Enhancing micro gas turbine performance in hot climates through inlet air cooling vapour compression technique

Microturbines (MGTs) are power generation devices showing very interesting performance in terms of low environmental impact, high-grade waste heat and very low maintenance cost. One of the main issues that affect the output of MGTs is their strong sensibility to inlet air temperature. Both in literature and in practical applications, several solutions have been applied to control the inlet air conditions and reduce the sensibility of this kind of machines to ambient conditions. One of the most interesting technology is the refrigerating vapour compression technique. This solution has already been used for medium/large GTs, but there are very limited inlet air cooling applications on MGTs and few experimental data are documented. This paper describes a test bench that has been designed to apply the direct vapour expansion technique to a 100kWe MGT and reports the power and efficiency augmentation of the machine when operating in hot summer days.

[1]  Teuku Meurah Indra Mahlia,et al.  Current utilization of microturbines as a part of a hybrid system in distributed generation technology , 2013 .

[2]  Anne Hampson,et al.  Catalog of CHP Technologies , 2015 .

[3]  B. Mohanty,et al.  Enhancing gas turbine performance by intake air cooling using an absorption chiller , 1995 .

[4]  Zeliang Yang,et al.  Analytical method for evaluation of gas turbine inlet air cooling in combined cycle power plant , 2009 .

[5]  Massimiliano Renzi,et al.  Application of artificial neural networks to micro gas turbines , 2011 .

[6]  Jerry A. Ebeling,et al.  Qualifying Combustion Turbines for Inlet Air Cooling Capacity Enhancement , 1995 .

[7]  Mohsen Kalantar,et al.  Dynamic behavior of a stand-alone hybrid power generation system of wind turbine, microturbine, solar array and battery storage , 2010 .

[8]  Yousef S.H. Najjar,et al.  Enhancement of performance of gas turbine engines by inlet air cooling and cogeneration system , 1996 .

[9]  Cyrus B. Meher-Homji,et al.  Inlet Fogging of Gas Turbine Engines: Climatic Analysis of Gas Turbine Evaporative Cooling Potential of International Locations , 2006 .

[10]  Firdaus Basrawi,et al.  Effect of ambient temperature on the performance of micro gas turbine with cogeneration system in cold region , 2011 .

[11]  Tong Seop Kim,et al.  The influence of water and steam injection on the performance of a recuperated cycle microturbine for combined heat and power application , 2010 .

[12]  A. Doukelis,et al.  Inlet Air Cooling Methods for Gas Turbine Based Power Plants , 2006 .

[13]  Takanobu Yamada,et al.  Applied Performance Research of a Cogeneration Arrangement with Proposed Efficiency Well-Balance Method , 2007 .

[14]  Judith Franco,et al.  Potential renewable energy resources of the Lerma Valley, Salta, Argentina for its strategic territorial planning , 2009 .

[15]  Abdulhadi Varnham,et al.  A review of inlet air-cooling technologies for enhancing the performance of combustion turbines in Saudi Arabia , 2010 .

[16]  Mohamed E. Ali,et al.  Impact of the use of a hybrid turbine inlet air cooling system in arid climates , 2013 .

[17]  K. Mathioudakis,et al.  Evaluation of water injection effect on compressor and engine performance and operability , 2010 .

[18]  Horacio Perez-Blanco,et al.  Potential of regenerative gas-turbine systems with high fogging compression , 2007 .

[19]  Massimiliano Renzi,et al.  Microturbogas cogeneration systems for distributed generation: Effects of ambient temperature on global performance and components’ behavior , 2014 .

[20]  Wickwire Susan,et al.  Biomass Combined Heat and Power Catalog of Technologies. 7. Representative biomass CHP System Cost and Performance Profiles , 2007 .

[21]  Mojtaba Tahani,et al.  Analysis of gas turbine operating parameters with inlet fogging and wet compression processes , 2010 .

[22]  Ibrahim Dincer,et al.  Energetic and exergetic performance analyses of a combined heat and power plant with absorption inlet cooling and evaporative aftercooling , 2011 .

[23]  Massimiliano Renzi,et al.  Enhancing micro gas turbine performance through fogging technique: Experimental analysis , 2014 .

[24]  Na Zhang,et al.  General characteristics of single shaft microturbine set at variable speed operation and its optimization , 2004 .

[25]  Ronnie Belmans,et al.  Distributed generation: definition, benefits and issues , 2005 .

[26]  A. A. El Hadik,et al.  The Impact of Atmospheric Conditions on Gas Turbine Performance , 1990 .

[27]  S. M. Mousavi,et al.  An autonomous hybrid energy system of wind/tidal/microturbine/battery storage , 2012 .

[28]  A. Giourof Gas-turbine inlet-air cooling: you can almost pick your payback , 1995 .

[29]  Andrés Amell,et al.  Influence of the relative humidity on the air cooling thermal load in gas turbine power plant , 2002 .

[30]  Ricardo Chacartegui,et al.  Analysis of combustion turbine inlet air cooling systems applied to an operating cogeneration power plant , 2008 .

[31]  Yunho Hwang,et al.  Potential energy benefits of integrated refrigeration system with microturbine and absorption chiller , 2004 .

[32]  Sanjay,et al.  Thermodynamic assessment of impact of inlet air cooling techniques on gas turbine and combined cycle performance , 2014 .

[33]  Massimiliano Renzi,et al.  Use of a test-bed to study the performance of micro gas turbines for cogeneration applications , 2011 .

[34]  Peter Rodgers,et al.  Gas turbine efficiency enhancement using waste heat powered absorption chillers in the oil and gas industry , 2013 .

[35]  C. Lanfranchi,et al.  Benefits of Compressor Inlet Air Cooling for Gas Turbine Cogeneration Plants , 1996 .