论文信息 - EXPERIMENTAL INVESTIGATIONS OF DRILLING ON CFRP COMPOSITES

EXPERIMENTAL INVESTIGATIONS OF DRILLING ON CFRP COMPOSITES

ABSTRACT The paper outlines the various problems associated with the drilling of CFRP composites. The technique of dimensional analysis is used to investigate the complex correlation between thrust force, cutting speed, feed, hole diameter, point geometry and material thickness during the drilling of holes in CFRP composites, A new non-dimensional number (t/D), thickness of layered composites to drill diameter, is found to influence the thrust force. Four drill point geometries specifically found effective in drilling of FRP were tried and among them the eight facet drill point geometry was found to give the best results.

[1] A. Koplev,et al. The Cutting Process, Chips and Cutting Forces in Machining CFRP , 1983 .

[2] W. E. Baker,et al. Similarity Methods in Engineering Dynamics: Theory and Practice of Scale Modeling , 1973 .

[3] R. A. Williams. A Study of the Drilling Process , 1974 .

[4] E. Armarego,et al. The Machining of Metals , 1969 .

[5] V. Tagliaferri,et al. Effect of drilling parameters on the finish and mechanical properties of GFRP composites , 1990 .

[6] W. König,et al. Machining of Fibre Reinforced Plastics , 1985 .

[7] H. Takeyama,et al. Machinability of Glassfiber Reinforced Plastics and Application of Ultrasonic Machining , 1988 .

[8] S. Wu,et al. On-Line Hole Quality Evaluation for Drilling Composite Material Using Dynamic Data , 1981 .

[9] Serope Kalpakjian,et al. Mechanical processing of materials , 1967 .

[10] P.L.B. Oxley. Introducing strain-rate dependent work material properties into the analysis of orthogonal cutting , 1963 .

[11] M. A. Townsend,et al. Torque and Thrust Parameters in Drilling Using Dimensional Analysis , 1980 .

[12] W. König,et al. Quality Definition and Assessment in Drilling of Fibre Reinforced Thermosets , 1989 .