A user-friendly fuzzy-based system for the selection of electro discharge machining process parameters

Abstract This paper introduces a user-friendly intelligent system for the selection of electro discharge machining (EDM) parameters. In this system, a compact selection method based on expert rules, which were obtained from experimental results and extracted from the knowledge of skilled operators, is presented. Expert rules are evaluated by the fuzzy set theory. The developed fuzzy model uses fuzzy-expert rules, triangular membership functions for fuzzification and centroid area method for defuzzification processes. The system was developed on a PC using MATLAB Fuzzy Logic Toolbox. Inevitably, there are many machining parameters (discharge current, pulse duration, pulse interval, gap control, flushing rate, etc.) that should be considered in EDM processes. Selection of these parameters is still an ill-defined problem and generally relies on heuristics, which are not easy to model, and based on the experiences of specialists. In this system, discharge current, pulse duration and pulse interval are the inputs while the outputs are electrode wear, surface roughness and erosion rate. The remaining parameters are considered at constant rate during machining. The system is a compact and homemade tool that can be easily used by an average operator and provides the EDM parameters which lead to less electrode wear, better surface quality and more erosion rate according to the selected operation (finishing, roughing, etc.).

[1]  C. Cogun,et al.  AN INVESTIGATION ON TOOL WEAR IN ELECTRIC DISCHARGE MACHINING (EDM) , 2001 .

[2]  Pei-Jen Wang,et al.  Comparisons of neural network models on material removal rate in electrical discharge machining , 2001 .

[3]  Y. S. Tarng,et al.  Optimization of the electrical discharge machining process based on the Taguchi method with fuzzy logics , 2000 .

[4]  Che Hassan Che Haron,et al.  Investigation on the influence of machining parameters when machining tool steel using EDM , 2001 .

[5]  J. Y Kao,et al.  A neutral-network approach for the on-line monitoring of the electrical discharge machining process , 1997 .

[6]  Ebrahim H. Mamdani,et al.  An Experiment in Linguistic Synthesis with a Fuzzy Logic Controller , 1999, Int. J. Hum. Comput. Stud..

[7]  Fritz Klocke,et al.  Neuro-fuzzy Approach for Electro-discharge Sinking Process Control , 1997, Fuzzy Days.

[8]  S. H. Lee,et al.  Study of the effect of machining parameters on the machining characteristics in electrical discharge machining of tungsten carbide , 2001 .

[9]  Y Chen,et al.  Analysis of electro-discharge machining process and its comparison with experiments , 2000 .

[10]  K Hashmi,et al.  Data selection for turning carbon steel using a fuzzy logic approach , 2003 .

[11]  Michel Derenne,et al.  Fuzzy Logic Application in Gasket Selection and Sealing Performance , 2001 .

[12]  Michio Sugeno,et al.  An introductory survey of fuzzy control , 1985, Inf. Sci..

[13]  Lotfi A. Zadeh,et al.  Outline of a New Approach to the Analysis of Complex Systems and Decision Processes , 1973, IEEE Trans. Syst. Man Cybern..

[14]  T. Ross.  Fuzzy Logic with Engineering Applications , 1994 .

[15]  Pei-Jen Wang,et al.  Semi-empirical Model on Work Removal and Tool Wear in Electrical Discharge Machining , 2001 .

[16]  Can çogun,et al.  The effect of machining parameters on tool electrode edge wear and machining performance in Electric Discharge Machining (EDM) , 2002 .

[17]  Pei-Jen Wang,et al.  Predictions on surface finish in electrical discharge machining based upon neural network models , 2001 .