Thermal modeling of high performance packages in portable computers

A numerical study was conducted to determine the thermal performance of the Pentium Processor in a Tape Carrier Package (TCP) operating inside a typical portable computer. The objective of this study is to develop a validated system level model of the portable environment and demonstrate that equipment designers can carry out design iterations of possible heat transfer configurations to analyze cost, performance and manufacturability tradeoffs. A detailed 3D numerical model of the package was constructed using a computational fluid dynamic software. In the interest of keeping the computational model tractable, some simplifying assumptions were employed to obtain equivalent compact models of the various components in the computer. The fluid motion is essentially a buoyancy driven convection inside an enclosure with multiple discrete heat sources. The results obtained indicate that the model is in good agreement with the experimental data, both qualitatively and quantitatively. Thermal performance limits were established for various package families. The validated model was used to investigate the improvement in thermal performance due to increased PCB thermal conductivity and the inclusion of heat spreaders, heat pipes and vents.

[1]  Hong Xie,et al.  The use of heat pipes in the cooling of portables with high power packages-A case study with the Pentium processor-based notebooks and sub-notebooks , 1995, 1995 Proceedings. 45th Electronic Components and Technology Conference.

[2]  Hong Xie,et al.  Thermal solutions to Pentium processors in TCP in notebooks and sub-notebooks , 1995 .

[3]  Alfonso Ortega,et al.  Heat transfer in a low aspect ratio horizontal enclosure for laptop computer application , 1993, [1993 Proceedings] Ninth Annual IEEE Semiconductor Thermal Measurement and Management Symposium.

[4]  Bahgat Sammakia,et al.  Buoyancy-Induced Flows and Transport , 1988 .

[5]  J. E. Hart,et al.  Stability of Thin Non-Rotating Hadley Circulations , 1972 .

[6]  R. J. Krane,et al.  Natural Convection Cooling of a Horizontally Oriented Component Board Mounted in a Low-Aspect-Ratio Enclosure , 1991 .

[7]  H. I. Rosten,et al.  Thermal modelling of the Pentium processor package , 1994, 1994 Proceedings. 44th Electronic Components and Technology Conference.

[8]  E. Papanicolaou,et al.  Natural Convection in Shallow, Horizontal Air Layers Encountered in Electronic Cooling , 1995 .

[9]  Christoph Beckermann,et al.  Combined Conduction, Natural Convection, and Radiation Heat Transfer in an Electronic Chassis , 1991 .

[10]  Ephraim M Sparrow,et al.  Patterns of free convection flow adjacent to horizontal heated surfaces , 1968 .

[11]  B. Gebhart,et al.  Instability, Transition, and Turbulence in Buoyancy-Induced Flows , 1973 .

[12]  B. Chambers,et al.  Application of CFD Technology to electronic thermal management , 1994 .

[13]  I. Catton,et al.  NATURAL CONVECTION IN ENCLOSURES , 1978 .

[14]  H. I. Rosten,et al.  Development, validation and application of a thermal model of a plastic quad flat pack , 1995, 1995 Proceedings. 45th Electronic Components and Technology Conference.