfactant based on an image-quick closing valve method , 2021 .

[29]  T. Xue,et al.  Measurement of Three-Dimensional Characteristics of Slug Flow , 2021, IEEE Sensors Journal.

[30]  M. Shams,et al.  A novel numerical investigation of erosion wear over various 90-degree elbow duct sections , 2021 .

[31]  Somtochukwu Godfrey Nnabuife,et al.  Development of Gas-Liquid Slug Flow Measurement Using Continuous-Wave Doppler Ultrasound and Bandpass Power Spectral Density , 2021, ChemEngineering.

[32]  H. Tsubone,et al.  Measurement of Void Fraction Distribution with Small Wire Mesh Sensor in Water-Air Two-Phase Bubble and Slug Flows in Vertical Small Diameter Pipe , 2021, Multiphase Science and Technology.

[33]  Q. Bi,et al.  Experimental investigation on characteristic parameters of air–water slug flow in a vertical tube , 2021 .

[34]  Pengbo Yin,et al.  The effect of surfactants on the initiation and development of air–water slug flow in hilly terrain pipeline , 2020 .

[35]  Pengbo Yin,et al.  Investigation of slug flow characteristics in hilly terrain pipeline using ultrasonic Doppler method , 2020 .

[36]  G. Yeoh,et al.  Flow patterns and pressure gradient correlation for oil–water core–annular flow in horizontal pipes , 2019, Experimental and Computational Multiphase Flow.

[37]  Fei Xiao,et al.  Modelling and analysis of impact forces acting on elbow in gas–liquid slug flow , 2018, Asia-Pacific Journal of Chemical Engineering.

[38]  E. Pereyra,et al.  Onset of Liquid-Film Reversal in Upward-Inclined Pipes , 2018 .

[39]  Yujie Xu,et al.  A near-isothermal expander for isothermal compressed air energy storage system , 2018, Applied Energy.

[40]  J. Legrand,et al.  Influence of a sudden expansion on slug flow characteristics in a horizontal two-phase flow: a pressure drop fluctuations analysis , 2018, Meccanica.

[41]  Wei Cheng,et al.  A mathematical approach to submerged horizontal buoyant jet trajectory and a criterion for jet flow patterns , 2018 .

[42]  Evren Ozbayoglu,et al.  Pressure drop estimation in horizontal annuli for liquid–gas 2 phase flow: Comparison of mechanistic models and computational intelligence techniques , 2015 .

[43]  H. Shaban,et al.  Measurement of gas and liquid flow rates in two-phase pipe flows by the application of machine learning techniques to differential pressure signals , 2014 .

[44]  Rex B. Thorpe,et al.  Hydrodynamic forces acting on pipe bends in gas-liquid slug flow , 2014 .

[45]  Jing Ye,et al.  Multiphase flow pattern recognition in pipeline–riser system by statistical feature clustering of pressure fluctuations , 2013, Chemical Engineering Science.

[46]  M. Ishii,et al.  Experimental study of internal two-phase flow induced fluctuating force on a 90° elbow , 2012 .

[47]  Carl M. Larsen,et al.  On the Dynamic Response of Flexible Risers Caused by Internal Slug Flow , 2012 .

[48]  Biljana Djoric,et al.  Comparison of Commercial Multiphase Flow Simulators with Experimental and Field Databases , 2011 .

[49]  G. Aguilar,et al.  High-Speed Internal Nozzle Flow Visualization of Flashing Jets , 2009 .

[50]  Thomas J. Hanratty,et al.  Frequency and development of slugs in a horizontal pipe at large liquid flows , 2006 .

[51]  Hongjian Zhang,et al.  Flow Regime Identification of Gas-liquid Two-phase Flow Based on HHT , 2006 .

[52]  Hans J. Rath,et al.  Flow patterns in small diameter vertical non-circular channels , 2000 .

[53]  Thomas J. Hanratty,et al.  Influence of Froude number on physical processes determining frequency of slugging in horizontal gas–liquid flows , 1999 .

[54]  Minoo H. Patel,et al.  Internal flow-induced behaviour of flexible risers , 1989 .

[55]  K. Aziz,et al.  Gas-Liquid Flow In Upwards Inclined Pipe With Zero Net Liquid Production , 1981 .

[56]  Ovadia Shoham,et al.  Flow pattern transition for gas-liquid flow in horizontal and inclined pipes. Comparison of experimental data with theory , 1980 .

[57]  A. Dukler,et al.  Transient gas‐liquid flow in horizontal pipes: Modeling the flow pattern transitions , 1978 .

[58]  Khalid Aziz,et al.  Critical Evaluation of Friction Pressure-Drop Prediction Methods for Gas-Liquid Flow in Horizontal Pipes , 1977 .

[59]  Zhenhui Ma,et al.  Remaining useful life prediction of mechanical system based on performance evaluation and geometric fractional Lévy stable motion with adaptive nonlinear drift , 2022, Mechanical Systems and Signal Processing.