Heat and mass transfer model to predict the operational performance of a steam sterilisation autoclave including products

Abstract Steam sterilisation using autoclaves or retorts is a widely used thermal process in the food processing and pharmaceutical industries. Unfortunately, sterilisation, using steam, consumes a significant amount of energy and is known to cause unwanted peak energy demand when a number of autoclaves operate in parallel. The objective of this paper is to extend the previously published numerical methodology developed to simulate in detail the thermal energy consumption of an industrial sized empty autoclave used for steam sterilisation, to include products, in this case, intravenous solution packed in plastic pouches and a steam flow controller. The external parameters supplied to the numerically modelled controller are the maximum steam flow rate and the autoclave temperature as a function of time which it needs to maintain. The numerical model is then used to predict the actual transient temperature and pressure profiles and the details of the mass transfers in the autoclave during a sterilisation cycle, the transient temperature distribution within the products as well as details of the transient thermal energy consumption. The results from numerical modelling were validated with measurements obtained under actual operating conditions. The simulated total steam consumption was within 3% of the measured data. A reduction of 8% in steam consumption was obtained due to insulation on the outer walls.

[1]  Perry Sadorsky,et al.  Energy consumption, output and trade in South America , 2012 .

[2]  Sami Kara,et al.  Numerical modelling of an industrial steam–air sterilisation process with experimental validation , 2015 .

[3]  J. Grochowicz,et al.  Energy efficiency of a confectionery plant – Case study , 2015 .

[4]  Kostadin Fikiin,et al.  Numerical simulation of unsteady heat conduction in arbitrary shaped canned foods during sterilization processes , 1994 .

[5]  S. Holdsworth Thermal processing of packaged foods , 1997 .

[6]  Y. Çengel Heat and Mass Transfer: A Practical Approach , 2006 .

[7]  Patrick Glouannec,et al.  Numerical and experimental characterization of a batch bread baking oven , 2012 .

[8]  Jorge C. Oliveira,et al.  Determination of the heat transfer coefficient between bulk medium and packed containers in a batch retort , 2000 .

[9]  Savvas A. Tassou,et al.  Analysis and simulation of continuous food frying processes , 2013 .

[10]  Carlos J. Renedo,et al.  A review: Energy recovery in batch processes , 2012 .

[11]  Ricardo Simpson,et al.  Optimal scheduling of canned food plants including simultaneous sterilization , 2009 .

[12]  J. A. Barreiro,et al.  Optimization of energy consumption during the heat processing of canned foods , 1984 .

[13]  Michele Nehemy Berteli,et al.  The analysis of an alternative approach to the venting process in retorts operating under steam pressure , 2012 .

[14]  Richard Rocca-Poliméni,et al.  A model of heat and mass transfer inside a pressure cooker , 2011 .

[15]  Ricardo Simpson,et al.  Energy consumption in batch thermal processing: Model development and validation , 2006 .

[16]  Vassili Toropov,et al.  Thermal energy management in the bread baking industry using a system modelling approach , 2013 .

[17]  Ernst Worrell,et al.  Energy efficiency opportunities in the U.S. commercial baking industry , 2014 .

[18]  Siaw Kiang Chou,et al.  Energy analysis applied to food processing , 1986 .

[19]  Ephraim M Sparrow,et al.  Condensation heat transfer in the presence of noncondensables, interfacial resistance, superheating, variable properties, and diffusion , 1966 .

[20]  Geoffrey P. Hammond,et al.  Industrial energy analysis, thermodynamics and sustainability , 2007 .