FEM prediction of buckling distortion induced by welding in thin plate panel structures

Welding distortion generated during assembly process has a strongly nonlinear feature, which includes material nonlinearity, geometric nonlinearity, and contact nonlinearity. In order to obtain a precise prediction of welding distortion, these nonlinear phenomena should be carefully considered. In this study, firstly, a prediction method of welding distortion, which combines thermo-elastic-plastic finite element method (FEM) and large deformation elastic FEM based on inherent strain theory and interface element method, was developed. Secondly, the inherent deformations of two typical weld joints involved in a large thin plate panel structure were calculated using the thermo-elastic-plastic FEM and their characteristics were also examined. Thirdly, using the developed elastic FEM and the inherent deformations, the usefulness of the proposed elastic FEM was demonstrated through the prediction of welding distortion in the large thin plate panel structures. Finally, the influences of heat input, welding procedure, welding sequence, thickness of plate, and spacing between the stiffeners on buckling propensity were investigated. The numerical simulation method developed in this study not only can be used to predict welding distortion in manufacturing stage but also can be employed in design or planning stage.

[1]  K. Satoh,et al.  Fundamental Study on Buckling of Thin Steel Plate due to Bead-Welding , 1958 .

[2]  T. Nomoto,et al.  Critical Conditions of Plate Buckling Generated by Welding. , 1998 .

[3]  T. Nomoto,et al.  Study of Parameters Controlling Weld Buckling. , 1997 .

[4]  Dean Deng.  Theoretical Prediction and Control of Welding Distortion in Large Structures Considering Positioning and the Gap between Parts(Mechanics, Strength & Structure Design, INTERNATIONAL SYMPOSIUM OF JWRI 30TH ANNIVERSARY) , 2003 .

[5]  S. Sone,et al.  Prediction of Welding Distortion by Elastic Finite Element Analysis using Inherent Deformation Estimated Through Inverse Analysis , 2005 .

[6]  Shoji Takechi,et al.  Basic Studies on Accuracy Management System Based on Estimating of Weld Deformations , 1997 .

[7]  Hidekazu Murakawa,et al.  Numerical simulation of temperature field and residual stress in multi-pass welds in stainless steel pipe and comparison with experimental measurements , 2006 .

[8]  Yukio Ueda,et al.  Prediction of Welding Deformation and Residual Stress by Elastic FEM Based on Inherent Strain , 1996 .

[9]  Pingsha Dong,et al.  Fabrication and Engineering Technology for Lightweight Ship Structures, Part 1: Distortions and Residual Stresses in Panel Fabrication , 2004 .

[10]  K. Masubuchi.  Analysis of Welded Structures , 1980 .

[11]  Bob Sommer.  Construction begins at the world trade center site , 2004 .

[12]  Wei Liang,et al.  Numerical simulation of welding distortion in large structures , 2007 .

[13]  Yukio Ueda,et al.  Prediction of Residual Stresses in Butt Welded Plates Using Inherent Strains , 1993 .

[14]  Joining,et al.  Transactions of JWRI , 1972 .

[15]  Shoji Takechi,et al.  Studies on the block positioning metrics system for the hull erection stage , 2002 .

[16]  Hidekazu Murakawa,et al.  Determination of welding deformation in fillet-welded joint by means of numerical simulation and comparison with experimental measurements , 2007 .

[17]  F. Vollertsen.  Developments and Trends in Laser Welding of Sheet Metal , 2005 .