Effects of upstream two-dimensional hills on design wind loads: a computational approach

The paper describes a study about effects of upstream hills on design wind loads using two mathematical approaches: Computational Fluid Dynamics (CFD) and Artificial Neural Network (NN for short). For this purpose CFD and NN tools have been developed using an object-oriented approach and C++ programming language. The CFD tool consists of solving the Reynolds time-averaged Navier-Stokes equations and turbulence model using body-fitted nearly-orthogonal coordinate system. Subsequently, design wind load parameters such as speed-up ratio values have been generated for a wide spectrum of two-dimensional hill geometries that includes isolated and multiple steep and shallow hills. Ground roughness effect has also been considered. Such CFD solutions, however, normally require among other things ample computational time, background knowledge and high-capacity hardware. To assist the enduser, an easier, faster and more inexpensive NN model trained with the CFD-generated data is proposed in this paper. Prior to using the CFD data for training purposes, extensive validation work has been carried out by comparing with boundary layer wind tunnel (BLWT) data. The CFD trained NN (CFD-NN) has produced speed-up ratio values for cases such as multiple hills that are not covered by wind design standards such as the Commentaries of the National Building Code of Canada (1995). The CFD-NN results compare well with BLWT data available in literature and the proposed approach requires fewer resources compared to running BLWT experiments.

[1]  Theodore Stathopoulos,et al.  Modelling wind-induced interference effects using backpropagation neural networks , 1997 .

[2]  Alberto Maurizi.  Numerical simulation of turbulent flows over 2-D valleys using three versions of the k–ε closure model , 2000 .

[3]  J. D. Holmes,et al.  Computation of wind flow over topography , 1993 .

[4]  A. Davenport,et al.  SIMPLE APPROXIMATIONS FOR WIND SPEED-UP OVER HILLS , 1988 .

[5]  Jaeyong Chung,et al.  Numerical simulation of flow past 2D hill and valley , 2004 .

[6]  Peter A. Taylor,et al.  Guidelines for airflow over complex terrain: model developments , 2000 .

[7]  Luís Eça.  2D Orthogonal Grid Generation with Boundary Point Distribution Control , 1996 .

[8]  Theodore Stathopoulos,et al.  Numerical evaluation of wind flow over complex terrain : review , 2004 .

[9]  Peter A. Taylor,et al.  Development of a non-linear mixed spectral finite difference model for turbulent boundary-layer flow over topography , 1994 .

[10]  David Surry,et al.  Prediction of pressure coefficients on roofs of low buildings using artificial neural networks , 2003 .

[11]  J. P. V. Doormaal,et al.  ENHANCEMENTS OF THE SIMPLE METHOD FOR PREDICTING INCOMPRESSIBLE FLUID FLOWS , 1984 .

[12]  Paul Carpenter,et al.  Investigation of wind speeds over multiple two-dimensional hills , 1999 .

[13]  B. Launder,et al.  The numerical computation of turbulent flows , 1990 .

[14]  James R. Salmon,et al.  A simple model of neutrally stratified boundary-layer flow over real terrain incorporating wavenumber-dependent scaling , 1983 .

[15]  George Bergeles.  Numerical calculation of turbulent flow around two-dimensional hills , 1985 .

[16]  Peter A. Taylor,et al.  A mixed spectral finite-difference model for neutrally stratified boundary-layer flow over roughness changes and topography , 1987 .

[17]  C. Rhie,et al.  Numerical Study of the Turbulent Flow Past an Airfoil with Trailing Edge Separation , 1983 .

[18]  Fergus R. Fricke,et al.  The interference index and its prediction using a neural network analysis of wind-tunnel data , 1999 .

[19]  D. Spalding.  A novel finite difference formulation for differential expressions involving both first and second derivatives , 1972 .

[20]  Branislav Jaramaz,et al.  Nearly orthogonal two-dimensional grid generation with aspect ratio control , 2001 .